

Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.
2-3/8" [60mm] MAXIMUM WARE THICKNESS 17mm] 1/16" PIN LENGTH 3/8"[10mm] 1/4" DIA. [6mm]

Plumbers' Putty or Caulking
For vandal resistant fitting only, a pin hole will be need to be drilled into the deck offset from the mounting shank hole. Note: For vandal resistant models it is important to obtain the rough-in drawing for the particular model. The drawing illustrates exact size and positioning of the offset hole. Drill a 5/16" [8mm] dia. hole 1/2" [13mm] deep in mounting surface, per roughing-in dimensions for vandal resistant pin.
Apply putty to underside of turret body to assure a good seal and level fit.
If installing a vandal resistant fitting, align pin with pin hole in mounting surface.
Place body shank through hole in deck and assemble steel washer and lock nut. Tighten securely.
Pipe to correct service to complete installation.
After installation is complete turn service on and check all connections for leaks.
BODY
PUTTY
VANDAL RESISTANT PIN ON VANDAL RESISTANT FITTINGS ONLY
M962323-0070A 3/8" NPT X 4-3/4" INLET SHANK WITH LOCKNUT & WASHER
STEEL WASHER
LOCK NUT
HOTLINE FOR HELP For toll-free information and answers to your questions, call:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
Weekdays 8:00 to 7:00 p.m. Eastern Time
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE. M968486
Product names listed herein are trademarks of American Standard Inc. © A m e r i c a n S t a n d a r d I n c . 2 0 0 4


M962323-0070A 3/8" NPT X 4-3/4" INLET SHANK WITH LOCKNUT & WASHER
M962323-0070A 3/8" NPT X 4-3/4" INLET SHANK WITH LOCKNUT & WASHER
ユーザーまたはスタッフが通常1日以内に回答します。あなたの質問が次の人の助けにもなります。
最初の質問を投稿しましょう。他のユーザーや当チームが回答します。