MagnadyneメーカーMV1020の使用説明書/サービス説明書
ページ先へ移動 of 20
Owner's Manual Mobile DVD/CD Player with 10.2" TFT Monitor Model: MV1020 / MV1020C For operational or technical assistance, after reading this manual, please call us toll free at (800) 638-3600 or visit www .
2 Safety Information . . . . . . . . . . . . . . . . . . . . 2-3 Disc and SD Card Notes . . . . . . . . . . . . . . . . . 4 Screen and DVD/CD Functions . . . . . . . . . . 5-7 Location of Functions . . . . . . . . . . . . . . . . . . 5 T urning the Unit On .
3 Features • This unit can play compatible discs recorded in either P AL or NTSC format. • CD, DVD, CD-R, CD-RW and MP3 Compatible. • SD Card Support. • Full-Function Wireless Remote Controller . • Multi-Language On-Screen Display Menu. • Built-In Dome Light System.
Disc Formats Supported by this Player: Discs which cannot be played with this player: • DVD-ROM • DVD-R/DVD-RAM • CDV • CD-G 4 Disc and SD Card Notes V I D E O (Single-sided disc only) 8 cm disc 8 cm disc Label side up Do not touch the underside of the disc Do not bend Wipe the disc from center toward the outside edge.
5 Screen and DVD/CD Functions 1. POWER Button: Press this button to turn the unit On/Off. 2. SOURCE Button: Press this button to change the play source between DVD/CD player and an auxiliary input source. 3. STOP Button: Stops play of picture or audio.
T urning the Unit On: Press the POWER on either the remote or the screen housing. Adjusting the Monitor: 1. Press the MODE button on the remote to activate the monitor adjustment menu. The following will be displayed on the screen: 2. Press the MODE button again to select the adjustment bar .
Screen and DVD/CD Functions 7 Dome Light Switch Infrared Remote Control Sensor: The Infrared remote control sensor receives the signals from the remote control.
8 1 9 10 6 18 19 11 13 22 23 24 14 15 17 5 2 3 4 16 20 21 8 12 7 25 POWER AUDIO ANGLE SUBTITLE DISPLA Y SETUP PLA Y/PAUSE PROG CLEAR PREV REV SLOW SD TITLE NEXT FWD A-B REPEA T SOURCE VOL– ZOOM PBC MENU SEARCH ENTER RETURN STOP EJECT VOL+ MOD E TFT FUN CTION UP MUTE DOWN 1 4 7 2 5 8 0 10+ 3 6 9 Remote Control Locations and Operation 1.
POWER AUDIO ANGLE SUBTITLE DISPLA Y SETUP PLA Y/PAUSE PROG CLEAR PREV REV SLOW SD TITLE NEXT FWD A-B REPEA T SOURCE VOL– ZOOM PBC MENU SEARCH ENTER RETURN STOP EJECT VOL+ MOD E TFT FUN CTION UP MUTE DOWN 1 4 7 2 5 8 0 10+ 3 6 9 30 29 26 27 28 31 32 Remote Control Locations and Operation 26.
Slow Play Each time the SLOW button is pressed during DVD play the speed is reduced as follows: 10 Basic Operation and Special Functions Display DVD Menu Screen 1. Press the MENU button to display the DVD menu screen. 2. Use the cursor button to select item.
11 Special Functions and Setup Menu DVD SPECIAL FUNCTIONS (Continued) Multi-Subtitle Language Function Press the SUBTITLE button during playback. Each time the button is pressed the subtitle language on the screen changes. Multi-Audio Language Function Press the AUDIO button during playback.
12 Setup Menu DISC SETTINGS Use the CURSOR buttons to make DISC setting selections. Press the ENTER button to confirm the setting. Audio Setting Use this screen to setup the audio language on multi-language discs. Subtitle Language Setting Use this screen to setup the subtitle language on multi-subtitle language discs.
Setup Menu VIDEO SETTINGS Use the CURSOR buttons to make VIDEO setting selections. Press the ENTER but- ton to confirm the setting. TV Aspect Setting Use this screen to setup the desired TV Aspect Ratio. AUDIO SETTINGS Use the CURSOR buttons to make AUDIO setting selections.
14 Setup Menu Last Play Function The Last Play function automatically book- marks the position on a DVD/CD disc and remembers the playback settings. Playback will resumes at the position which the player was turned off, the disc was ejected, or the power was cut off.
15 Installation When installing the MV1020 using a Custom Bracket Mounting System refer to the instructions included wi th with the bra cket. War ning: T ake e x tra ca re not to p enetrate the roof of your v ehicle during i nst allati on.
16 Wiring Diagram Black (Video Out) White (L-Audio Out) Red (R-Audio Out) Audio Video Output (Female RCA) Mini DIN Connector Black Wire - Ground Red Wire - Ignition Y ellow Wire - Batter y Blue Wire -.
17 Power Harness Wiring: The 4-wire harness provides battery and ignition 12 volts as well as a chassis ground. Route the power harness to the point in the vehicle that you will make the connections. Red Wire: The red wire in the harness should be connected to a +12 volt power wire that is turned on and of by the position of the ignition key .
18 Only qualified service personnel can remove the cover or service this player . Other wise the warranty will become invalid. No Power: • Check to see if the player is set to “On”. • Check to see that the power plug of the main unit is properly connected.
19 Replacement Parts Order Form Send Orders T o : Magnadyne Corporation We Accept Checks, Money Orders, Visa and Master Card A TTN: Consumer Parts Sales Make Checks Payable to: Magnadyne Corporation P . O. Box 5365 Carson, CA 90749-5365 SHIP TO: (No P .
Order By Mail Replacement Parts for MovieVision ® Systems DESCRIPTION MODEL # PRICE DVD Remote Control MV-1020RM $39.95 Ea. ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agent.
デバイスMagnadyne MV1020の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Magnadyne MV1020をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMagnadyne MV1020の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Magnadyne MV1020の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Magnadyne MV1020で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Magnadyne MV1020を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMagnadyne MV1020の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Magnadyne MV1020に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMagnadyne MV1020デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。