IBMメーカーAC453Aの使用説明書/サービス説明書
ページ先へ移動 of 21
CUSTOMER SUPPORT INFORMATION Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mail order: Black Box Corporation , 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.
2 COMPUTER TOP TV-III FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT This equipment generates, uses, and can radiate radio frequency energy and if not installed an used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio communication.
3 Contents 1. SPECIFICATIONS ...............................................................................................4 2. INTRODUCTION ...............................................................................................5 3. INSTALLATION .
4 COMPUTER TOP TV-III System Bus — IBM AT or compatible 286/386/486, 8 or 16-bit slot System Requirements — DOS 3.1 or higher, Microsoft Windows 3.1 Monitor — VGA Amplifier Power — 4 watts (2 watts/channel max.) TV Channels — 122 channels covering broadcast and cable VHF and UHF channels.
5 CHAPTER 2: Introduction The Computertop TV-III card is a full-motion video display card with a television tuner and audio- processing circuitry. It allows a live video window from cable or broadcast television to be merged with VGA graphics on a single display monitor.
6 COMPUTER TOP TV-III Use the hardware installation guide that came with your system to find specifics related to your PC. W ARNING Static discharge can damage sensitive electronic com- ponents on your Com- putertop TV-III card and in your PC.
7 9. Plugthe terminating “dummy plug” into the external connector of the VGA card to which the monitor cable was previously attached. 10. Attach the supplied mini-DIN cable to the Computertop TV-III board. The yellow jack is for composite video input.
8 COMPUTER TOP TV-III 2. Setup and installation of the Computertop TV-III software must be done at the DOS command level. Before attempting to install the Computertop TV-III software, you must exit Microsoft Windows. Do not exit Microsoft Windows by using the DOS icon.
9 CHAPTER 4: Operation This chapter describes the menu items supported by Computertop TV-III Board. 4.1 Find/Hide Remote Find/Hide Remote hides or redisplays the remote control window. 4.2 Clear Clear clears the whole video buffer to black. 4.3 Show Always Show Always can be set to on or off.
10 COMPUTER TOP TV-III 4.4.2 C ONTRAST Changes in the contrast are reflected with a row of vertical bars at the bottom left corner of the TV screen. The word Contrast is displayed above the row of bars. The contrast can be adjusted three ways: a. Use the contrast button on the remote.
11 4.4.5 R ED L EVEL Changes in the red level of the video are reflected with a row of vertical bars at the bottom left corner of the TV screen. The word Red is displayed above the row of bars. The red level can be adjusted two ways: a. Use the Red button on the remote.
12 COMPUTER TOP TV-III 4.5 Broadcast Broadcast gives you the following options: a. USA Broadcast b. USA Cable c. Japan These are the only standards that can be handled with an NTSC tuner. 4.6 Audio This brings up the Audio dialog box to control the following audio settings: a.
13 4.6.3 B ASS Changes in the bass level of the audio are reflected with a row of vertical bars at the bottom left corner of the TV screen. The word Bass is displayed above the row of bars. The bass level can be adjusted three ways: a. Use the Bass button on the remote.
14 COMPUTER TOP TV-III 4.8 Video Align This brings up a Video Align dialog box that lets you reposition the video window to match the VGA display screen. These adjustments should be performed using the “Screen “ TV style (set the style using TV Style in the Configure menu).
15 4.8.3 V IDEO P OSITION A DJUSTMENTS First set Video Position Horizontal and Vertical slide bars to the far left of their range. Next adjust the Shift Clock Adjust control as described below.
16 COMPUTER TOP TV-III For channels requiring only one digit, a short delay confirms that the whole channel number has been entered. If you don’t enter a second digit before a certain amount of time, the channel is set using just the single digit.
17 4.13 Selecting the Audio Source There are three audio sources that can be selected: • The tuner • An external source from a laser disk or VCR • An internal source, which could be a sound board or CD-ROM drive The tuner source is selected by default.
18 COMPUTER TOP TV-III 4.14 Selecting the Video Source The Computertop TV-III card has two video sources, the tuner and an external video source such as a laser disk player or a VCR. You can select the two video sources as follows: a. Use the TV/Video button on the remote.
19 4.16 Still Image Display Still images can be loaded when the standard Windows interface or screen is selected. To load an image, select the Load option from the Display menu. The dialog box displays two list boxes, one to select the directory or disk drive, the other to display image files available in the current directory.
20 COMPUTER TOP TV-III 4.20 Select The User Interface The Set TV style option in the floating menu or the Configure menu of the menu bar selects the TV interface. When the TV style is set to Cabinet or Screen only, choices are made through the remote, the keyboard, or the floating menu.
1000 Park Drive • Lawrence, PA 15055-1018 • 724-746-5500 • Fax 724-746-0746 © Copyright 1993. Black Box Corporation. All rights reserved..
デバイスIBM AC453Aの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
IBM AC453Aをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはIBM AC453Aの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。IBM AC453Aの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。IBM AC453Aで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
IBM AC453Aを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はIBM AC453Aの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、IBM AC453Aに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちIBM AC453Aデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。