Fantom VacuumメーカーFM766HGの使用説明書/サービス説明書
ページ先へ移動 of 19
REPLACEMENT PAR TS IMPORT ANT SAFETY INSTRUCTIONS NAME OF EACH P ART PREPARA TION BEFORE USE USING THE VACUUM CLEANER USING THE A TTACHMENTS EMPTYING THE DUST COMP ARTMENT CLEANING THE FILTERS CLEARIN.
IMPORT ANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - T o reduce the risk of fire, electric shock or injury: 1.
2 16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly . 19. Do not pick up items such as pieces of waste paper or cloth which looks as though they may cause the hose to become blocked.
3 NAMES OF EACH P ART W ARNING: Operate vacuum cleaner only at the voltage specified on name plate. FRONT REAR Set the O N/OFF switch to " ON " to light the headlight.
Handle Wa nd Crevice T ool Upholstery T ool & Dusting Brush Duster Hose Cuff Suction Inlet Suction Hose A Caution : Do not connect the power cord plug to the wall outlet until assembly is completed.
5 PREP ARA TIONS BEFORE USE WINDING THE POWER CORD 1 Wind the p ower cord around the co rd sto rage hooks. Secure the power cord plug on the power cord. Cord Storage Hooks THERMAL SAFETY DEVICE IN MAIN BODY T o protect your vacuum cleaner motor from overheating, a thermal safety device has been built in.
Handle Release Lever Handle Release Lever Parallel position This position is used for cleaning under furniture. 6 USING THE V ACUUM CLEANER ADJUSTING THE HANDLE Upright po sition The handle is normally locked in this The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel.
Rug/Floor (T ools) SELECTOR EDGE CLEANING This vacuum c leaner is equipped with an "edge cleaning" function for c leaning ca rpet edges near baseboards and stationary furniture. 7 1 2 RUG/FLOOR (T OOLS)SELECT OR The RUG/FLOOR(TOOLS)selector should only be adjusted while the vacuum cleaner is turned on and in the upright position.
Holder Mount Hose Holder Release Button C Wan d Crevice T ool Duster Attachment Clamp Caution: When using one of the attachments during cleaning,set the vacuum cleaner to the upright position. 1 2 3 USING THE A TT ACHMENTS Press the release button C to disconnect the handle from the vacuum cleaner .
Hose Cuff Suction Inlet Suction Hose A USING THE A TT ACHMENTS 9 Hose Attachment Line up notches push hose in till it clicks. Handle.
Projection Groove MAX mark 1 1 2 3 2 4 1 2 Trapdoor Release Lever Duster Handle Turn the duster handle several times in the direction shown to empty the dust compartment. EMPTYING THE DUST COMP ARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning.
Remove the dust compartment.(refer to page 11) Clean the filter fins free of dirt with the forked end of cleaning utensil as shown. Prefilter Dust Compartment Ribs Main Filter 1 1 CLEANING THE FIL TERS 2 Set the dust compartment to the parallel position.
Bypass V alve (Inside) Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect Cleaning the agitator assembly 1 2 3 CLEARING BLOCKAGES AND CLEANING THE A GIT A T OR ASSEMBL Y the power cord from the wa ll outlet before clearing any blockages in the suction hose and cleaning th e agitator assembly .
REPLACING THE HEADLIGHT LAMP REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below . 1 Set the vacuum cleaner to the parallel position.
Place a new flat belt onto the motor shaft and pulley. 1 2 3 4 5 REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the O N/OFF swit ch to the"OFF" position a nd dis connect the po wer cord fro m the wall outlet before replacing an y of the parts be low .
Loosen Screw Latch Mounting screw Projection Groove Tight en Screw Latch Bottom Plate 15 1 1 REPLACEMENT INSTRUCTIONS REMOVING THE BOTT OM PLA TE Set the vacuum cleaner to the parallel position and turn it over .
Filter Cover Seal 1 1 1 1 2 2 HEP A Filter 2 2 1 1 Sub-Filter Air Inlet Cover Caution: Be sure that seal on the HEPA filter is inserted towards the inside of the vacuum cleaner. The filter cover should be correctly oriented when it is reattached. Do not reattach it upside down.
If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring.
In US: FANTOM, 94 Main Mill Street, Door 16, Plattsburgh, N.Y . 12901 RETURN TO FANTOM , 94 Main Mill Street, Door 16 , Plattsburgh , N.Y . 12901 OWNERSHIP REGISTRA TION CARD Please fill out and mail the product registration card within ten (10) days of purchase.
デバイスFantom Vacuum FM766HGの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Fantom Vacuum FM766HGをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはFantom Vacuum FM766HGの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Fantom Vacuum FM766HGの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Fantom Vacuum FM766HGで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Fantom Vacuum FM766HGを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はFantom Vacuum FM766HGの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Fantom Vacuum FM766HGに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちFantom Vacuum FM766HGデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
