JVCメーカーCOLOUR TELEVISON AV-29LS24の使用説明書/サービス説明書
ページ先へ移動 of 24
INSTRUCTIONS GGT0045-001B-H A V -29LS24 A V -21CS24 A V -29LX14 A V -21CX14 A V -29VS24 A V -21DX14 A V -29VX54 A V -21LX14 A V -29VX74 A V -21VS24 A V -29WX14 A V -21VX14 A V -29WX24 A V -21VX54 A V -25LS24 A V -21VX74 A V -25LX14 A V -21WS24 A V -25VS24 A V -21WX14 A V -25VX54 A V -21YX14 A V -25VX74 Contents Knowing your TV’ s features .
2 15 cm 10 cm 10 cm 15 cm W ARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO ENSURE PERSONAL SAFETY , OBSERVE THE FOLLOWING RULES REGARDING THE USE OF THIS TV . 1 Operate only from the power source indicated on the rear of the TV .
3 Knowing your TV’ s features 5 1 2 4 3 6 Confirm your TV’ s functions Some functions written in this instruction manual may not be available for your TV . Please see the chart below and check the functions that are equipped for your TV ’ s model number .
4 Remote control buttons and basic functions 8 2 ! 4 1 6 3 7 9 5 No. Press T o POWER T urn on or off the TV from standby mode. MENU/OK Display menu and confirm selected function. 5 / ∞ / 2 / 3 Select and adjust menu function. CHANNEL -/+ Select the desired channel number .
5 Remote control buttons and basic functions (continued) The following chart shows locations of functions in menus. In this manual, location of a function is described as follows: Note: Some functions have the 4th menus as the sub-menus.
6 TV buttons and functions The illustrations shown below is for A V -29VS24 and A V -21CS24 only , which are used for explanation purpose. Y our TV may not look exactly the same as illustrated.
7 V L R R L / MONO Y C B C R / V V S OVER L R / MONO OUTPUT VIDEO-1 INPUT To RF output To video output To S-video output To aerial input To audio output COMPONENT (VIDEO-2) INPUT Setting up your TV CAUTION • T urn off the equipment including the TV before connecting.
8 5 Making the initial settings Set up your TV by pressing any button except POWER button, then operate the TV menu by following the steps as below: • Press 5 / ∞ button to select your desired language, then press MENU/OK button. • Press 5 / ∞ button to select your desired T eletext language group.
9 COLOUR SYSTEM Y ou can select the appropriate colour system when the picture is not clear or no colour appears. Press the COLOUR SYSTEM button to select a setting. T o operate this function with a menu: For the colour system in each country or region, see the table below: PICTURE MODE Y ou can choose the desired picture setting with one-touch.
10 Adjusting the picture – USER Y ou can adjust the desired picture setting when selecting USER in PICTURE MODE. 1 Select the USER in PICTURE MODE under PICTURE menu.
11 AI ECO SENSOR (ECO) Y ou can adjust TV screen contrast according to the brightness of your room. Press the ECO button to select the desired mode. 1 Mild contrast (recommended). 2 Even contrast. OFF Cancel the function. T o operate this function with a menu: Y ou can display the graphic of AI ECO SENSOR on the screen.
12 PIP Y ou can display a sub picture on the screen. Press the PIP operation buttons to display and change the sub picture setting. PIP Display the sub picture. T o cancel, press the PIP button again. Notes: • Y ou can hear the sound from the main picture only .
13 Original features for picture (continued) Using the List mode Y ou can store and recall the favorite teletext pages in memory using the colour buttons. 1 In TEXT mode, press the MODE button to enter the List mode. 2 Press a colour button, then press the number buttons to enter the page number .
14 SOUND SYSTEM Y ou can select an appropriate sound system when abnormal sound occurs even when the picture appears normally . Press the SOUND SYSTEM button to select a setting.
15 CINEMA SURROUND Y ou can enjoy an enhanced sound for wider audience. Press the CINEMA SURROUND button to select a setting. OFF Cancel the function. LOW Listen to sound with less wider audience effect. HIGH Listen to sound with more wider audience effect.
16 T o r egister the favorite channel Y ou can register and recall 4 favorite channels by using the colour buttons (red, green, yellow , blue). 1 In TV mode, select a TV channel (PR01-99) you desired to register . 2 Press and hold a colour button for 3 seconds or more.
17 VNR Y ou can reduce the noise. Select the VNR in the PICTURE FEA TURES menu under PICTURE menu, then choose a setting of VNR function. OFF VNR is turned off. AUTO Effect of VNR is automatically controlled. MIN Effect of VNR becomes minimum level. MAX Effect of VNR becomes maximum level.
18 AUTO SHUTOFF Y ou can set the TV to turn off automatically when no signal is received for about 15 minutes or longer after the end of a broadcast. Select AUT O SHUTOFF in INST ALL menu, then choose ON or OFF . The AUTO SHUTOFF function does not turn of f the TV ’ s main power .
19 T o register the TV channels automatically Y ou can register the TV channels into the TV ’ s channel list automatically . 1 Display the INST ALL menu. 2 Choose AUT O PROGRAM, then press the MENU/OK button. AUTO PROGRAM function starts, and the channels received are registered in the channel list (PR LIST ) automaticall y .
20 T o add in the new channel (INSERT in the EDIT menu) Y ou can add in the new channel in the TV channel list as you like. Y ou need to find the “ CH/CC ” number for the TV channel. Find the “ CH/CC ” number corresponding to the channel number of the TV channel from the attached sheet “ CH/CC number list ” on page 21.
21 TV channel presetting (continued) CH/CC number When you want to use the INSERT function on page 20, find the CH/CC number corresponding to the channel number of the TV channel from this table. Channel No. Country US United States, Philippines, etc.
22 V L R V L R / MONO OUTPUT VIDEO-1 INPUT V L R R L / MONO Y C B C R / V V S OVER L R / MONO OUTPUT VIDEO-1 INPUT COMPONENT (VIDEO-2) INPUT The illustrations shown in this section are for A V -29VS24 and A V -21CS24 only , which are used for explanation purpose.
23 T roubleshooting If a problem occurs when you are using the TV , check the below troubleshooting guide before calling for repair . • Deactivate the BLUE BACK function if it is turned on. • Choose the appropriate sound system. Refer to “ SOUND SYSTEM ” on page 14.
VICTOR COMPANY OF JAPAN, LIMITED © 2004 VICTOR COMP ANY OF JAP AN, LIMITED 0304-FLE-JMT Specifications TV RF systems B, G, I, D, K, M Colour systems P AL, SECAM, NTSC 3.58 MHz, NTSC 4.43 MHz Receiving channels VHF low channel (VL), VHF high channel (VH), UHF channel (U) Receives cable channels in mid band, super band and hyper band.
デバイスJVC COLOUR TELEVISON AV-29LS24の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
JVC COLOUR TELEVISON AV-29LS24をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJVC COLOUR TELEVISON AV-29LS24の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。JVC COLOUR TELEVISON AV-29LS24の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。JVC COLOUR TELEVISON AV-29LS24で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
JVC COLOUR TELEVISON AV-29LS24を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJVC COLOUR TELEVISON AV-29LS24の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、JVC COLOUR TELEVISON AV-29LS24に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJVC COLOUR TELEVISON AV-29LS24デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。