EchoメーカーCS-305の使用説明書/サービス説明書
ページ先へ移動 of 24
X7503204801 X750006731 06/05 Chain Saw Instruction Manual MODEL : CS-305 W ARNING DANGER Read rules for safe operation and instructions carefully. ECHO provides an Instruction Manual and a Safety Manual. Both must be read and understood for proper and safe operation.
2 RULES FOR SAFE OPERA TION A. Kickback Safety Precaution for Chain Saw Users 1 . With a basic understanding of kickback, you can reduce or eliminate the element of surprise.
3 CONTENTS Page Rules for Safe Operation .................................................................................................. 2 T echnical Dat a ............................................................................................
4 TECHNICAL DA T A * T echnical data subject to change without notice. IMPORT ANT This spark ignition system complies with Canadian ICES-002. l e d o M 5 0 3 - S C n o i s n e m i DH x W x Lm m0 2 2 x 5 3 2 x 0 8 3 h c n i7 . 8 x 2 . 9 x 2 . 0 1 t h g i e Wy r d , d a e h r e w o Pg k) b l 5 .
5 DESCRIPTION The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, guide bar and saw chain installation and other assembly may be necessary. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts.
6 1. Front handle 2. Hand guard (Chain brake actuating lever) 3. Saw chain 4. Guide bar 5. Chain catcher 6. Sprocket guard 7 . Muffler 8. Rear hand guard 9. Throttle control lockout 10 . Throttle control trigger 1 1. Air cleaner cover 1 2 . Chain tension adjustment screw 1 3 .
7 PREP ARA TION FOR USE W ARNING DANGER Saw Chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result. GUIDE BAR AND SA W CHAIN • Remove two guide bar nuts (I) and remove sprocket guard (J). • Mount guide bar (G) on studs, and slide toward sprocket to make saw chain installation easier .
8 L ADJUSTMENT , CHAIN TENSION • Remove spark plug lead. • Loosen two guide bar nuts (I), if necessary . • Hold the bar nose up, and turn the adjuster screw (L) clockwise until the chain touches the bottom of the bar . • Tighten both guide bar nuts with bar nose held up.
9 FUEL T ANK OIL T ANK T ANK INDICA TION IMPORT ANT S tored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabi- lizer is added. S tored two-stroke fuel may separate. AL W A YS shake fuel container thoroughly before each use.
10 Securely hold the saw. OPERA TION B C A WHEN THE ENGINE IS COLD W ARNING DANGER Make sure bar and chain are not touching anything when starting the saw. • Move chain brake lever fully forward to engage chain brake before starting. • Fill the fuel tank with fuel.
11 A A ST ARTING W ARM ENGINE • Ensure that there is fuel and chain oil in the tanks. (If fuel tank was emptied during previous operation, refill tank and push purge bulb 10 times.) • Turn switch (A) to “RUN” position ( I ). • Pull starter handle.
12 W ARNING DANGER Read the ECHO “CHAIN SAW SAFETY MANUAL” included with your chain saw for additional cutting and safety instruc- tions. Failure to obey all instructions may result in serious or fatal injuries. In all circumstances the operation of the chain saw is a one- man job.
13 2” 45° 2” FELLING A TREE DIRECTION OF F ALL Direction of fall Hinge Felling cut First cut Notch Second cut One-third tree diameter LIMBING W ARNING DANGER A falling tree can cause serious injury or damage any- thing it may hit - a car , a house, a fence, a power line, or another tree.
14 BUCKING Uphill position FINISH CUT FIRST CUT Board or flat stones KICKBACK • Improper thrust cutting. • When the bar nose hits another tree, etc. Don’t cut with the saw overhead or the bar in a vertical posi- tion. If the saw should kick back you may not have good enough control to prevent possible injury .
15 NOTE Use ECHO TM replacement guide bars. These guide bars may be considered to have equivalent kickback reduction: • S procket nose guide bars of the same length and nose radius, same pitch and having the same number of teeth. • A hard nose guide bar having the same length and nose radius as a sprocket nose bar .
16 A B C D E G I MAINTENANCE AND CARE AIR FILTER • Check before every use. • Pull choke (A) all the way out (close position). • Loosen bolt and remove air cleaner cover (B) and filter (C). • Lightly brush dust off filter, and inspect for damage.
17 SPROCKET • A damaged sprocket (J) will cause premature damage or wear of saw chain. - When the sprocket has worn out 0.5mm (.020”) or more, replace it. • Check sprocket when you install new chain. Replace it if worn. • Clean sprocket, clutch, and bar mount area before installation of bar.
18 B A CARBURETOR ADJUSTMENT Engine Break-In New engines must be operated a minimum duration of two tanks of fuel break-in before carburetor adjust- ments can be made. During the break-in period your engine performance will increase and exhaust emissions will stabilize.
19 *Reduced nose radius symmetrical bars (OREGON name — Double Guard) W ARNING DANGER Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may cause severe kickback resulting in serious injury.
20 Depth gauge tool Remove until flat with tool Round off the edge 30° 80° 50° 90 0.64 mm (0.025 in.) Parallel Number indicates Chain type Number indicates Chain type 90S (SPROCKET) (DRIVE LINK) • Properly filed cutters are shown below .
21 Fuel is not reaching carburetor Fuel is not reaching cylinder Engine does not start (or, is difficult to start) Engine cranks There is fuel in the tank Fuel is reaching carburetor Fuel is reaching cylinder There is spark at high tension cord end There is spark at plug Starting procedures correct No spark at high tension cord end.
22 Improper fuel used ........................................ Use fuel with correct mixing ratio. Never use gasoline of poor quality. Spark plug defective (worn) .
23 Kickback Motion: • When the bar nose hits another tree, etc. • Improper thrust cutting. CORRECT USE OF CHAIN BRAKE The installation of a chain brake may be mandatory by law or as stipulated by insurance regulations in your area of operation.
CONSUMER PRODUCT SUPPORT 1-800-673-1558 8:30 - 4:30 Mon - Fri C.S.T. ECHO, INCORPORA TED 400 O AKWOOD R OAD L AKE Z URICH , IL 60047 www .echo-usa.com SER VICING INFORMA TION P ARTS Genuine ECHO Parts and ECHO REPOWER TM Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer.
デバイスEcho CS-305の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Echo CS-305をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEcho CS-305の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Echo CS-305の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Echo CS-305で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Echo CS-305を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEcho CS-305の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Echo CS-305に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEcho CS-305デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。