Dellメーカー1150の使用説明書/サービス説明書
ページ先へ移動 of 38
Dell™Inspiron™1150ServiceManual Before You Begin System Components Memory, CD or DVD Drive, Modem, and Mini PCI Card Hard Drive Keyboard EMI Shield Display Palm Rest Microprocessor The.
Back to Contents Page Base Plastics Dell™Inspiron™1150ServiceManual 1. Follow the instructions in " Before Working Inside Your Computer ." 2. Remove the hard drive . 3. Remove the CD or DVD drive . 4. Remove the memory module(s) .
Back to Contents Page Before You Begin Dell™Inspiron™1150ServiceManual Computer Orientation Screw Identification This chapter provides procedures for removing and installing the components in your computer.
1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched. 2. Turn off your computer . 3. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
Screw Identification When you are removing and replacing components, photocopy " Screw Identification " as a tool to lay out and keep track of the screws.
Back to Contents Page Hinge Bracket to Computer Base: (4 each) Display Bezel: (5 each) Screw Covers (2 each) Display Bumpers (3 each) Display Panel:.
Back to Contents Page Flashing the BIOS Dell™Inspiron™1150ServiceManual Flashing the BIOS From a Floppy Disk or a CD Flashing the BIOS From the Hard Drive If a BIOS update program floppy disk or CD is provided with the new system board, see "Flashing the BIOS From a Floppy Disk or a CD.
Back to Contents Page .
Back to Contents Page Microprocessor Module Dell™Inspiron™1150ServiceManual Removing the Microprocessor Module 1. Follow the instructions in " Before Working Inside Your Computer ." 2. Remove the keyboard .
1. Align the pin - 1 corner of the microprocessor module so that it points to the triangle on the system board, and insert the microprocessor module into the ZIF socket. When the microprocessor module is correctly seated, all four corners are aligned at the same height.
Back to Contents Page Display Dell™Inspiron™1150ServiceManual Display Assembly Display Bezel Display Panel Display Latch Assembly Display Assembly 1. Follow the instructions in " Before Working Inside Your Computer .
11. Lift the display assembly up and out of the computer base. Display Display Bezel 1. Follow the instructions in " Before Working Inside Your Computer ." 2. Remove the keyboard . 3. Remove the display assembly .
6. Starting at the bottom of the display panel, use your fingers to separate the bezel from the top cover and lift the inside edge of the bezel away from the top cover. Display Panel Removing the Display Panel 1. Follow the instructions in " Before Working Inside Your Computer .
1. Connect the top flex - cable connector to the display panel connector. 2. Connect the bottom flex - cable connector to the inverter connector. 3. Lay the display panel in the top cover. 4. Route the display - feed flex cable so that it rests in the notch located in the bottom edge of the top cover.
Back to Contents Page .
Back to Contents Page EMI Shield Dell™Inspiron™1150ServiceManual EMI Shield EMI Shield 1. Follow the instructions in " Before Working Inside Your Computer ." 2. Remove the keyboard . 3. Remove the one M2.
Back to Contents Page Hard Drive Dell™Inspiron™1150ServiceManual Removing the Hard Drive 1. Follow the instructions in " Before Working Inside Your Computer ." 2. Turn the computer over, and remove the two M2.
2. Insert the drive into the bay, and push the hard drive until it is fully seated in the bay. 3. Replace and tighten the two M2.5 x 5 - mm screws. 4. Use the Operating System CD to install the operating system for your computer. 5. Use the Drivers and Utilities CD to install the drivers and utilities for your computer.
Back to Contents Page Keyboard Dell™Inspiron™1150ServiceManual Removing the Keyboard 1. Follow the instructions in " Before Working Inside Your Computer .
5. Lift the top of the keyboard out of the computer base, and pull the keyboard out at an angle (towards the display). 6. Grasp the keyboard flex cable near the connector, and pull up on the flex cable to disconnect it from the interface connector on the system board.
Back to Contents Page Palm Rest Dell™Inspiron™1150ServiceManual Palm Rest Palm Rest 1. Follow the instructions in " Before Working Inside Your Computer ." 2. Remove the hard drive . 3. Remove the CD or DVD drive .
10. Disconnect the touch pad connector from the system board. 11. Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base plastics by lifting the inside edge of the palm rest.
Back to Contents Page Pinout Assignments for I/O Connectors Dell™Inspiron™1150ServiceManual USB Connector Video Connector USB Connector Video Connecto.
Back to Contents Page Speakers Dell™Inspiron™1150ServiceManual Removing the Speakers The speakers are located on the left and right corners of the front of the base plastics. Take note of the speaker cable routing so that you can replace the cables properly under or between their routing clips.
Installing the Speakers 1. Slide the speakers down into the base plastics. 2. Route the speaker cables under or between their routing clips. 3. Connect the speaker connector to the system board. Back to Contents Page NOTICE: Ensure that the speaker cables are under or between their routing clips.
Back to Contents Page System Board Dell™Inspiron™1150ServiceManual Removing the System Board The system board's BIOS chip contains the Service Tag sequence, which is also visible on a barcode label on the bottom of the computer.
16. Remove the two M2.5 x 5 - mm system board screws from the optical drive cage. 17. Remove the two M2.5 x 5 - mm system board screws from the chipset heat sink. 18. Remove the two M2.5 x 6 - mm screws that secure the left antenna to the hard drive and optical drive cages.
20. Lift the front of the system board out and away from the base plastics. Installing the System Board 1. Insert the video connector on the replacement system board through the back of the base plastics. 2. Replace the two hex nuts that secure the video connector to the base plastics.
Back to Contents Page System Components Dell™Inspiron™1150ServiceManual Back to Contents Page CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.
Back to Contents Page Microprocessor Thermal - Cooling Assembly Dell™Inspiron™1150ServiceManual Removing the Microprocessor Thermal - Cooling Assembly 1. Follow the instructions in " Before Working Inside Your Computer .
3. Connect the fan power cable to the system board. 4. Tighten the four captive screws, labeled "1" through "4," in consecutive order.
Back to Contents Page Dell™Inspiron™1150ServiceManual For a complete list of abbreviations and acronyms, see the Tell Me How help file. IfyoupurchasedaDell™nSeriescomputer,anyreferencesinthisdocumenttoMicrosoft ® Windows ® operating systems are not applicable.
Back to Contents Page Memory, CD or DVD Drive, Modem, and Mini PCI Card Dell™Inspiron™1150ServiceManual Memory CD or DVD Drive Modem Mini PCI Card Memory Removing the Memory Modules 1.
Installing the Memory Modules 1. Align the notch in the module edge connector with the tab in the connector slot. 2. Slide the module firmly into the slot at a 45 - degree angle, and rotate the module down until it clicks into place.
4. Press the lever next to the memory module connectors in the direction of the arrow on the lever (towards the drive) to release the drive. 5. Pull the drive out of the bay. Installing the CD or DVD Drive 1. Slide the new drive into the bay until the drive is fully seated.
1. Follow the instructions in " Before Working Inside Your Computer ." 2. Turn the computer over, loosen the captive screw (labeled "C") in the modem/Mini PCI card cover, and lift the cover away from the computer. 3.
4. Replace the cover and tighten the captive screw. Mini PCI Card Removing the Mini PCI Card 1. Follow the instructions in " Before Working Inside Your Computer .
4. UseyourfingertipstocarefullyspreadapartthesecuringtapsoneachendoftheMiniPCIcardconnectoruntilthecardpopsup. 5. Lift the Mini PCI card out of its connector. Installing the Mini PCI Card 1.
デバイスDell 1150の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Dell 1150をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDell 1150の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Dell 1150の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Dell 1150で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Dell 1150を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDell 1150の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Dell 1150に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDell 1150デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。