EmersonメーカーHD8100の使用説明書/サービス説明書
ページ先へ移動 of 19
PE R S O N A L C D , CD - R / R W P L A YE R w i t h 6 0 SE C O N D AN T I - S H O C K a n d L I G H T W E I G H T S T E R E O H E AD P H O N E S HD 8100 - S il v e r HD 8100 R D - R e d HD 8100 B L - B l u e O W N E R ’ S M A N U A L V i s i t ou r w eb s i t e a t w ww .
1 T h a n k y o u . ........ F o r pu r c ha s i ng t h i s E m e r s on P e r s o na l CD P l a y e r . T he C D p l a y e r ha s a 2 0 t r a ck p r og r a mm ab l e m e m o r y s o y ou c a n li s t en t o t he s o ng s on y ou r f a v o r i t e CD ' s i n a n y o r de r y ou c h oo s e .
2 W A RN I N G: T O P R EVE N T F I R E O R S H O C K H A Z A R D , D O N O T E XP O SE T H I S UN I T T O R A I N O R M O I S T UR E . T h i s de v i c e c o m p li e s w i t h pa r t 15 o f t he F CC r u l e s .
3 P R E P AR A T I O N F O R U S E REMOVE THE TRANSIT CARD This personal CD player is shipped with a dummy CD ‘ transit card ‘ inside the CD compartment. The purpose of this card is to prevent the laser from moving during shipment of the product. This card must be removed before using the CD playe r.
4 INS TA LLING THE B ATTERIES Note : The battery compartment is located inside the CD compartment. 1.) Slide the OPEN switch to the right to open the CD door. If you have not already done so, remove the dummy CD ‘ transit card ’ and discard it. 2.
5 CONNECTING THE OPTION AL AC ADAPTER (NOT INCLUDED) 1.) Connect the small female plug of the optional AC adapter to the “ DC IN 4.5 V ” jack on the right side of the CD player. 2.) Connect the adapter housing to your 120V 60Hz AC outlet. Notes: • Never connect or disconnect the adapter from the AC outlet while your hands are wet.
6 CONNECTING THE STEREO HEADPHONES Connect the plug of the supplied stereo headphones to the green-colored headphone jack on the left side of the cabinet. NOTE : Make sure the headphone plug is inserted into the headphone jack as far as it will go. If the plug is not fully inserted, you may only hear sound from one side of the headphones.
7 1 . ) O PE N S w i t c h – S li de t o t he r i gh t t o un l o ck a nd open t he CD doo r . . 2 . ) V O L U M E C on t r o l – R a i s e s o r l o w e r s t he v o l u m e . 3 . ) P H O N ES J a ck – C onne c t s t e r eo headphone s , i n c l uded , t o t h i s j a ck .
8 1 . ) T r a ck N u m be r Di s p l a y . 2 . ) P R OG ( P r og r a m) I n d i c a t o r – A ppea r s w hen p r og r a mm i ng t r a cks o r p l a y i ng p r og r a mm ed t r a cks . 3 . ) S HU FF ( S hu ff l e ) I nd i c a t o r – A ppea r s w hen R a ndo m p l a y ba ck m ode i s s e l e c t ed .
9 O P E R A T I N G I N S T RUC T I O N S SPECIAL FUNCTIONS HOLD Switch The HOLD switch on the bottom of the cabinet must be in the ‘ Off ’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘ On ’ (right) position.
10 Electronic Skip Protection (ESP) This CD player includes an Electronic Skip Protection circuit that continuously stores 60 seconds of CD music in an electronic memory. If the player is bumped or shaken you will not hear any skipping because the player is reading from the memory, not directly from the disc.
11 NORMAL CD PL AYBACK • Make sure you have installed the batteries. • Make sure the HOLD switch is set to the ‘ Off ’ (left) position. • Make sure to set the VOLUME control to a low setting before you put on the headphones. IMPOR TANT: This CD player can play normal CDs plus CD Recordable (CD-R) and CD Rewriteable (CD-RW) discs.
12 6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘ Off’ automatically to conserve the batteries and the display goes blank.
13 PL AY MODE BUTTON Pressing the MODE button during playback cycles the player through the following four special playback modes: (Repeat 1 Track) ALL (Repeat All Tracks) INTRO SHUFF (Shuffle) Playback. REPE AT PLAYBACK The player can be programmed to continuously repeat a single track or the entire disc automatically.
14 INTRO (Intro Scan) PL AYBACK The Intro Scan feature plays only the first 10 seconds of each track on the disc. This feature is useful when you are trying to find a particular song but you cannot remember the title. 1.) Load your disc in the player as usual and press the PL A Y/ PA USE button to begin playback.
15 PROGRAMMED PL AYBACK You can program up to 20 tracks on a disc to play in any desired orde r. NOTE: You can program a disc either during playback or in Stop mode. 1.) Press the PROG button once. The PROG indicator and the Program Number ‘ 01 ’ appear, and the track number ‘ 00 ’ flashes.
16 C L E AN I N G T H E CAB I N E T W i pe w i t h a s o f t c l o t h . If t he c ab i ne t i s v e r y d i r t y , da m pen t he c l o t h w i t h a w ea k s o l u t i on o f neu t r a l de t e r gen t a nd w a t e r , and t hen w i pe c l e an .
17 L I M I T E D W AR RAN T Y E m e r s on R a d i o C o r p . w a rr a n t s m a nu f a c t u r i ng d e f e c t s i n o r i g i n a l m a t e r i a l , i n c l ud i ng o r i g i n a l p a r t s a nd.
E M E R S O N P AR T N O . 16 - 2936 403 - 0 2 P R I N T E D I N CH I NA HD8100_031604.p65 16/3/2004, 11:56 18.
デバイスEmerson HD8100の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Emerson HD8100をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはEmerson HD8100の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Emerson HD8100の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Emerson HD8100で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Emerson HD8100を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はEmerson HD8100の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Emerson HD8100に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちEmerson HD8100デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。