DesaメーカーVm42ePの使用説明書/サービス説明書
ページ先へ移動 of 32
For more information, visit www .desatech.com MODELS M36E(B,H), M42E(B ,H), VM36E(B,H) AND VM42E(B ,H) NA TURAL GAS MODELS M36EP(B,H), M42EP(B ,H), VM36EP(B,H) AND VM42EP(B,H) PROP ANE/LP GAS B-V ENT .
www .desatech.com 108796-01L 2 W ARNING: Improper installation, adjustment, altera - tion,service ormaintenancecan causeinjuryor prop - erty damage. Refer to this manual for correct installation and operational procedures.
www .desatech.com 108796-01L 3 SAFETY INFORMA TION W ARNING: This product c o n t a i n s a n d / o r g e n e r a t e s chemicals known to the State of California to cause cancer or birth defects or other reproduc - tiveharm.
www .desatech.com 108796-01L 4 11. Keep the area around your replace clear of combustible materials, gasoline and other ammable vapor and liquids. Do not run re- place where these are used or stored. Do not place items such as clothing or decorations on or around replace.
www .desatech.com 108796-01L 5 W ARNING: Installation of this appliance should be done by a qualied service person well trained in the installation of such appliances.
www .desatech.com 108796-01L 6 Model 36 Model 42 Mo del 3 6 Mo d el 42 Mo del 3 6 Model 42 A 29" 36" I 40 1 / 4 " 44 1 / 4 " Q 13 7 / 8 " 14" B 5/8" 5/8" J 21&q.
www .desatech.com 108796-01L 7 PRE-INST ALLA TION PREP ARA TION CLEARANCES Minimum clearances to combustibles are: • Back and Sides of Outer Surround . . . 0" min. • Drywall to Sides of Front Face (Nailing Flanges) . . . . . . . . . . . . . .
www .desatech.com 108796-01L 8 PRE-INST ALLA TION PREP ARA TION Continued FRAMING 1. Frame appliance enclosure as illustrated in Figures 7 and 8. Note: If a wall covering is used to line the enclosure, then all measurements must be from the surface of the covering.
www .desatech.com 108796-01L 9 INST ALLING TRANSITION PIPE AND ST ARTER COLLAR The transition pipe and starter collar shown in Figu re 9 are suppl ied with the repla ce, unat tach ed and rea dy for insta lla tio n. Remo ve the start er coll ar and set aside.
www .desatech.com 108796-01L 10 Maintain Listed Clearance Maintain Listed Clearance 12' Min. 12' Min. 45° 45 6' 8' 12' Min. 60 45 Position Firestop Position Firestop Position.
www .desatech.com 108796-01L 1 1 CHECKING FOR PROPER VENTING After completing and checking the electrical, gas and vent connections, follow the lighting instructions and allow the main burner to run for approximately 5 minutes.
www .desatech.com 108796-01L 12 3" Min. (76 mm) Side W all Of Appliance GAS LINE HOOK-UP W ARNING: Gas line hookup should be done by your gas supplier or a qualied service person. W ARNING: Before you pro- cee d, make sure you r gas suppl y is OFF .
www .desatech.com 108796-01L 13 P I L O T ON OFF IN OUT Figure 19 - Connecting Flexible Gas Line to Millivolt V alve Gas Shutoff V alve Flexible Gas Line Do NOT Kink 1/2" NPT Incoming Gas Line No.
www .desatech.com 108796-01L 14 0.5" 0.5" Figure 22 - Pan and Ember Material Clearances Grate Burner Pan Pan and Ember Material INST ALLA TION Continued LO G P LA CEM EN T F OR M3 6E , M 36E P , VM E36 AN D VM 36E P MO DEL S 1. Pla ce small fron t right log (log 1) on rig ht front of grate as shown in Figure 23.
www .desatech.com 108796-01L 15 INST ALLA TION Continued LO G P LA CEM EN T F OR M4 2E , M 42E P , VM E42 AN D VM 42E P MO DEL S 1. Place large back log (log 1) onto grate making sure notches rest over grate (see Figure 27).
www .desatech.com 108796-01L 16 INST ALLA TION Continued COMBUSTION AIR KIT MODEL AK4 (OPTIONAL) The outside air kit may be installed on the left side of the replace only . The vent can be installed through any outside wall a minimum of three feet below replace termination cap.
www .desatech.com 108796-01L 17 6. Repeat the process for the opposite door assembly . 7. T o adjust the doors, slide them partially open. Using a screwdriver , loosen the hold-down screws in the spring clip (see Figure 34) and pivot plate. 8. Close both doors until evenly joined at the middle and note the gap at the outer edges of the face.
www .desatech.com 108796-01L 18 OPERA TING FIREPLACE FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , a re or explosion may result causing property damage, per - sonalinjuryorlossoflife.
www .desatech.com 108796-01L 19 TO TURN OFF GAS TO APPLIANCE 1. T urn off the wall switch. 2. T urn off all electric power to the appliance if service is to be performed. 3. Fully open glass doors if installed. 4. Remove front hearth brick and control access panel.
www .desatech.com 108796-01L 20 CLEANING AND MAINTENANCE W ARNING: Installation and repair should be done by a quali - ed service person. The appli - ance sho uld be inspec ted befo re each use and at least annually by a qualied service person.
www .desatech.com 108796-01L 21 Robertshaw MODEL SP745 IGNITION CONTROL STEP DOWN TRANSFORMER PV GND PV/MV TR MV TH VENT SAFETY SHUTOFF SWITCH MANUAL DAMPER SWITCH IGN EV2 SUPPL Y INCOMING MAIN GAS EV1 TO GAS LINE BURNER 24V AC 120V AC 120V AC INCOMING OR BREAKER) (FUSE BOX OFF ON (SUPPLIED) WALL SWITCH GREEN BLACK WHITE 120v , 60Hz, 0.
www .desatech.com 108796-01L 22 TROUBLESHOO TING Note: Before troubleshoo ting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1.
www .desatech.com 108796-01L 23 TROUBLESHOO TING Continued W ARNING:Ifyousmellgas • Shut off gas supply . • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in yourbuilding. • Immediately call your gas supplier from a neighbor ’ s phone.
www .desatech.com 108796-01L 24 ILL USTRA TED P ARTS BREAKDOWN MODELS M36E(B,H),M36EP(B,H),M42E(B,H),M42EP(B,H),VM36E(B,H), VM36EP(B,H),VM42E(B,H) ANDVM42EP(B,H) 51 21 3 25 2 1.
www .desatech.com 108796-01L 25 P ARTS LIST This list contains replaceable parts used in your heater . When ordering parts, follow the instructions listed under Replacement Parts on page 20 of this manual.
www .desatech.com 108796-01L 26 KEY NO. M3 6(B ,H ) VM 36( B, H) M4 2(B ,H ) VM 42( B, H) D ESC RIP TI ON QTY 12 106658-02 107812-02 Left Refractory , Std. Brick (M36EB/ME42B) 1 108164-02 108169-02 Left Refractory , Herringbone (M36EH/M42EH) 1 106658-01 107812-01 Left Refractory , Std.
www .desatech.com 108796-01L 27 ILL USTRA TED P ARTS BREAKDOWN LOGSETS FOR MODELS M36(B,H),M36P(B,H),VM36(B,H) ANDVM36P(B,H) KEY NO. P ART NUMBER DESCRIPTION QTY .
www .desatech.com 108796-01L 28 KEY NO. P ART NUMBER DESCRIPTION QTY . - 107999-02 Log Set 1 901098-02 Rear Log 1 2A 108723-01 Left Front Log - 1 1" 1 2B 108839-01 Right Front Log - 15 3 / 4 &quo.
www .desatech.com 108796-01L 29 ACCESSORIES NOTICE: Allaccessoriesmaynotbeavailableforallreplacemodels. Purchase these rebox accessories from your local dealer . If they can not supply these accessories, call DESA ’ s Sales Department at 1-866-672-6040 for information.
www .desatech.com 108796-01L 30 _____________________________________________________ ______________________________________________________ ______________________________________________________ ____.
www .desatech.com 108796-01L 31 _____________________________________________________ ______________________________________________________ ______________________________________________________ ____.
LIMITED WARRANTY B-VENT FIREPLACE DESA warrants this product to be free from defects in materials and components for four (4) years from the date of rst purchase, provided that the product has been properly installed, operated and maintained in accordance with all applicable instructions.
デバイスDesa Vm42ePの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Desa Vm42ePをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDesa Vm42ePの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Desa Vm42ePの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Desa Vm42ePで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Desa Vm42ePを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDesa Vm42ePの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Desa Vm42ePに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDesa Vm42ePデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。