Fisher & PaykelメーカーDW820の使用説明書/サービス説明書
ページ先へ移動 of 28
Installation instructions and User guide NZ & A U Dishw asher DW820 and DW920 models.
.
1 Contents Installation instruc tions 2 Introduction 6 Quick operating instructions 7 Control panel 8 Loading the dishwasher 11 Detergent 13 Rinse aid 14 W ash programmes 15 Changing the preset options 16 Australian/New Zealand Standar d AS2007.
2 MAX Ø 20m m MIN Ø15mm I nstallation instructions Befor e you start These instructions are intended as a guide only . I t is the responsibility of the Plumber and Electrician to ensure that each installation complies with the Government Regulations and Local Government By- Laws.
3 T o Change the Setup for a hot or cold water supply This is only required on a F isher & Paykel DW920 model. 1 Pr ess the POWER button to turn the Dishwasher off . 2 Hold the ECO button for 15 seconds and the dishwasher will beep. On the time Display , “H” or “C ” will be displayed.
4 Door open (D) 595mm Width (B) 600mm Depth ( C) 560mm Height (A) 825-875mm Electrical A 3 Pin 10 Amp switched outlet is requir ed. The switch must be located in a readily accessible position with the product installed.
5 Diagram 1: Dishw asher Plumbing and drainage options Diagram 2: Dishw asher & waste disposal unit Diagram 3: Dishw asher using sink trap with dishwasher dr ain hose spigot Was t e Wat e r 200mm .
6 I ntroduction F isher & Pa ykel strongly recommend that you read the information contained in this User Guide before using the dish washer . After your Dishwasher has been installed, please check that: 1 The Dishwasher has been installed in accordance with installation instructions.
7 Quick operating instructions Load the dishes into the dish washer Remove any large scraps of f ood from dishes. Ensure the dish washer is not overcrow ded when loading as this may lead to poor wash per formance. Check spray arms can rotat e Ensure there ar e no items block ing the spray arm path.
8 Contr ol panel P ower Button This turns the Dishwasher on and off. On After pressing the POWER button:- 920 Model Only - The Time Remaining Display will indicate the time remaining in minutes for the wash programme selected. 820 Model Only - The wash programme light will be lit up.
9 W ash button T o select a wash programme, press the W ASH button. The wash button will scroll between the normal - light - fast and rinse wash programmes. The light below the wash programme will indicate your selection. Eco button The Eco feature r educes the temperatures during the wash.
10 Time r emaining display (920 Model Only) This indicates the approximate time r emaining in the wash programme. The Time Remaining Display is based on 20°C or 60°C incoming supply , depending on whether the water connection is cold or hot.
11 L oading the dishwasher Scrape off large food scraps and remov e bones, crusts, toothpicks and any similar items . Load the dishes, taking care not to overload the dishwasher . Check there are no items blocking the path of the spray arm. Check by giving the top and bottom spray arm a turn before you close the door .
12 Cutlery basket A removable cutlery bask et sits in the centre of the lower basket. Load cutlery handles down for the best wash per formance. T ak e care when loading and unloading sharp k nives or prongs. Mix spoons, knives and forks within each section of the basket.
13 Det er ge nt Detergent usage The detergent dispenser is located on the inside of the Dishwasher door . Check the W ash Pr ogramme Chart for the correct amount of detergent or consult the detergent manufacturer ’ s instructions.
14 Rinse aid Rinse Aid helps give a streak-fr ee, spark ling clean look to glass and chinaware. It speeds up dr ying and helps prevent metal from tarnishing . The Rinse Aid Dispenser is on the inside of the Dishwasher door . The dispenser holds 140ml, enough for about 70 regular washes.
15 W ash programmes Detergent quantities W ash descriptions W ash times (approx. minutes) Wa s h programme W he n t o us e P r e w as h (g) Main wash ( g) Pre wash 1 Pre wash 2 Main wash Pos t rinse 1.
16 Changing the pr e -set options End of programme beeps The beeps at the end of each wash programme can be removed by f ollowing the steps below . 1 Pr ess the POWER button to turn the Dishwasher off.
17 Australian/New Z ealand standards AS2007.1 Loading patterns F isher & Pa ykel Dishwashers are tested to Australian/New Z ealand Dishwasher Standards f or both wash and dr y per formance. The loading pattern for AS 2007.1 is shown below . Detergent quantities F or testing to AS2007.
18 Care guide The combination of high temperatures and Dishwasher detergent may cause damage to some items if they are washed in the Dishwasher . Remember , if you are in doubt about any aspect concerning items washed in the Dishwasher , follow the instructions from the manufacturer of the items, or wash the item by hand.
19 Care and cleaning Cleaning the strainer The filter plate is designed to be self cleaning but occasionally food scraps may collect. Sweep these into the strainer before emptying. The strainer should be regularly checked and removed f or cleaning, if necessar y .
20 P roblem solving If the Dishwasher does not appear to be operating properly, check this chart before you call f or ser vice. Problem P ossible cause What to do The dish washer will not start. Door not closed properly. Close the door by pushing the handle forward until it ‘ clicks’ , Po wer supply not connected.
21 Problem P ossible cause What to do W ater does not flow . T aps turned off. Check the taps are turned on. Inlet hose bent or k inked. Straighten the inlet hose so that water can flow through. W ater spots, streaks or film on glassware. Incorrect r inse aid setting.
22 F ault codes Y ou are reminded that if you call a F isher & P aykel Authorised Ser vice Centre because of a User F ault, it is not covered by the Warranty . Should you encounter any problems we r ecommend that you call our Customer Care Centr e.
23 Manufac turer ’ s warrant y When you purchase any new F isher & P aykel whiteware Pr oduct you automatically receive a two year Manufacturer ’ s W arranty covering par ts and labour for ser vicing.
24 Customer car e Check the things you can do yourself . Refer to your User Guide and check: 1 your appliance is correctly installed 2 you are familiar with its normal operation If after check ing these points you still need assistance please refer to the following: In New Zealand If you need assistance.
.
Copyright Reserved © Fisher & P aykel 2004. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.
デバイスFisher & Paykel DW820の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Fisher & Paykel DW820をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはFisher & Paykel DW820の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Fisher & Paykel DW820の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Fisher & Paykel DW820で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Fisher & Paykel DW820を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はFisher & Paykel DW820の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Fisher & Paykel DW820に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちFisher & Paykel DW820デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
