Kenmoreメーカー116.30912の使用説明書/サービス説明書
ページ先へ移動 of 20
116.30912 116.31912 116.31913 Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com C01ZBAZ30U_0-8175058.
Before Using Your New Vacuum ........ 2 Kenmore Vacuum Cleaner Warranty ,, • 2 Important Safety Instructions ............ 3 Upright Vacuum Cleaner Parts and Features ................................ 4 Assembly Instructions ................. 5-6 Operating Instructions .
WARNING Your safety is important to us, To reduce the risk of fire, electrical shock, injury to persons or damage when using your vacuum cleaner, follow basic safety pre= cautions including the following; Read this manual before assembling or using your vacuum cleaner.
It is important to know your vacuum cleaner's parts and features to assure its proper and safe use° Review these before using your cleaner. Item Part No.
WARNING Electrical Shock Hazard Do not plug Into the electrical sup- ply until the assembly is complete,, Failure to do so could result in elec- trical shock or injury° i i ii iNil,,,ll ii Before assembling vacuum, check the PACKING LIST on the cover of the separate Repair Parts List.
Using a screwdriver, tighten the screw. Do not overtighten. Overtightening could strip the screw holes. Do not operate the cleaner without the screw in place, CORD ASSEMBLY Make sure the quick release upper cord hook is in the upright position,, Remove the wire tie from the power cord.
Release the handle by pressing down on the handle release pedal with your foot and pulling back and down on the handle with your hand. Note: The agitator will not rotate if the vacu- um cleaner is in the upright position.
OFF Position: Step on the back half of the pedal to turn off the agitator for use on bare floors.. In the OFF position, the agitator does not rotate_This setting should be used for cleaning hardwood and tile floors Note: The light will remain on when vacu- uming with the agitator in the OFF Position, provided the vacuum is not fully upright.
The attached hose swivels to make cleaning swivel- easier in every direction. Remove the Hose hose from the clip hose clip by pulling straight out, TELESCOPING WAND WITH SUCTION CONTROL SLIDE SOME MOD.
TO STORE ATTACHMENTS Remove dusting brush or combination brush, Snap into appropriate storage loca- tion, Remove crevice tool from the wand by twist- ing.
CLEANING AREA ATTACHMENT DUSTING BRUSH CREVICE TOOL S CC IINATION BRUSH Hanc -Mate ® Jr. Furniture* Between Cushions* Drapes* x X x x X x X x Stairs *Always clean attachments before using on fabrics Walls X Pivoting Brushes Carpet edges Guide either side or the front of the noz- zle along a base- board.
MOTOR PROTECTION SYSTEM Motor Protector This vacuum has a motor protector by-pass valve which automatically opens to provide cooling air to the suction motor when a clog prevents the normal flow of air to the motor.
DIRT SENSOR SOME MODELS The electronic dirt sensor is a feature which will detect particles as they pass through the vacuum cleaner. The dirt sensor indicators and sensor sensitivity switch are located on the front of the switch cover A red light indicates dirt is being picked up by the cleaner.
Always follow all safety precautions when cieaning and servicing the vacuum cleaner. WARNING Electrical Shock And Personal injury Hazard Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in elec- trical shock or personal injury from cleaner suddenly starting.
TO REMOVE DUST BAG TO REPLACE DUST BAG Pull out on the bag cover release located near the top of the bag cover, Grasp the dust bag collar and pull gently, carefully removing the dust bag° Throw away the used dust bag. Do not reuse. Pull the bag cover forward and lift up.
Check motor safety filter frequently and change when dirty WARNING Electrical Shock Hazard Unplug power cord from electrical outlet. Do not operate the cleaner without the motor safety filter. Be sure the filter is dry and properly installed to prevent motor failure and/or electrical shock.
WARNING Electrical Shock Or Personal Injury Hazard Disconnect electrical supply before servicing or cleaning the uniL Failure to do so could result in elec- trical shock or personal injury from cleaner suddenly starting. ii ii ii iiiii i TO REMOVE LIGHT BULB Disconnect power cord from electrical out- let.
Always follow all safety precautions when cleaning and servicing the vacuum cleaner_, ! WARNING .............. Electrical Shock Or Personal Injury Hazard Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in elec- trical shock or personal injury from cleaner suddenly starting.
Review this chart to find do.it-yourself solutions for minor performance problems, Any serv}ce needed, other than those described in this owner's manual, should be performed by an autho- rized service representative, .............................
For repair of major brand appliances in your own home... no matter who made it, no matter who sold it! 1-800-4-MY-HOME ® Anytime, day or night (1-800-469-4663) (USA° and Canada) www.sears.com www.sears.ca For repair of carry-in products like vacuums, lawn equipment, and electronics, call for the nearest Sears Parts and Repair Center.
デバイスKenmore 116.30912の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Kenmore 116.30912をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはKenmore 116.30912の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Kenmore 116.30912の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Kenmore 116.30912で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Kenmore 116.30912を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はKenmore 116.30912の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Kenmore 116.30912に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちKenmore 116.30912デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。