La Crosse TechnologyメーカーWS-7025Uの使用説明書/サービス説明書
ページ先へ移動 of 25
WS-7025U Wireless 433 MHz Radio-controlled Weather Station Instruction Manual.
2.
3 Topic Page Inventory of Contents/Additional Equipment 4 About WWVB 4-5 Quick Set-Up Guide 5 Detailed Set-Up Guide Battery Installation 5-6 Program Mode Function Keys 7 12/24 Hour Time Setting 7 Time.
4 INVENTORY OF CONTENTS 1. The Weather Station (Figure 1). 2. One TX3U Remote Control Sender with mounting bracket (Figure 2). 3. Three each, ½” Philips screws. 4. One strip double-sided adhesive t ape. 5. Instruction Manual and Warranty Card. ADDITIONAL EQUIPMENT (not included) 1.
5 continually measuring every second, of every day, to an accuracy of ten billionths of a second per day. These physicists have created an internati onal standard measuring a second as 9,192,631,770 vibrations of a Cesium -133 atom in a vacuum . QUICK SET-UP GUIDE 1.
6 to fall away from the unit. Place the screw partially back into its hole and an gle it slightly—so the thread s grab the battery cover. With the screw , pull the battery cover o ff. 3. Observing the correct polarity install 2 AAA batteri es. The batteries will fit tightly (to av oid start-up problems make sure they do not spring free).
7 PROGRAM MODE Programming Note: If 30 seconds are allowed to pass or ei ther the IN or the OUT bu tton is pressed durin g programmin g modes, the unit will set the last information entere d—the display will stop flashing and return to normal time-date readings.
8 the top of the TIME LCD . Observe the chart b elow, showing the corresponding abbreviations, t ime zones, and codes. TIME ZONES GMT 0 Atlantic -4 EST; Eastern -5 CST; Central -6 MST; Mountain -7 PST.
9 V. TIME There are two methods by whi ch the time can be set : A) Automatically via WWVB reception or B) Manually. A. WWVB (Remote Control Time) This met hod requires you to do nothing except wai t for the signal to be received and to select a time zone.
10 6. Press the SET button to confirm the mi nutes and to advance to the Day, Date, and Year setting m ode. Note: In 12h mode, “PM” will appear to the left of the time during PM ho urs. If the time is not with in the PM hours, nothing will be displa yed.
11 10. Press the SET button to confirm and to advance to the ° F or ° C setting m ode. VII. SELECTING ° F OR ° C 1. Press and hold the SET button for 3 seconds, or until “12h” or “24h” flashes in the DATE LCD. 2. Press the SET button 9 times to reach the ° F or ° C setting mode.
12 FEATURES OF THE WS-7025U I. BACK LIGHT The WS-7026U has a backlight that can be activated by pressi ng any of the eight function b u ttons. After a bu tto n has been pressed th e backlight will come on for five seconds before autom atically shutting off.
13 A. WEATHER ICONS There are 3 possible weather icon s that will be displayed in the FORECAST LCD: Sunny —indicates that the weather is expected to im prove (not that the weather will be sun n y). Sun with Clouds —indicates that the weather is expected to be fair (not that the weather will be sunny with clouds).
14 III. INDOOR TEMPERATURE, HUMIDITY, AND COMFORT LEVEL INDICATOR The current Indoor Temperature (viewed on the left ) and Relative Humi dity (viewed on the right) are displ ayed in the INDOOR LCD. The Comfort Level Indicator is located at the center of the INDOOR LCD.
15 3. While “MAX” is still displayed press the IN button again to return to the current d ata display. By waiting 20 seconds during either the mini mum or t he maxim um readings the unit will automatically return to current data read ings. B. VIEWING THE OUTDOOR TEMPERATURE RECORDS 1.
16 1. Press and hold the AL1 button for 5 seconds or until the alarm-time display flashes in the DATE LCD. 2. Press the IN button to set the alarm hours and the OUT butto n to set the alarm minutes.
17 up of Remote Control Sender units wit h the WS-7025U. These extra sensors can be purchased through the same deal er as this uni t, or by contacting La Crosse Techn ology directly. A TX3U will monitor temperature only and the TX 3UP will monitor the temperature via a pro be for use in pools, spas, etc.
18 the button tw ice) will display the same data for the maxim um recordings. 3. To reset the Minimum/Maximum readings, it is necessary to select which Remote Control Sender you wish to reset. Press and hold the OUT button for 5 seconds, the records for the selected Remote Control Sender unit w ill be reset.
19 MOUNTING Note: Before permanently mount ing ensure that the Indoor Temperat ure Station is able to receive WWVB signals from the desired location. Also, extreme and sudden changes in temperat ure w.
20 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat . 2) Remove the protective stri p from one side of the tape. Adhere the tape to the desi gnated area on the back of the mounting bracket .
21 TROUBLESHOOTING Problem: No reception of WWVB time signal. Solution: 1) Wait overnight for signal. 2) Be sure weather station is at leas t 6 feet from any electrical devices such as televisions, com puters or other radio-control led clocks.
22 MAINTENANCE AND CARE INSTRUCTIONS • Extreme tem peratures, vibration and shock shoul d be avoided to prevent damage to the units. • Clean displays and units with a soft, dam p cloth. Do not use solvent s or scouring agents. They m ay mark the displ ays and casings.
23 SPECIFICATIONS Temperature measuring range: Indoor: 32 ° F to 139.8 ° F with 0.2 ° F resolution. (0 ° C to 59.9 ° C with 0.1 ° C resolution) “OFL” displayed if out side this range Outdoor: -21.8 ° F to 157.2 ° F with 0.2 ° F resolution.
24 WA RRANTY INFORMA TION La Crosse Technology, Ltd provides a 1-y ear limited w arranty on this product against manufacturing defects in ma terials and workmanship. This limited warranty begins on the original dat e of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product.
25 PUBLIC INFORMATION. THIS PRO DUCT IS NOT A T OY. KEEP OUT OF CHILDREN’S REACH. This warranty gives y ou specific legal rights. You may also have other rights specific to your State. Some States do no allo w the exclusion of c onsequential or incidental damages therefore the above exclusion of limitation may not apply to y ou.
デバイスLa Crosse Technology WS-7025Uの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
La Crosse Technology WS-7025Uをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLa Crosse Technology WS-7025Uの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。La Crosse Technology WS-7025Uの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。La Crosse Technology WS-7025Uで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
La Crosse Technology WS-7025Uを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLa Crosse Technology WS-7025Uの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、La Crosse Technology WS-7025Uに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLa Crosse Technology WS-7025Uデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
