EmersonメーカーCF550ORB00の使用説明書/サービス説明書
ページ先へ移動 of 16
Part No. F40BP74530001 Form No. BP7453-1 ETL Model No.: CF550 READ AND SA VE THESE INSTRUCTIONS 54” Ceiling F an Owner's Manual CF550BS00 CF550ORB00 Model Number L UXE ECO ™ Net W eight: 20.9 Lbs. DATE CODE: The date code of this fan may be found on the box, stamped in ink on a white label.
WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2 . Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally.
3 Unpac king Instr uctions 1. Check to see that you have received the following parts: NOTE: If you are uncertain of part description, refer to exploded view illustration. a. Fan motor assembly b. Light kit assembly c. One ceiling cover d. One coupler cover e.
4 Electrical R equir ements If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture. Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.
5 Ho w to Put Y our Ceiling F an T ogether (continued) FAN MOTOR ASSEMBL Y CEILING COVER DOWNROD RUBBER GROMMET COUPLER COVER Figure 3 4. Make sure the rubber grommet is properly installed onto the coupling cover then slide the coupler cover onto the downrod until it rests on top of the motor housing.
6 Ho w to Hang Y our Ceiling F an The fan must be hung with at least 7' of clearance from floor to blades (Figure 6). CEILING FLOOR A T LEAST 7' Figure 6 WARNING ! The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs.
7 ETL Model No.: CF550 Ho w to W ire Y our Ceiling F an If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
8 4 Position the light kit assembly onto the fan motor assembly, safely tucking all wires and connectors inside the light kit assembly. 5. Engage the two key slots on the light kit assembly with two loosened screws in motor housing assembly. Rotate the light kit assembly clockwise to engage the two screws into both slots and tighten securely.
9 ETL Model No.: CF550 W all Control Installation (continued) W all Control Pr ocedures SINGLE-POLE INST ALLA TION CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver.
10 ETL Model No.: CF550 W all Control Installation (continued) NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire.
11 ETL Model No.: CF550 W all Control Installation (continued) 6. Screw wall control into wall box using the supplied screws. Leave wall control in “OFF” mode until fan installation is completed. 7. The wall control is supplied with a white, ivory, and almond color switch covers.
Using Y our Ceiling F an Fan installation must be completed, including the installation of the fan blades, before testing the remote control. WARNING ! Your wall control has full control of your fan and light. 1. To set the desired fan speed, press the ( ) button to decrease the speed and the ( ) to increase the speed.
13 ETL Model No.: CF550 T r ouble Shooting WARNING: For your own safety, turn off power at fuse box or circuit breaker before trouble shooting your fan. TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1.
14 ETL Model No.: CF550 R epair Par ts 1 7 3 2 13 14 6 10 11 18 12 15 16 17 19 20 9 8 5 4.
15 ETL Model No.: CF550 R epair Par ts Listing Key Model Number No. Description CF550BS00 CF550ORB00 * Hanger Ball Assembly, 761655-17 761655-32 Consisting of: 1 Hanger Bracket —— 2 Hanger Ball —— 3 Downrod (4.
Part No. F40BP74530001 Printed in China 08/12 Form No. BP7453-1 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 ETL Model No.
デバイスEmerson CF550ORB00の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Emerson CF550ORB00をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEmerson CF550ORB00の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Emerson CF550ORB00の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Emerson CF550ORB00で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Emerson CF550ORB00を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEmerson CF550ORB00の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Emerson CF550ORB00に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEmerson CF550ORB00デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。