Extron electronicメーカーDTP T UWP 232/332 Dの使用説明書/サービス説明書
ページ先へ移動 of 31
User Guide DTP T HWP 232/332 D DTP T UWP 232/332 D HDMI T ransmitters HDMI T wisted Pair Extender T ransmitters 68-2547-01 Rev . A 03 14.
Safety Instructions Safety Instructions • English WARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated danger ous voltage within the product’ s enclosure that may pr esent a risk of electric shock.
FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rules. The ClassA limits provide r easonable protection against harmful interfer ence when the equipment is operated in a commercial environment.
Conventions Used in this Guide Notifications The following notifications are used in this guide: CAUTION: A caution indicates a situation that may result in minor injury . A TTENTION: Attention indicates a situation that may damage or destroy the pr oduct or associated equipment.
v DTP T HWP/UWP 232/332 D T ransmitters • Contents Contents Introduction ............................................................ 1 About this Guide ................................................. 1 About the DTP T HWP D and DTP T UWP D Extenders .
.
DTP T HWP/UWP 232/332 D T ransmitters • Introduction 1 Intr oduction • About this Guide • About the DTP T HWP D and DTP T UWP D Extenders • Features About this Guide This guide provides instru.
DTP T HWP/UWP 232/332 D T ransmitters • Introduction 2 DTP T HWP D and DTP T UWP D systems consist of a transmitter (Tx) and a receiver (Rx). The transmitters and corresponding compatible r eceivers are sold separately .
DTP T HWP/UWP 232/332 D T ransmitters • Introduction 3 Featur es T ransmits single link HDMI-D signals over one STP cable — T wisted pair cables provide an economical, easily installed cable solution.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 4 Installation and Operation This section describes the installation and the operation of the extenders, including: • Mounting th.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 5 Site Preparation and W all Box Installation Choose a location that allows cable runs without interference. Allow enough depth for both the wall box and the cables. Install the cables into the wall, furniture, or conduits before installing the wall plate.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 6 6. Feed the twisted pair cables and, if applicable, the power cables through the opening and through the wall box punch-out holes, securing them with cable clamps to pr ovide strain relief.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 7 Final Installation After testing and making any adjustments, do the following: 1. At the power outlet, unplug the power supply . NOTE: One power supply can power both the transmitter and the receiver (see Power Supply Wiring on page 13).
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 8 DTP T HWP 232 and 332 D Connections Front Panel AUTO SW CONFIG IR OUT HDMI IN AUDIO IN S G HDCP 1 AUDIO IN VGA IN Ext ro n AUTO S.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 9 Rear Panel R DTP OUT REMOTE O VER DTP SIG LINK RS-232 CONT AC T Tx Rx Tx Rx G PO WER 12V A MAX 0.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 10 DTP T UWP 232 and 332 D Connections Front Panel AUTO SW CONFIG IR OUT HDMI IN AUDIO IN S G HDCP 1 AUDIO IN VGA IN Ext ro n AUTO .
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 11 Rear Panel R DTP OUT REMOTE O VER DTP SIG LINK RS-232 CONT AC T Tx Rx Tx Rx G PO WER 12V A MAX 0.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 12 TP Cable T ermination and Recommendations Figure 9 details the r ecommended termination of both ends of TP cables with RJ-45 connectors in accordance with the TIA/EIA-T568B wiring standar d.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 13 Power Supply W iring NOTES: • Only one power supply is requir ed. A single power supply connected to either unit in the pair powers both units. • A power supply is included with each individually-packaged transmitter .
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 14 RS-232 and IR Connector W iring Remote RS-232 and Contact Closure Connector Wire the rear Remote RS-232 and contact closur e connector as shown in figure 11.
DTP T HWP/UWP 232/332 D T ransmitters • Installation and Operation 15 Operation AUTO SW CONFIG IR OUT HDMI IN AUDIO IN S G HDCP 1 2 HDMI IN AUDIO IN Extr on AUTO SW CONFIG IR OUT HDMI IN AUDIO IN S G HDCP 1 AUDIO IN VGA IN Ext ro n DTP T HWP 232/332 D Front Panel DTP T UWP 232/332 D Front Panel A B C A B C Figure 14.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 16 Remote Contr ol This section includes: • Contact Closure Contr ol • Simple Instruction Set Control The DTP T HWP D and DTP T UWP D famil.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 17 Simple Instruction Set Contr ol The DTP T HWP D and DTP T UWP D family of extenders can be remotely contr olled using SIS commands from a ho.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 18 Using the Command and Response T able The command and response table begins on page 20. Symbols ar e used throughout the table to repr esent variables in the command and response fields. Command and r esponse examples are shown thr oughout the table.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 19 X1& = V erbose mode 0 = clear/none 1 = verbose mode ( default ) 2 = tagged responses for queries 3 = verbose mode and tagged for queries.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 20 Command and Response T able for SIS Commands Command Function SIS Command (Host to Unit) Response (Unit to Host) Additional Description Select and view input Select an input X! ! In X! • All ] Select input X! to transmit to the connected receiver .
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 21 Command Function SIS Command (Host to Unit) Response (Unit to Host) Additional Description Picture adjustment (RGB input only , UWP models o.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 22 Command Function SIS Command (Host to Unit) Response (Unit to Host) Additional Description EDID Minder NOTE: Se e table 1 for the EDID values.
DTP T HWP/UWP 232/332 D T ransmitters • Remote Control 23 Command Function SIS Command (Host to Unit) Response (Unit to Host) Additional Description Video mute Enable video mute 1B Vmt1 ] Output no video signal. Disable video mute 0B Vmt0 ] Output selected video input.
DTP T HWP/UWP 232/332 D T ransmitters • Reference Information 24 Refer ence Information This section includes Decora template dimensions for installation of the DTP T HWP D and DTP T UWP D family of transmitters. Decora T emplate Dimensions T o create a template, use the dimensions shown on figur e 14.
Extr on W arranty Extron Electr onics warrants this product against defects in materials and workmanship for a period of thr ee years from the date of pur chase.
デバイスExtron electronic DTP T UWP 232/332 Dの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Extron electronic DTP T UWP 232/332 Dをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはExtron electronic DTP T UWP 232/332 Dの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Extron electronic DTP T UWP 232/332 Dの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Extron electronic DTP T UWP 232/332 Dで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Extron electronic DTP T UWP 232/332 Dを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はExtron electronic DTP T UWP 232/332 Dの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Extron electronic DTP T UWP 232/332 Dに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちExtron electronic DTP T UWP 232/332 Dデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。