HooverメーカーUH50000の使用説明書/サービス説明書
ページ先へ移動 of 19
Owner's Manual 0 pe roti n g o n d Se rvi ci n g I nstru cti ons www.hoover.com Please review this manual before operating your Hoover@ product. =z =2 =z =t l=t @2008 Healthy Gain lnvestments, Ltd.
Thank you for choosing Please enter the complete model and serial numbers in the spaces provided. Model a HOOVER' product. ff@,lffifiiklfliitlll, #Fffqlra"*.@" frnf.lm-ffi lrE IIilEL|h[t[ M mffi** I*r/FtEtIE l||fiffi|slEilil -rs!:* UXUXXINXX Serial Number Hint: Attach your sales receipt to this owner's manual.
lmportant Safety lnstructions When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNINGI To reduce the risk of fire, electric shock, or injury: o Do not use outdoors or on wet surfaces.
1. Assembling cleaner This cleaner was inspected and packaged carefully before being shipped from the factory. lf you should happen to need assistance during assenrbly or operation, call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.
STEP ll Attach hose Align end of hose with projection (E) over slots (F) in dirt duct on back of handle. NOTE: Hose must be connected as shown for all operations. Slide hose into (F) and twist hose to lock it into place. Position hose over rack and into hose tube (G).
2. How to use Cleaner description Operate cleaner only at voltage specified on data plate on bottom of cleaner. The assembled cleaner will look like the drawing. l. Handle 2. Self-propel button 3. 0N-0FF switch 4. Hose 5. Tool cover 6. Powered hand tool 7.
ON-OFF Switch Plug cord into elec- trical outlet. To turn cleaner 0N, push switch up. To turn cleaner 0FF, push switch down. Note: To reduce the risk of electric shock, this appli- ance has a polarized plug Ione blade is wider than the other). This plug will fit in a polar- ized outlet only one way.
(Fig. 2.7 Continued) When the red light is on, you should take additional cleaning strokes in the area until it changes to green. o The red light may seldom come on during cleaning. This means that your cleaner is picking up primarily fine surface dust and lint which the system may not detect, or that the carpet is generally clean.
tool cover How to attach The tool cover is designed with a "break-away" feature which al- lows it to snap free if it is pushed open too far. To reattach, align hinges of cover with slots on sides of tool storage area. Push cover down to secure in place.
Sta ir Cleaning Use the hose and powered hand tool or furniture nozzle for stair cleaning. CAUTION: To prevent the cleaner from falling, always place it at the bot- tom of the stairs.
Where to buy Filter bags may be purchased from Au- thorized Hoover Dealers (Depot), Leading Retailers, from Hoover Factory Service Centers, or through Hoover lnc., on-line at www.hoover.com. What to buy To assure cleaning effectiveness, use only HOOVER@ Allergen Filtration Media Type Y Disposable Filter Bags.
Replacing final The final filter assists in the filtration process to return clean air to the room. The 3 layer filter (some models) can be washed in the sarne manner as the secondary filter and reused. To remove final filter, first open the door on the side of the cleaner (Fig.
Belt replacement The belts are located under the bottorn plate of the cleaner and should be checked from time to time to be sure thev are in rrood condition. The flat (wide) belt is described below; tlre other is described under "Brush roll replacement".
Replacing brush roll Removing brush roll Slide Brush Roll Control (Fig. 2-9) to "Hard" (0FF) position. Turn cleaner over and remove bottom plate (Fig. 3-e). Lift up brush roll and slide V-belt (D) off brush roll. Inspecting V-belt The V-belt is designed to last for a long time and is not normally replaced.
Q,,{----,,---g 3. Remove agitator including end plates (C) and discard. 4. lnspect belt to ensure that it is in good condition. lf belt is cracked, gouged or broken, replace it (see fol- lowing section). 5. lnsert brush roll through belt and position belt over gear teeth (D) on brush roll.
Edge groomer replacement When to replace The edge groomers, located on both sides of the front of the cleaner, should be replaced when they appear worn. What to buy When purchasing edge groomers, ask for HOOVER part No. 3941 1 01 B. Replacing edge groomers Disconnect cleaner from electrical outlet.
4. Trouble Shooting lf a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION Cleaner won't .
Checking under bottom plate 5. Remove bottom plate ( Fig. 3-e) and brush roll (Fig. 3-r 5). Look into opening (F), in channnels (G) and around lin- er (H), and remove any accumulated debris. lf blockage occurs hand tool use 1. Disconnect powered hand tool from hose.
Parts and Accessories MAIL ORDER FORM Detach this sectiorr arrd mail to: Hoover, lnc. 7005 Cochrarr Road o Clenwillow 0hio o 44119 Attrr: Sales tt Service Cerrtcr Item Description Part No. Qty/ Pk. Price/Pk. atv. Total Allergen Filtration Type Y Disposable Filter Bags 40 1 01 00Y 3 $ 9.
デバイスHoover UH50000の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Hoover UH50000をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはHoover UH50000の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Hoover UH50000の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Hoover UH50000で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Hoover UH50000を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はHoover UH50000の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Hoover UH50000に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちHoover UH50000デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。