DualメーカーXDVD1002CMの使用説明書/サービス説明書
ページ先へ移動 of 20
INSTALLATION/OWNER'S MANUAL XDVD1002CM.
D V D O p e r a t i o n . . . . . . ...................................... C D O p e r a t i o n ............................................. M P 3 O p e r a t i o n ........................................... D i v X O p e r a t i o n . . . . ......
3 XDVD1002CM PREPARATION Before You Begin Cautions To prevent damage or injury: 1. Make sure to ground the unit securely to the vehicle chassis ground. 2. Do not remove the top cover of the unit. 3. Do not install the unit in a spot exposed to excessive heat or the possibility of water splashing.
4 5 XDVD1002CM PREPARATION Contents Main Unit Remote Control Recommended Tools and Equipment • Upholstery hook tool (for removal of panels, if necessary) • #1 and #2 Phillips screwdrivers • Utility knife, razor knife, or shears • Misc.
4 5 XDVD1002CM INSTALLATION Wiring Diagram - Main Unit Yellow Black Red Brown Brown/Black Green Aux 2 Input (Red Jacket) A/V Output (Black Jacket) Connect to battery circuit or constant 12 volt source.
XDVD1002CM INSTALLATION Mounting 6 1. Test fit the mounting bracket and unit on the ceiling of the vehicle, verify- ing that it is not going to interfere with the safe operation of the vehicle and is physically safe for the driver and passengers. 2. Once the mounting location is determined, carefully mark the location with masking tape.
XDVD1002CM OPERATION Control Locations - Main Unit 7 9 10 11 2 3 6 4 5 Power Source Select Chapter/Track Down Dome Light Switch Screen Release Aux1 Inputs 1 2 3 4 Rear IR Sensor Motorized Disc Slot Fr.
XDVD1002CM OPERATION Control Locations - Remote 8 9 Power Return Fast Reverse Enter Chapter/Track Down Root Menu Setup Menu Step Subtitle Dimmer Angle 1 Shuffle Goto Video/Source Repeat LCD Screen Men.
XDVD1002CM OPERATION General Operation To turn on the unit, press the power button on the main unit or on the remote. Press again to turn the unit off.
Press SOURCE on the main unit to select between the following sources: AUX1 > AUX2 > DVD. Press SOURCE on the remote to select between AUX1 > AUX2 > DVD. Adjust volume using VOLUME / on the remote (0-16). Press MUTE on the remote to silence the audio.
XDVD1002CM OPERATION General Operation - Setup Menu 10 11 In the AUDIO SETUP menu, the following menus are availble: Select SPDIF from the AUDIO SETUP menu. Press to make selection. Press or to adjust (ON/OFF). Select OP MODE from the AUDIO SETUP menu.
XDVD1002CM OPERATION DVD Operation 12 13 Press SOURCE on the remote or the main unit to select DVD mode. Press EJECT on the remote control or on the main unit to open the motorized disc slot, insert disc. Press EJECT on the remote control or on the main unit to eject the disc.
XDVD1002CM OPERATION DVD Operation 12 13 Press A-B on the remote for more than 2 seconds to set point “A”. Press A-B for more than 2 seconds to set point “B”. The points between “A” and “B” will continually repeat. Press A-B to cancel repeat A-B.
14 15 XDVD1002CM OPERATION CD Operation Press SOURCE on the remote or the main unit to select DVD mode. Press EJECT on the remote control or on the main unit to open the motorized disc slot, insert disc. Press EJECT on the remote control or on the main unit to eject the disc.
14 15 XDVD1002CM OPERATION Additional MP3 Operation When an MP3 encoded disc is first inserted, SMART NAVI will show on screen. The disc will automatically begin playback . NOTE: It may take a few seconds for the unit to read disc. Disc playback must be stopped by pressing on the remote.
16 17 XDVD1002CM OPERATION DivX ® Operation When a DivX encoded disc is first inserted, playback will begin with the first file auto- matically, To access the SMART NAVI menu screen, stop playback by pressing on the remote . Disc playback must be stopped by pressing on the remote.
16 17 XDVD1002CM WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
18 19 XDVD1002CM OPERATION Troubleshooting Copyright Notes This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners.
18 19 XDVD1002CM OPERATION Specifications Signal-to-noise: >92dB Dynamic range: >85dB Frequency response: 20Hz-20kHz Panel size: 10.2 ” Diagonal measurement Format: Widescreen 16:9 View area: 8.
Dual Electronics Corp. 21318 64th Ave. South Kent, WA 98032 Toll Free: 1-866-382-5476 www.dualav.com ©2005 Dual Electronics Corp. All rights reserved.
デバイスDual XDVD1002CMの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Dual XDVD1002CMをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはDual XDVD1002CMの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Dual XDVD1002CMの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Dual XDVD1002CMで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Dual XDVD1002CMを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はDual XDVD1002CMの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Dual XDVD1002CMに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちDual XDVD1002CMデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。