Extron electronicメーカーSM 26の使用説明書/サービス説明書
ページ先へ移動 of 18
User Guide SM 26 Speakers SpeedMount ® Surface Mount Speakers 68-2164-01 Rev. A 08 13.
Safety Instructions • English WARNING: This symbol, , when used on the product, is intended to alert the user of the presence of uninsulated danger ous voltage within the product’ s enclosure that may pr esent a risk of electric shock.
Conventions Used in this Guide Notifications The following notifications are used in this guide: CAUTION: A caution indicates a situation that may result in minor injury . A TTENTION: Attention indicates a situation that may damage or destroy the pr oduct or associated equipment.
SM 26 Surface Mount Speaker • Contents iv Contents Introduction ................................................... 1 About this Guide ................................................. 1 About the SM 26 Surface Mount Speaker .......... 1 Features ..
SM 26 Surface Mount Speaker • Introduction 1 Intr oduction This section gives an overview of the Extron SM 26 SpeedMount Surface Mount Speaker . T opics include: • About this Guide • About.
SM 26 Surface Mount Speaker • Introduction 2 • Color options — Available in black or white finishes. • Automatic speaker connection — Recessed gold-plated contact pins integrated into each speaker automatically make an electrical connection when the speaker is mounted to the wall mounting plate.
SM 26 Surface Mount Speaker • Installation 3 3 Installation NOTE: Unless otherwise stated, mounting hardwar e is not included. This section describes the installation and setup of the SM 26 surface mount speaker .
SM 26 Surface Mount Speaker • Installation 4 The mounting plate can be installed vertically or horizontally , as shown below . Catch Ta b V ertical Mounting Figure 3. Positioning the Mounting Plate NOTE: Observe all applicable building codes and local ordinances when installing the speaker .
SM 26 Surface Mount Speaker • Installation 5 Mounting to a W all Stud NOTE: Mounting hardwar e not provided. 1. Locate the wall stud where the mounting plate will be installed. 2. If using the 10° mounting adapter , position the adapter to the wall stud according to how the speaker will be angled and mark the positions of the pilot holes.
SM 26 Surface Mount Speaker • Installation 6 5. The SM 26 can be mounted with or without the 10° mounting adapter . In either case the wiring of the quick connect contacts remains the same, but the wir e routing will vary .
SM 26 Surface Mount Speaker • Installation 7 Routing the wires with the 10° mounting adapter Route the speaker cable through the 10° mounting adapter and the 0° mounting plate, and attach the adapter to the 0° mounting plate using the four included screws and washers, as shown below .
SM 26 Surface Mount Speaker • Installation 8 6. Attach the mounting plate to the wall, as shown below . A TTENTION: Use the appropriate mounting scr ews. The screw heads must not protrude mor e than 0.27 inch (7 mm) above the screw holes in the mounting plate (see the figure below).
SM 26 Surface Mount Speaker • Installation 9 Y oke Mounting the SM 26 The SM 26 can be mounted using the optional yoke mount kit. Refer to the Y oke Mount Kit Setup Guide for installation details. Attaching a Secondary Support Cable If a secondary support cable is being attached, attach the cable to the eye bolt, as shown below .
SM 26 Surface Mount Speaker • Installation 10 Attaching the Speaker to the Mounting Plate A TTENTION: By default, the SM 26 speaker is shipped unlocked.
SM 26 Surface Mount Speaker • Installation 11 Setting the T ap Selector Switch (SM 26T Model Only) For the SM 26T model, insert a small screwdriver thr ough the upper left portion of the front grille, as shown below , to adjust the tap selector switch to the desired setting.
SM 26 Surface Mount Speaker • Installation 12 Using the Security Key to Lock and Unlock the Speaker Insert the key into the center of the speaker grille and turn the key , as needed, so that the speaker is in the unlocked position (see the figure below).
SM 26 Surface Mount Speaker • Installation 13 Removing the Speaker from the Mounting Plate T o remove the speaker from the mounting plate, you must unlatch the locking mechanism. 1. Insert the security key into the keyhole of the speaker grille (see the previous section) and turn the key to the unlock position.
Extron Headquarters +1.800.633.9876 (Inside USA/Canada Only) Extron USA - W est Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 F AX +1.919.850.1001 F AX Extron Europe +800.3987.6673 (Inside Europe Only) +31.33.453.4040 +31.33.453.4050 F AX Extron Asia 800.
デバイスExtron electronic SM 26の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Extron electronic SM 26をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはExtron electronic SM 26の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Extron electronic SM 26の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Extron electronic SM 26で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Extron electronic SM 26を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はExtron electronic SM 26の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Extron electronic SM 26に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちExtron electronic SM 26デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。