La Crosse TechnologyメーカーWS-9057Uの使用説明書/サービス説明書
ページ先へ移動 of 12
1 Weather Station Model WS-9057U Instruct ion Man ua l INSTANT TRANSMISSION is the state-o f - the-art new wireless transmissi on technology, exclusively designed and developed by L A CROSSE TECHNOLOGY.
5 SETUP WHEN ONE TRANSMITTER IS USED 1. First, insert the ba tteries in the trans mitter (see “ How to install and replace batteries in the Thermo-hygro outdoor transmitter ” on page 11).
9 When the weather station is receiving the WWVB time signal, the outdoor transmitter data signal will temporarily not be receiv ed by the weather station. During this short period of time, the outdoor readings shown on the weather station will not be renew ed until the WWVB time signal is successf ully recei ved.
13 will sound for every seco nd. It is possible that your wireless w eather station may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accu rate; under 0.
17 * When the signal is successfully received by t he Weather Station, the outdoor transmission icon will be switched on. I f not successful, the icon will no t be shown on LC D. The user can the n easily see whe ther the last reception was successful (icon on) or not (icon off).
21 12/24-HOUR FORMA T SETTING: The hour display can be selecte d to show hours in 12-hour or 24-hour settings. (Default 12-Hour) 1. Use the OU T/+ key to toggl e between “12H” or “2 4H”. 2. Confirm with the SET key and enter the Manual time setting .
25 2. Confirm with the SET key and enter the Relative air pre ssur e value s etting . Note : Units of weather icon sensitivity and air pressure history are not affected. They are always expressed in hPa. RELATIVE A IR PRESSURE VALUE SET TING The default relative pressure value is 29.
29 INDO OR RELA TIV E HUM IDI TY A ND INDO OR TEMP ER ATU RE: The indoor temperature and hum idity data and the indoor comfort indicator are automatically update d and displayed on the second section of the LCD.
33 If the Weather stati on is moved to another location significantly higher or lower than its initi al standing point (fo r example from the ground floor to the upper floors of a h ouse), discard the w eather foreca st for the nex t 48- 60 hours.
37 2. Use OUT/+ key to view the MIN/MAX temperature and humidity data for the sele cted transmitter. 3. To reset the minimum and maximum temperatur e and humidity data, and the times at which they were recorded , press the SET key continuously for abou t 3 seconds.
41 2. Clip the remote temperature transmitt er onto the bracket. Note : The mounti ng surface can affect th e transm ission range. If, for instance, the unit is attached t o a piece of metal, it ma y then either reduce or increase the transmittin g range.
45 parts or products if found to be defectiv e during the limited warranty period specifie d above. All replaced parts and produc ts become the property of La Crosse Technology , Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty , or ninety (90) days, whichever is longer.
デバイスLa Crosse Technology WS-9057Uの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
La Crosse Technology WS-9057Uをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはLa Crosse Technology WS-9057Uの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。La Crosse Technology WS-9057Uの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。La Crosse Technology WS-9057Uで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
La Crosse Technology WS-9057Uを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はLa Crosse Technology WS-9057Uの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、La Crosse Technology WS-9057Uに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちLa Crosse Technology WS-9057Uデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
