GefenメーカーEXT-DVI-1CAT5-ELRの使用説明書/サービス説明書
ページ先へ移動 of 28
Audio Embedder 3GSDI EXT-DVI-1CAT5-ELR User Manual DVI ELR Extender over one CAT5 *Pr eferred Release A1.
ii 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this product near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer ’s instructions.
iii Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notied within two (2) years from the da.
iv T echnical S upport (818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday , Pacic T ime Fa x (818) 772-9120 Email support@gefen.com We b http://www .gefen.com Mailing Addr ess Gefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 9131 1 Pr oduct R egistr ation Register your product here: http://www .
v v Operating Notes • Shielded T wisted-Pair (STP) CA T -5e or CA T -6 cabling is recommended. However , Un-shielded T wisted-Pair (UTP) CA T -5e or CA T -6 cabling is acceptable. Shielded cable is preferred as it provides immunity to Electromagnetic Interference (EMI), cell phones, and A/C motors.
vi Features and Packing List Features • Extends DVI up to 495 feet (150 meters) over one CA T -5e cable • Supports resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA) • EDID management for r.
.
viii Table of Contents 1 Get ting St arted Introduction............................................................................................................ 2 Sender Unit .........................................................................
.
.
DVI ELR Extender over one CAT5 1 Ge t ting St ar t ed Introduction............................................................................................................ 2 Sender Unit ..............................................................
page | 2 Introduction Sender Unit 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-ELRS Gefen 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-E.
page | 3 Introduction ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Receiver unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product.
page | 4 Introduction Getting S tart ed Getting S tart ed Receiver Unit 5V DC Link DVI Out Power DVI ELR Extender over one CAT5 R Link EXT -DVI-1CAT5-ELRR Gefen 5V DC Link DVI Out Power DVI ELR Extend.
page | 5 Introduction Getting S tart ed ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Sender unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product.
page | 6 Installation Getting S tart ed Connection Instructions 1. Use the included DVI cable to connect the DVI source to the DVI In port on the Sender unit.
.
.
page | 9 DVI ELR Extender over one CAT5 2 Basic Oper ation LED Status .......................................................................................................... 10 DIP Switch Conguration .............................................
page | 10 Adv anced Oper ation LED Status Basic Oper ation The Power and Link LED indicators on the Sender and Receiver unit provide basic information on the current status of the DVI ELR Extender over one CA T5. The information, in the table below , applies to both the Sender and Receiver unit.
page | 1 1 DIP Switch Conguration Adv anced Oper ation There is a bank of four DIP switches on the bottom of the Sender and Receiver unit. Remove the piece of colored tape to reveal the DIP switch bank. These DIP switches provide control over EDID management, HPD pass-through, power modes, and range selection.
page | 12 Adv anced Oper ation DIP Switch Conguration Each of the following sections describe the DIP switch settings that control each feature. DIP switches that are not related to a specic feature have been grayed-out. Note that DIP switch settings can be used independently or in conjunction with other features, as desired.
page | 13 DIP Switch Conguration Basic Oper ation Power Mode Description Sender unit Receiver unit Power-Save (Green) mode. The Receiver unit is powered only when a video signal is present on the DVI (or HDMI) cable. Sleep Mode consumes less than 1 W att of power .
.
DVI ELR Extender over one CAT5 3 Appendix Specications .............................................................................................
page | 16 Appendix Specications Supported Formats Resolutions (max.) • 1920 x 1200 (WUXGA) • 1080p Full HD Connectors, Indicators, and Controls DVI In (Sender) • 1 x DVI-I, 29-pin, female (di.
.
20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com Stretch it. Switch it. Split it. Gefen’s got it. ® 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.
デバイスGefen EXT-DVI-1CAT5-ELRの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Gefen EXT-DVI-1CAT5-ELRをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはGefen EXT-DVI-1CAT5-ELRの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Gefen EXT-DVI-1CAT5-ELRの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Gefen EXT-DVI-1CAT5-ELRで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Gefen EXT-DVI-1CAT5-ELRを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はGefen EXT-DVI-1CAT5-ELRの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Gefen EXT-DVI-1CAT5-ELRに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちGefen EXT-DVI-1CAT5-ELRデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
