HooverメーカーS3083-030の使用説明書/サービス説明書
ページ先へ移動 of 20
HOOVER Model Owner’s i Celebrity II TM .S3083-030 Manual j Cleaner &L.
Fill in and retain ! The vacuum cleaner you have just purchased is a combination cleaner. It has a motorized power nozzle for carpet and floor cleaning and has cleaning tools for above the floor cleaning. Your cleaner is a model . . . . . . . . . . . .
Importantsafeguards! l Read all instructions. l Warning: Electric shock could occur if used outdoors or on wet surfaces. l Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time.
14 A I 1. FURNITURE GUARD 2. COMBINATION CARPET AND FLOOR ‘POWERMATIC’ NOZZLE Powermatic nozzle automatically adjusts to different carpet pile height. Has setting for “Carpet” and “Bare Floor”. 3. SURFACE SELECTOR INDICATOR Shows “Carpet” or “Bare Floor” setting of Surface Selector Lever.
6. WALL/FLOOR BRUSH 7. HOSE CORD CONNECTION TO CLEANER Plug hose cord into cleaner base to receptacle. 8. CASTERS Provide easier towing; pull cleaner using hose to guide the cleaner easily over carpet, throw rugs, and door sills. 9. ON-OFF SWITCH A convenient switch is located near front of cleaner.
TO CONNECT AND REMOVE HOSE To connect hose, insert hose into opening of cleaner lining up the arrow on the hose with the dot on the cleaner. Turn the hose clockwise until it lines up with the bar on the cleaner and latch locks into place. When the hose is attached properly, the hose cord plug will reach to the receptacle on the cleaner.
HOW TO USE HANDLE ADJUSTMENTS The handle has two positions when used with the power nozzle: Storage and Low. Step on the Han- dle Adjustment Latch to lower the handle. Use the low position for reaching under low furniture. Raise the handle straight up for the storage position.
FOR HARD SURFACE FLOOR CLEANING The power nozzle can be used for cleaning hard sur- face floors such as wood, linoleum, vinyl, asphalt and rubber tile, sealed cork, concrete and terrazzo as well as carpet.
HOW TO USE THE ‘CELEBRITY II’ CLEANER WITH CLEANING TOOLS CLEANING TOOLS The cleaning tools have many uses. Select the tool best suited for the cleaning task from the descrip- tions below. Adjust the Suction Regulator to select the amount of suction appropriate to the cleaning task.
TO CLEAN HARD TO REACH AREAS Use the curved wand with the extension wands. The tools attached to the curved wand will enable you to clean many hard to reach areas; especially crown moldings, tops of drapery rods, shelves, and picture frames, etc. TO CLEAN STAIRS Clean stairs by placing the cleaner on its side as pictured in the illustration.
When To Replace Check bag from time to time. When the bag is filled with dirt, the cleaner will not operate effectively. Discard used bag. CAUTION: Very fine materials, such as face powder, cornstarch, fire- place ashes or fireplace soot, may seal the throw away bag and may cause it to burst even though it is only partially full of dirt.
HOW TO CLEAN SECONDARY FILTER DISCONNECT CLEANER FROM ELECTRICAL OUTLET BEFORE REMOVING FILTER The secondary filter is a foam disc located on top of the motor and protects the motor from dirt par- ticles. When the filter becomes dirty, either clean or replace it.
To provide space for grasping the agitator, remove end of hose from holder, Fig. 3. Then grip agitator and pull out. Fig. 4. Remove old belt. Place one end of the new belt around agitator pulley with smooth side of belt against the pulley.
Place a screwdriver under the belt as illus- trated. Fig. 8. 8 Bracing the end of the screwdriver against the end of the motor shaft, slide belt over end of shaft. Fig. 9. Remove screwdriver. Check to be sure belt is not twisted. 9 Rotate the agitator by hand to properly align the belt on the motor shaft.
NOZZLE HOSE The Nozzle Hose carries the dirt from the nozzle to the extension wand and to the throw away bag. If the hose becomes obstructed, cleaning effectiveness will sharply decrease. Remove bottom plate as de- scribed in preceding section, and slide end of hose out of the holder.
LOCATOR Remove brushes by pulling them from agitator with pliers. Slide new brushes into the channels - small ends first - pushing them in as far as possible. (Fig. 4). Replace end plate and shaft, lining up locator on end section with slot in agitator.
HOW TO REPLACE THE BOTTOM PLATE BRUSH Disconnect cleaner from electrical outlet and disconnect Powermatic nozzle from extension wand. 1 Put the Surface Selector Lever in the “Carpet” Position. This will allow for easier removal of the brush. Turn Power- matic nozzle over.
USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience.
LUBRICATION The motor is equipped with one ball bearing and one roller bearing. These bearings contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing.
VCMA VACUUM CLEANER MANUFACTURERS ASSOCIATION (HOOVER - AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned with product safety.
デバイスHoover S3083-030の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Hoover S3083-030をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHoover S3083-030の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Hoover S3083-030の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Hoover S3083-030で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Hoover S3083-030を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHoover S3083-030の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Hoover S3083-030に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHoover S3083-030デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
