FollettメーカーMU155N Seriesの使用説明書/サービス説明書
ページ先へ移動 of 20
Installation, Operation and Ser vice Manual MU155N Series - 120V 60Hz Ice and W ater Dispenser s Cool Ideas For Ice Managemen t 209091R00 801 Church Lane • PO Box D, Easton, PA 18044 (610) 252-7301 • FAX (610) 250-0696 • www.follettice.com ® Following installation, please f orwar d this manual to the appropriate operations per son.
.
Ta b le of contents W elcome to Follett . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Bef ore y ou begin. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Specifications . . . . .
W elcome to Follett Follett ice and water dispensers enjoy a well-deserved reputation for excellent performance, long-term reliability and outstanding after-the-sale support. To ensure that this dispenser delivers that same degree of service, we ask that you take a moment to review this manual before beginning the installation of the dispenser.
Plumbing Dispenser 3/4" PVC slip joint for hopper drain 3/4" PVC pipe nipple for beverage drain pan 3/8 ID red line tubing for water in Note: Drains should be hard-piped and insulated.
5 Junction box Junction box Field wiring diagram is intended to aid electrician or technician in understanding how equipment works. IMPORTANT L1 L2 GND Electric supply 120V 60Hz L1 L2 GND Electric sup.
Installation Installing MU155N dispenser in counter 1. Check that dispenser location meets all requirements in this manual and cut counter as shown. 2. Block up area below counter cut-out to support dispenser when lowered into place. 3. For automatic load dispensers, disconnect ice transport tube from bracket in storage area of dispenser.
Installing remote icemaker (automatic load units only) 1. Position icemaker in desired location. 2. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser. 3. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice transport tube(s).
To star t up and operate dispenser 1. Follow detailed cleaning instructions in service manual before operating dispenser. 2. For manual load units, remove front drain pan or rear lid and fill storage area with compatible ice. 3. Turn power switch located on control box to ON position.
9 Cleaning bin before use 1. Wipe storage area with Solution A. 2. Rinse thoroughly with clear, potable water. 3. Wipe with Solution B to sanitize. P eriodic cleaning of dispenser Recommended daily c leaning of drain pan 1. Remove all debris from drain pan.
Dispense chute co ver removal 1. Remove top cover. 2. Push chute cover up vertically to slip off holding tab. 3. After clearing tab, pull chute cover forward to remove. Dispense mechanism assembl y remov al 1. Remove top cover. 2. Remove chute cover (see above).
Service Disassembl y instructions for service requirements only – NO T required for an y cleaning pr ocedure Dispense wheel motor remov al (Fig. 3) 1. Remove drain pan, bin access cover and dispense wheel. 2. Remove stainless steel baffle plate under dispense wheel.
Blk Blk COUNTERCLOCKWISE ROTATION COUNTERCLOCKWISE ROTATION Red Yel Red Red SWITCH NO. 1 SWITCH NO. 2 IM_#2 IM_#1 AutoFill Timer 24 Volts R1 Blu T-STAT BIN 2 2 Red 3 3 9 6 18 MIN OFF 5 SEC ON 2 NO C D.
13 Symptom Ice does not dispense. • Auger motor does not run • Wheel motor does not run Ice does not dispense. • Auger motor runs • Wheel motor runs • Gate does not open Ice does not dispense. • Auger motor does not run • Wheel motor runs Ice does not dispense.
Reference # Description Part # 1 Label, “Follett” 502438 2 Top cover (includes label and magnet) 502905 3 Drain pan (includes magnet) 502903 4 Grille, drain pan 502450 5 Cover, electrical componen.
Dispense assembly side view (right-hand unit shown) Reference # Description Part # 1 Gate, dispense 502455 2 Linkage pin, gate/solenoid 502456 3 Pin, quick release, 141mm, dispense gate 502102 4 Solen.
16 2 Reference # Description Part # 1 Auger, LH unit (black, stamped with “1”) 502491 Not shown Auger, RH unit (gray, stamped with “2”) 502492 2 Plate, auger bearing 501696 Not shown Tube, aug.
17 Reference # Description Part # Auger motor/drive assembly, vertical (includes all items below) 502953 1 Motor, vertical auger (includes gearbox and capacitor) 502476 2 Chain, auger drive #35, 40p 5.
Reference # Description Part # 1T ransformer, 24V 502058 2 Relay, dispense 501826 3 Relay, auto fill 501826 4 Timer, auto fill (automatic fill units) 502471 5S trip, terminal 502472 6 Tube, water disp.
Cool Ideas For Ice Managemen t 209091R00 4/02 801 Church Lane • PO Box D, Easton, PA 18044 (610) 252-7301 • FAX (610) 250-0696 • www.follettice.com ®.
デバイスFollett MU155N Seriesの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Follett MU155N Seriesをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはFollett MU155N Seriesの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Follett MU155N Seriesの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Follett MU155N Seriesで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Follett MU155N Seriesを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はFollett MU155N Seriesの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Follett MU155N Seriesに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちFollett MU155N Seriesデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。