AmanaメーカーRS2320006の使用説明書/サービス説明書
ページ先へ移動 of 39
RS2320006 Revision 0 August 2001 This manual is to be used by qualified appliance technicians only. Amana does not assume any responsibility for property damage or personal injury for improper service procedures done by an unqualified person.
RS2320006 Rev. 0 2 Important Information Pride and workmanship go into every product to provide our customers with quality products. It is possible, however, that during its lifetime a product may require service.
3 RS2320006 Rev. 0 Table of Contents Important Information ................................................. 2 Important Safety Information ...................................... 4 ALL APPLIANCES ............................................... 5 SURFACE COOKING UNITS .
RS2320006 Rev. 0 4 Important Safety Information WARN ING ! To a void risk of electrical shock, personal injury, death, or property damage, verify wiring is correct, if components were replaced. Verify proper complete operation of unit after servicing.
5 RS2320006 Rev. 0 Important Safety Information SURFACE COOKING UNITS 1. Use Proper Pan Size—This appliance is equipped with one or more surface units of different size. Select utensils having flat bottoms large enough to cover the surface unit heating element.
RS2320006 Rev . 0 6 General Information Cooking Utensils • Use proper pan size. Do not use a pan that has a bottom smaller than element. Do not use utensils that overhang element by more than 1 inch. More than 1" overhang 2" Less than 1" overhang 1" • Use care when using glazed cooking utensils.
7 RS2320006 Rev . 0 General Information Follow these recommendations only as a guide for times and temperature. Times, rack position, and temperatures may vary depending on conditions and food type. For best results, always check food at minimum time.
Component Testing Information ! WARNI NG To avoi d risk of electric al shoc k, per sonal inj ury or de ath; disc onnect p ower to o ven bef ore ser vicing, un less testing r equires it. RS2320006 Rev. 0 8 Refer to Technical Sheet or Parts Manu al for replacement components specifications.
Troubleshooting Procedures ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to oven before servicing, unless testing requires it. RS2320006 Rev. 0 9 Problem Possible Cause Correction Surface element does not heat • Open element .
Troubleshooting Procedures ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to oven before servicing, unless testing requires it. R S2320006 Rev. 0 10 Problem Possible Cause Correction Melted top door trim • Miss - aligned door gasket .
Disassembly Procedures 11 RS2320006 Rev. 0 To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it. WA RNI NG ! Oven Door Handle, Outer/Inner Glass, and Door Hinges 1. Open or remove storage drawer to avoid damaging finish.
Disassembly Procedures To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it. WA RNI NG ! RS2320006 Rev. 0 12 Reverse Procedure to Reassemble Oven Door Position slot on oven door hinge arms into the hinge receivers.
Disassembly Procedures 13 RS2320006 Rev. 0 To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it. WA RNI NG ! Maintop NOTE: Requires range to be moved out away from the wall.
Disassembly Procedures To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it. WA RNI NG ! RS2320006 Rev. 0 14 Broil Element 1. T urn of f power to unit. 2. Remove screw securing broil element to rear of oven wall.
Disassembly Procedures 15 RS2320006 Rev. 0 To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it. WA RNI NG ! Storage Drawer Removal 1. Pull drawer out until it stops. 2.
Disassembly Procedures To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it.
A1 RS2320006 R ev . 0 Appendix A.
RS2320006 Re v . 0 A 2 Installa tion Electric Range PREP ARE T O INST ALL RANGE AND INST ALL ANTI-TIP BRA CKET Measure cabinet area and prepare it according to illustrations in Minimum Clearances to Combustible Surfaces and Range and Cabinet Dimensions section in this manual.
A3 RS2320006 R ev . 0 CONNECT ELECTRICAL CORD T o place electrical receptacle, see Electrical Receptacle Location diagram in this manual. 2 3-wir e or 4-wire Plug Connection Four-wire cord is required for mobile homes or where codes (Canada) do not permit grounding through neutral.
RS2320006 Re v . 0 A 4 POSITION AND LEVEL RANGE Place range near final position and plug in. Then, slide range into final position and adjust all legs (4) until range is level side to side and front to back. Place a level on top oven rack or on range top when leveling.
A5 RS2320006 R ev . 0 Bef ore Y ou Install Installation Requirements Consider Descri pt i on Location This r ange can be i nstal l ed fl ush against ri ght and lef t base cabi nets, and rear ver ti c al w all .
RS2320006 Re v . 0 A 6 Range and Cabinet Dimensions Electrical Receptac le Location Locate electrical receptacle in area with diagonal lines. .
A7 RS2320006 R ev . 0 Important Safety Information SA VE THESE INSTR UCTIONS WARNING ! T o avoid risk of the appliance tipping, it must be secured by a properly installed anti-tip bracket. T o make sure bracket has been inst alled properly , remove the storage drawer or p anel and look under the range with a flashlight.
RS2320006 Re v . 0 A 8 This page intentionally left blank..
B1 RS2320006 R ev . 0 Appendix B.
RS2320006 Re v . 0 B 2 Care and Cleaning R emo ving Ov en Door 1. Fully open oven door . 2. Push hinge locks down toward door frame, to the unlocked position. This may require a flatblade screwdriver . 3. Firmly grasp both sides of top of oven door .
B3 RS2320006 R ev . 0 T o keep your smoothtop looking like new , Amana recommends routine cleaning. The following general instructions for routine and tough spot cleaning are based on the performance of Amana recommended product s. T o order these products, contact the Consumer Affairs dep artment at 800-843-0304.
RS2320006 Re v . 0 B 4 PROBLE M CAUSE REMOVAL Brown str eaks and specks Cleani ng with spon ge or cl oth c ontai ning soil ed deter gent water . Normal cl eansin g (provi ded above) . Blackened, burnt on spots Spatt ers or spi llov ers on a h ot cook ing ar ea or acci dental melt ing of plast ic l ike a bread bag.
B5 RS2320006 R ev . 0 Care and Cleaning Can I use liquid cleaners on my stainless steel? Just because a cleaner is a liquid does not mean it is non-abrasive. Many liquid cleansers designed to be gentle on tile and smooth surfaces still damage stainless steel.
RS2320006 Re v . 0 B 6 This page intentionally left blank..
C–1 RS2320006 Rev . 0 Appendix C.
Genesis Control Testing Information ! WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to oven before servicing, unless testing requires it.
Genesis Control Programming Instructions C − 3 RS2320006 Rev. 0 Setting Electronic Clock The 12 ho ur clock does not display AM , PM or military time. When power is connected or restored, display flashes until RECALL OVEN TEMP/CLOCK pad is pressed or temperature knob is turned.
Genesis Control Programming Instructions RS2320006 Rev. 0 C − 4 7. Oven will automatically begin to heat at selected start time. • OVEN ON light will turn on when oven begins t o heat. • To adjust cook time, press COOK/CLEAN TIME pad twice while the remaining cook time is displayed.
D–1 RS2320006 Rev . 0 Appendix D.
Sigma Control Testing Information ! WARNI NG To avoi d risk of electric al shoc k, per sonal inj ury or de ath; disc onnect p ower to o ven bef ore ser vicing, un less testing r equires it.
Sigma Control Testing Information ! WARNI NG To avoi d risk of electric al shoc k, per sonal inj ury or de ath; disc onnect p ower to o ven bef ore ser vicing, un less tes ting requires it. D 3 RS2320 006 Rev. 0 Illustra tion Comp onent Test Pro cedure Res ults ERC Controll ed Temperat ure adjust ment (BAKE mode onl y) Press BAKE pad.
Sigma Control Programming Instructions D 4 RS2320 006 Rev. 0 Setting Electronic Clock 12 hour c lock does not dis play AM , PM or m ilitar y tim e. W hen power is c onnected or restor ed, disp la y flashes until CLO CK or CA NCEL pad is pres sed. 1. Press CLOCK pad.
Sigma Control Programming Instructions RS2320006 Rev. 0 D 5 Delayed Baking Set oven t o begin a nd end b aking at a lat er tim e. Oven control automatic all y calculates starting t im e. 1. Place food in o ven. 2. Pres s STO P TIME butt on. • Default tim e displ ayed is current t ime of day.
デバイスAmana RS2320006の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Amana RS2320006をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAmana RS2320006の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Amana RS2320006の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Amana RS2320006で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Amana RS2320006を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAmana RS2320006の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Amana RS2320006に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAmana RS2320006デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
