NordicTrackメーカーNTBE06901の使用説明書/サービス説明書
ページ先へ移動 of 19
QUESTIONS? As a manufacturer , we are com- mitted to providing complete customer satisfaction. If you have questions, or if there are missing parts, we will guarantee complete satisfaction through direct assistance from our factory . TO A VOID UNNECESSAR Y DELA YS, PLEASE CALL DIRECT TO OUR T OLL-FREE CUSTOMER HOT LINE.
2 W arning Decal Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 1. Read all instructions in this manual before using the weight rack. Use the weight rack only as described in this manual. 2. It is the responsibility of the owner to ensure that all users of the weight rack are ade- quately informed of all precautions.
4 Weight Carriage High Pulley Station Lat Bar Weight Rest Weight Spotter Right Side Left Side Note: The terms Òright sideÓ and Òleft sideÓ are determined relative to a person using the rack; they do not correspond to right and left on the drawings in the manual.
5 Part Identification ChartÑModel No. NTBE06901 R1000A M10 Nylon Locknut (29)Ð46 M8 Nylon Locknut (30)Ð4 M10 x 66mm Bolt (35)Ð2 51mm Spacer (39)Ð1 24mm Spacer (38)Ð2 M10 x 45mm Bolt (32)Ð3 18mm.
6 Before beginning assembly , carefully read the following information and instructions: ¥ Assembly requires two people. ¥ Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
7 3 4a 4b 4. Refer to drawing 4a. Press Square Bushings (21) into the top and bottom of one of the Weight Rests (19) and one of the Weight Spotters (20) as shown. Pull out the Adjustment Knobs (22) and slide the Weight Spotter and the W eight Rest down over the right Uprights (7, 8) as indicated.
8 8. Set the two Weight Bumpers (18) over the indicated holes in the Weight Guide Base (4). Hold the Weight Carriage (15) on top of the W eight Bumpers. Insert the two Weight Guides (9) into the W eight Carriage (15), the Weight Bumpers (18), and the Weight Guide Base (4).
9 10 10. Locate a Cable (25) and notice that there is a ball on one end of the Cable and a metal sleeve on the other end. Route the metal-sleeve end of the Cable (25) up under the lat bar rest on the .
10 24 2 29 15 29 17 17 32 24 23 25 25 23 14. Pull the Cable (25) down in the indicated location, so there is no slack at the ends of the Cable. Locate the other Cable (25). Insert the metal-sleeve end of the Cable into the indicated hole in the Weight Guide Base (4).
11 USING THE WEIGHT RESTS AND WEIGHT SPOTTERS Before beginning an exercise, move the Weight Rests (19) and the Weight Spotters (20) to sets of holes in the Uprights (7, 8) that are best suited for that exercise. Do this by turning the Adjustment Knobs (22) counterclock- wise until loose.
12 A TT ACHING WEIGHTS TO THE WEIGHT CARRIAGE T o use the high or low pulley station, slide the desired amount of weight onto the weight tubes of the Weight Carriage (15) and secure the weights with Weight Clips (48). 48 15 Weight T ube Weight T ube W ARNING: Do not place more than 150 pounds on the Weight Carriage (15).
13 THE FOUR BASIC TYPES OF WORKOUTS Muscle Building The only way to increase the size and strength of your muscles is to push them close to their maximum capacity . When you progressively increase the inten- sity of your exercise, your muscles will continually adapt and grow .
14 Make sure to rest for a short period of time after each set. The ideal resting periods are: ¥ Rest for three minutes after each set for a muscle building workout. ¥ Rest for one minute after each set for a toning workout. ¥ Rest for 30 seconds after each set for a weight loss workout.
15 MONDA Y Date: / / EXERCISE WEIGHT SETS REPS EXERCISE WEIGHT SETS REPS EXERCISE WEIGHT SETS REPS AEROBIC EXERCISE AEROBIC EXERCISE TUESDA Y Date: / / WEDNESDA Y Date: / / THURSDA Y Date: / / FRIDA Y Date: / / Make photocopies of this page for scheduling and recording your workouts.
Part No. 171090 R1000A Printed in China © 2000 ICON Health & Fitness, Inc. T o order replacement parts, simply call our Customer Service Department toll-free at 1-888-825-2588, Monday through Friday , 6 a.m. until 6 p.m. Mountain T ime (excluding holidays).
REMOVE THIS P ART LIST/EXPLODED DRA WING FROM THE MANUAL SA VE THIS P ART LIST/EXPLODED DRA WING FOR FUTURE REFERENCE 81.
Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notice. See the back cover of the user Õs manual for information about ordering replacement parts. Key No. Qty . Description Key No. Qty . Description Part ListÑModel No.
46 46 45 44 47 47 28 29 31 6 13 28 31 29 37 29 11 10 12 31 6 31 29 31 29 32 23 29 17 17 24 24 23 25 28 14 24 24 43 34 37 41 29 29 37 41 33 29 29 30 25 18 27 33 34 37 36 40 37 16 16 15 35 37 39 37 35 3.
デバイスNordicTrack NTBE06901の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
NordicTrack NTBE06901をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはNordicTrack NTBE06901の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。NordicTrack NTBE06901の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。NordicTrack NTBE06901で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
NordicTrack NTBE06901を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はNordicTrack NTBE06901の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、NordicTrack NTBE06901に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちNordicTrack NTBE06901デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。