JVCメーカーSP-HXC6の使用説明書/サービス説明書
ページ先へ移動 of 28
COMPACT COMPONENT SYSTEM HX-C6 —Consists of CA-HXC6 and SP-HXC6 INSTRUCTIONS For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear , bottom or side of the cabinet. Retain this information for future reference.
G-1 Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION To reduce the risk of electrical shocks, fire, etc.: 1 Do not remove screws, covers or cabinet. 2 Do not expose this appliance to rain or moisture. ATTENTION Afin d’éviter tout risque d’électrocution, d’incendie, etc.
G-2 IMPORTANT FOR LASER PRODUCTS 1 CLASS 1 LASER PRODUCT 2 CAUTION : Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel. 3 CAUTION : Visible and invisible laser radiation when open and interlock failed or defeated.
1 Introduction Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to prevent internal heat buildup in the System.
2 Contents Introduction .................................................................. 1 Precautions ...................................................................................... 1 How to Read This Manual .................................
3 Getting Started Step 1 : Unpack After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately.
4 Step 3 : Hook Up If you need more detailed information, see page 5. Illustrations of the input/output terminals below are typical examples. When you connect other components, refer also to their manuals since the terminal names actually printed on the rear vary among the components.
5 To connect the AM loop antenna cords • Connect black cord to the H terminal, and the while cord to the other terminal. • If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.
6 Before Operating the System Parts Index Refer to the pages to see how to use the buttons and controls. Main unit Remote control 8, 13 12 Remote sensor 5 11 8, 12 8, 9 7 10 10, 14, 16, 17 8, 19 8, 10.
7 The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. *1 At the playback beginning, the file name will be shown for a while after the track number and elapsed playing time.
8 Daily Operations —Playback ¥ Turn on the power. The standby lamp on the main unit goes off. • Without pressing STANDBY/ON , the System also turns on by pressing one of the source select button in step ø . ø Select the source. Playback automatically starts if the selected source is ready to start.
9 Listening to the Radio To select the band (FM/AM) To tune in to a station While FM or AM is selected... When a station (frequency) with sufficient signal strength is tuned in, the frequency search stops. To stop searching manually, press either button.
10 Playing Back a Disc This System can play back the following discs—regular CD and CD-R/RW (recorded in the audio CD format and in the ISO 9660 format for MP3 files). To insert discs To close the disc tray, push up the same control ( 0 ) again. If you push down the same control ( 3 ), the disc tray closes automatically and playback starts.
11 To select a track • See the right column for an MP3 disc. While playing a disc... To locate a particular portion While playing a disc, press and hold the button until the portion you want is reached. To select a track directly To select MP3 playback mode Before playback or while playing an MP3 disc.
12 Playing Back from the PC This System is equipped with a USB terminal on the front panel. You can connect your PC to this terminal and enjoy sound reproduced through your PC. When you connect your PC for the first time, follow the procedure below. • Remember you cannot send any signal or data to your PC from this System.
13 Daily Operations —Sound and Other Adjustments Adjusting the Volume The volume level can be adjusted in 32 steps (VOL MIN, VOL 1 – VOL 30, and VOL MAX). To drop the volume in a moment To restore the volume, press the button again, or adjust the volume level.
14 Selecting the Sound Modes You can select one of the preset Sound Modes. Selecting the Surround Modes You can select one of the Surround Modes to create being- there feeling in your room. Turning On or Off the Key-Touch Tone Setting the Clock Without setting the built-in clock, you cannot use Daily Timer (see page 18).
15 Advanced Disc Operations Programming the Playing Order —Program Play You can arrange the playing order of the tracks (up to 32 tracks) before you start playback. • Program Play cannot be used for MP3 discs. 1 Before starting playback, activate Program Play.
16 To check the programmed contents While the PROGRAM indicator lights on the display and before playback... To modify the program While the PROGRAM indicator lights on the display and before playback... Playing at Random—Random Play You can play the contents of the current disc at random.
17 Repeating Playback—Repeat Play You can repeat playback. • Repeat Play and Random Play cannot be used at the same time. Before playback or while playing... • “REPEAT 1 DISC” cannot be selected for Program Play. It is also canceled when you select Program Play.
18 Timer Operations Turning Off the Power Automatically With Sleep Timer, you can fall asleep to music. While the System is turned on... To check the time remaining until the shut-off time Setting the Daily Timer Using Daily Timer, you can wake up with your favorite song.
19 2 Set the hour then minute for on-time. 3 Set the hour then minute for off-time. 4 Select the playback source—“TUNER FM,” “TUNER AM,” “CD,” “AUX,” or “USB.” 1 Select a preset station for “TUNER FM” and “TUNER AM.” 2 Select the volume level.
20 Additional Information Learning More about This System Daily Operations—Playback (see pages 8 to 12) Listening to the Radio: • When you repeatedly press ¡ / 1 , the frequency changes step by step. • If you store a new station into an occupied preset number, the previously stored station in that number will be erased.
21 Maintenance To get the best performance of the System, keep your discs clean. Handling discs • Remove the disc from its case by holding it at the edge while pressing the center hole lightly. • Do not touch the shiny surface of the disc, or bend the disc.
22 Specifications Amplifier section—CA-HXC6 Output Power: SUB WOOFER: 170 W per channel, min. RMS, driven into 6 Ω at 63 Hz with no more than 10% total harmonic distortion. MAIN SPEAKER: 80 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion.
00-00_Wrranty[J]-f.fm Page 1 Monday, March 7, 2005 3:35 PM.
00-00_Wrranty[J]-f.fm Page 2 Monday, March 7, 2005 3:35 PM.
0305TMMMDWSAM EN © 2005 Victor Company of Japan, Limited HX-C6 COMPACT COMPONENT SYSTEM 00-00_Cover[J]-f.fm Page 2 Monday, March 7, 2005 2:57 PM.
デバイスJVC SP-HXC6の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
JVC SP-HXC6をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはJVC SP-HXC6の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。JVC SP-HXC6の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。JVC SP-HXC6で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
JVC SP-HXC6を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はJVC SP-HXC6の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、JVC SP-HXC6に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちJVC SP-HXC6デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
