KodakメーカーKC50/55の使用説明書/サービス説明書
ページ先へ移動 of 29
1 KC50/55 Camera.
2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
3 Auto Getting to Know Y our Camera 6 9 1 2 3 4 6 7 8 9 10 11 5.
4 O N U F O ! K s es I L M 12 13 14 15 16 17 18 19 20 21 22 23 24.
5 Contents Need Help with Y our Camera? .................................................. 6 Camera Identification ................................................................ 7 Specifications ......................................................
6 Need Help with Y our Camera? Call: Kodak (USA only) toll free from 9:00 a.m. to 7:00 p.m. (Eastern time) Monday through Friday at 1 (800) 242-2424. Kodak (Canada only) from 8:30 a.m. to 5:00 p.m. (Eastern time) Monday through Friday at 1 (800) 465-6325, ext.
7 1 Shutter Button 2 Flash Sensor 3 Picture Counter 4 V iewfinder 5 Flash 6 Red-Eye-Reduction Lamp 7 Flash Switch 8 Lens 9 Len-Cover Switch 10 Camera Strap 11 Auto-Focus W indows 12 Film Spindle 13 V .
8 T ype: Compact 35 mm auto-focus camera Lens: 29 mm, 3-element hybrid V iewfinder: Reverse-Galilean Aperture: f /5.6 Focus Range: Daylight: 4 ft. (1.2 m) to infinity Flash Unit: Electronic flash with ISO 100/21 ° , guide number of 7.
9 This camera uses 2 AA-size alkaline batteries. Loading the Batteries Low-Battery W arning It’ s time to replace the batteries when— • the flash- /camera-ready light takes more than 30 seconds to turn on. • the camera motor slows down or will not run.
10 If in sunlight, turn your back to the sun and load the film in the shade of your body . 1. Slide the FILM-DOOR LA TCH 23 down; then open the FILM DOOR 17 . Loading the Film 2. Insert the film into the FILM CHAMBER 22 . Place the flat, recessed end of the film over the FILM SPINDLE 12 .
11 FILM LOAD MARK FILM-GUIDE RAILS 3. Pull out just enough film to place the end of the film at the FILM-LOAD MARK 18 . (Be sure the end of the film is at the film-load mark or you may not get any pictures). If the end of the film extends past the film-load mark, gently push the excess back into the film cartridge.
12 Auto 5. Slide the LENS-COVER SWITCH 9 to uncover the LENS 8 and turn the camera on. 4. Snap the film door closed. Y ou should be able to read the film information in the FILM WINDOW 16 . CAUTION: Do not open the film door if you have film loaded in the camera.
13 NOTE: Because of limited space on the picture counter, dots stand for frames 2 and 3. Beginning at frame 4, only even numbers show. 6. Press the SHUTTER BUTT ON 1 three times so that the PICTURE COUNTER 3 moves to “1.
14 3. Look through the VIEWFINDER EYEPIECE 13 to see your subject. VIEWFINDER Auto 1. Slide the LENS-COVER SWITCH 9 open until it locks into place. The camera will not work if the lens cover is not completely open. 2. For a sharp picture, be at least 4 ft (1.
15 4. Hold the camera steady and gently press the SHUTTER BUTT ON 1 to take a picture. W ait for the FLASH- /CAMERA-READY LIGHT 14 to turn “on” before you take the picture. The flash automatically fires when you take a picture (see T AKING FLASH PICTURES ).
16 Using the Focus Lock This camera automatically focuses on whatever is within the auto-focus frame of the veiwfinder eyepiece. If you want to take a picture with the subject positioned outside of the auto-focus frame, use the focus lock as follow: 1.
17 3. While still partially depressing the shutter button move the camera until your subject is where you want it. VIEWFINDER AUTO-FOCUS BRACKETS 4. Press the shutter button completely down to take the picture.
18 In dim light, such as indoors or outdoors in heavy shade, or on dark overcast days, you need flash. Y our camera features an automatic flash that fires when you need it. T aking Flash Pictures ISO Film Speed Flash-to-Subject Distance 100 4 to 9 ft (1.
19 Auto Using Fill Flash and Flash Off Fill Flash— Bright light indoors or outdoors from backlit subjects can create dark shadows (especially on faces) in contrasty scenes.
20 Using Red-Eye-Reduction T o minimize red-eye in flash pictures of people, use the red- eye-reduction feature. Whenever the flash is needed, the red-eye-reduction will automatically be active. 1. Partially depress the SHUTTER BUTTON 1 . The RED-EYE- REDUCTION LAMP 6 stays on as long as the shutter button is partially depressed.
21 After you take the last picture on the roll of film, slide the FILM-REWIND SWITCH 21 into position to start the film rewind. Y ou may get a few extra pictures on a roll (26 instead of 24, etc.). W ait for the camera motor to stop before you open the FILM DOOR 17 and remove the film cartridge.
22 T roubleshooting What happened Probable cause Solution Camera will Lens cover closed Slide the lens-cover not operate switch to uncover lens and turn on camera Batteries weak, Replace or reload the.
23 What happened Probable cause Solution Picture counter Film door opened Close film door and returns to “S” rewind film to avoid losing additional pictures Film does Batteries weak, Replace or re.
24 What happened Probable cause Solution Film does Film did not See Loading the Film not rewind load properly Batteries weak, Replace or reload the dead, missing, or batteries; see Loading improperly .
25 For Owners of the Quartz Date Back Model Setting the Date and T ime The date and time feature enables you to record the date in a choice of four formats: (month/day/year , day/month/ year , year/month/day) or time (day/hour/minute) directly onto the film.
26 Mode Selection Use the Mode Button (b) to change the data display as shown. M M M Setting Data 1. Press the Mode Button (b) to select the desired data type.
27 In time mode, pressing the select button successively causes the hour , minute, and then the colon to blink. 3. Press the Set Button (d) to change the blinking display . M SELECT MODE SET Replacing the Date Back Battery 1. Open the film door . Remove the screw from the battery cover using a small screw driver .
28 2. Remove the battery cover and insert a new 3-volt lithium CR 2025 (+ side up) battery . 3. Replace the battery cover and reattach the screw . Reset the date and time. Date back subject to minor appearance and specification changes. Kodak is a trademark.
29 Consumer Imaging EASTMAN KODAK COMP ANY Rochester , NY 14650 Pt. No. 916 5101 1-97 Printed in USA.
デバイスKodak KC50/55の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Kodak KC50/55をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはKodak KC50/55の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Kodak KC50/55の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Kodak KC50/55で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Kodak KC50/55を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はKodak KC50/55の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Kodak KC50/55に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちKodak KC50/55デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
