MieleメーカーCS 1223の使用説明書/サービス説明書
ページ先へ移動 of 40
Operating and Installation Instructions Induction Wok CS 1223 To prevent accidents and machine damage, read the Operating Manual before installation or use.
IMPORTANT SAFETY INSTRUCTIONS .................................3 Description of the unit ..............................................8 Before using for the first time ........................................9 Induction ..............................
WARNING- When using your appliance follow basic precautions, including the following: Read all instructions before installation or use to prevent injury and appliance damage. This appliance conforms to all uniform safety codes and regulations. The manufacturer cannot be held responsible for damage or injury caused by improper use of this appliance.
Children ~ Activate the Child Safety Lock so that the combiset cannot be turned on inadvertently. ~ Children should not be left unattended in an area where the appliance is in use. Never allow children to sit or stand on any part of the appliance. Caution : Do not store items of interest to children in cabinets above the appliance.
~ Install the appliance so that the power cord does not come into contact with any portion of the cooktop which may become hot during use. ~ Before servicing, disconnect the appliance from the main power supply. ~ Do not operate any appliance with a damaged cord or plug, or if the appliance has been damaged in any manner.
Safety ~ Individuals with a pacemaker or similar medical device: Please note that an electromagnetic field develops when the combiset is turned on. It is not likely that this will affect the pacemaker or similar device. If in doubt contact the manufacturer of the device or your doctor.
~ Make certain that the power cords of small appliances do not come in contact with the appliance. The insulation of the cable could become damaged. Danger of electric shock! ~ Be careful not to drop anything on the ceramic surface of the combiset. Even lightweight objects may cause damage.
a Wok burner C 11 3 / 4 " (30 cm) Rating in watts: 2400 W with Booster: 3200 W b Wok pan (included) c Control knob d Indicators Indicators f On/Off indicator g Booster indicator h "Residual .
Clean the combiset ^ Before using for the first time, clean the appliance with a damp cloth and dry with a soft cloth. Do not use liquid dish soap to clean the combiset, this may cause permanent blue discolorations.
How it works An induction coil is located under the burner. When the burner is switched on, this coil creates a magnetic field which impacts directly on the base of the pan and heats it up. The burner itself is heated indirectly by the heat given off by the pan.
Noises The following noises can occur when the induction wok is in use. – Higher power settings may cause a buzz. This will decrease or cease altogether when the power setting is reduced. – You may hear a clicking sound from the electronic switches, especially on lower settings.
Turning the combiset On/Off , Do not leave the appliance unattended while in use. To turn the combiset on turn the control knob clockwise a to the desired power level. To turn the combiset off turn the control knob counterclockwise b to "0".
Settings Use for Power level Keeping food warm, Melting chocolate, etc. 1-2 Warming food 3 - 6 Stir-frying 7- 9 Auto-heat Continued power level Heat-up time (approx.
Booster function The induction wok is equipped with a booster function to temporarily increase the power level. When the Booster is activated the burner will operate at power level 9 with an extra boost of power for 10 minutes. Taking the wok pan off the burner while the booster is in operation interrupts the booster function.
Child Safety Lock Keep children away from the combiset for their own safety. The combiset has a Child Safety Lock to prevent children from turning on the burners. To activate the Child Safety Lock: ^ Turn the control knob counterclockwise as far as it will go, and hold until L appears in the display.
Overheating protection The induction coils are fitted with an overheating protection feature. This prevents the induction coils from overheating by: – If the booster function is being used, it will be switched off. – If the temperature continues to rise after the booster function is switched off, the power level will be reduced.
Do not use a steam cleaner to clean this appliance. Steam could penetrate electrical components and cause a short circuit. Pressurized steam could cause permanent damage to the surface and to components for which the manufacturer cannot accept responsibility.
Stainless steel Clean stainless steel surfaces with warm water and liquid dish soap applied with a non-abrasive sponge and then wipe dry with a soft cloth. Soak baked or hardened spills first to loosen them. Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner (available from Miele).
, Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage.
What if the combiset turns itself off automatically? Possible fault Solution Either the "Safety cut-out" feature or the "Overheating protection" feature has been activated. See "Overheating protection" or "Safety cut-out".
In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance.
22.
Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE To prevent accidents and machine damage read these instructions before installation or use.
Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector’s use. The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire.
Safety distances above the appliance The minimum safety distance given by the hood manufacturer must be maintained between the combiset and the hood above it.
Safety distances to the sides of the appliance The appliance should only be installed as shown in the illustrations, while maintaining the required safety distances shown.
Safety distance when installing the appliance near a wall with trim or a back splash A minimum distance of 2" (50 mm) between the trim or back splash and the countertop cut-out if required. This distance is only necessary if these items are made of combustible materials e.
Installation dimensions a Spring clips b Appliance front c Installation height d Power supply box with connection cabl eL=7 8 3 / 4 " (2000 mm) Installation 28.
Cut out ^ Make the worktop cut-out for one or more appliances as applicable. Remember to maintain a minimum safety distance from the back wall , as well as from any tall unit or side wall to the right or left of the appliance(s). See also "SAFETY INSTRUCTIONS FOR INSTALLATION".
Installation of multiple appliances When installing more than one combiset appliance, a support bar b must be installed between the appliances. Countertop cut-out two appliances For the installation of two appliances the width of the countertop cut-out D is the sum of A and C.
Sample calculations for a countertop cut-out for three appliances A appliance width minus 5 / 16 "( 8m m ) B appliance width C appliance width minus 5 / 16 "( 8m m ) D Countertop cut-out 11&.
a Spring clips b Support bars c Space between support bar and countertop An additional support bar is required for each additional appliance. The position for attachment of an additional spacing strip depends on the width of the appliance B .
Attach the spring clips and support bars Wood or solid surface countertops ^ Place the supplied spring clips a and the support bars b at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1 / 8 " x 1" (3.
^ Coat the edges of the spring clips a , ^ and the space d between the strips b and the countertop with silicone (supplied). Installation 34 b d a.
Installing the appliance ^ Feed the power cord down through the cut-out. ^ Then place the front side of the appliance in the countertop cut-out. ^ Then with a hand on each side of the appliance press down evenly on the edges until it clicks into position.
Sealing The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. If the appliance is sealed into position, the countertop or appliance could be damaged if it needs to be removed for maintenance or service.
, CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power supply or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards.
Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children. Danger of suffocation! Disposal of an old appliance Old appliances contain materials that can be recycled.
39.
Alteration rights reserved / 4608 For the most updated manual see the Miele web site. M.-Nr. 07 353 930 / 00.
デバイスMiele CS 1223の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Miele CS 1223をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはMiele CS 1223の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Miele CS 1223の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Miele CS 1223で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Miele CS 1223を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はMiele CS 1223の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Miele CS 1223に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちMiele CS 1223デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。