

Color Dome Camera Operation Instructions
Please read this manual first for correct installation and operation. This manual should be retained for future reference. The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice.
80%. The input power sources is 12VDC only.

PREFACE These cameras are compact, full functioned CCD cameras. Their stylish appearance can be applied as per installer's ideal locations. These dome cameras can be mounted either on the ceiling or on the wall easily. The camera uses high sensitive 1/3" color interline transfer CCD sensor with DSP. The camera is featured with Auto Electronic Shutter, Automatic Gain Control, and Auto White Balance functions. FEATURES z The high sensitivity is achieved by using 1/3” SONY Super HAD interline transfer color CCD z The electronic shutter and AGC functions allow the camera to be used in environment with varying light levels. z Built-in anti-aliasing and IR-cut optical filter z Compact size: 87 mm (D). x 58 mm (H) / 3.48” (D) x 2.31” (H) z System available for NTSC or PAL
STANDARD ACCESSORIES z Camera Unit z Operation Instructions (this document)

* Standard board lens f=3.6 mm, F=2.0 mm. * Other available lens : 4 Lens f=4.3 mm, F=2.0 mm 6 Lens f=6.0 mm, F=2.0 mm 8 Lens f=8.0 mm, F=2.0 mm
1. Remove the plastic dome cover. 2. Loosen the two screws of the supporting bracket to remove the camera body. 3. Using four screws to fix the camera base on the ceiling. 4. Put the camera body back to the supporting bracket, the connector of the back panel should always be placed to camera’s left lower corner, in order to obtain the image of best quality. Tighten the 2 screws to fix the camera. Please refer to the back panel diagram shows as below:
a. Floor Mount b. Ceiling Mount
c. Wall mount, aim to the right d. Wall mount, aim to the left
Main Board · Bottom Connector

5. Connect the BNC connector of the camera to a color monitor, or other video device through a 75 ohm type coaxial cable with BNC female connector at cable extension. 6. Connect the DC +12V regulated power source of the camera (DC Jack) to the DC 12V Power-in jack with 2 mm, center+, outer- plug. 7. Once the image appears on the monitor, loosen the fixing screw located at the lens mount then adjust the focus and diaphragm of the lens to obtain the best picture. When the ideal picture is obtained, secure the lens mount by fixing screw firmly again. 8. Put the plastic cover back on the Dome Camera.


EverFocus Electronics Corp.
Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-26982380 www.everfocus.com.tw
China Office: Room B-05D-1, KESHI PLAZA , Shangdi Information Industry Base, Haidian District, Beijing China 100085 TEL: +86-10-62973336/37/38/39 FAX: +86-10-62971423 www.everfocus.com.cn
Japan Office: 1809 WBG MARIBU East 18F, 2-6 Nakase.Mihama-ku. Chiba city 261-7118, Japan TEL: +81-43-212-8188 FAX: +81-43-297-0081 www.everfocus.com

Your EverFocus product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste. Please, dispose of this equipment at your local community waste collection/recycling centre. In the European Union there are separate collection systems for used electrical and electronic product. Please, help us to conserve the environment we live in!
Ihr EverFocus Produkt wurde entwickelt und hergestellt mit qualitativ hochwertigen Materialien und Komponenten, die recycelt und wieder verwendet werden können. Dieses Symbol bedeutet, dass elektrische und elektronische Geräte am Ende ihrer Nutzungsdauer vom Hausmüll getrennt entsorgt werden sollen. Bitte entsorgen Sie dieses Gerät bei Ihrer örtlichen kommunalen Sammelstelle oder im Recycling Centre. Helfen Sie uns bitte, die Umwelt zu erhalten, in der wir leben!
この取扱説明書で参照されているリンク(メーカー、サポート、ダウンロード等)。
ユーザーまたはスタッフが通常1日以内に回答します。あなたの質問が次の人の助けにもなります。
最初の質問を投稿しましょう。他のユーザーや当チームが回答します。