OmronメーカーHJ-322Uの使用説明書/サービス説明書
ページ先へ移動 of 28
P edometer Downloadable Model: HJ-322U INSTRUCTION MANU AL ENGLISH.
2 TABLE OF CONTENTS Before Using the Monitor Introduction ................................................. 3 Important Safety Information ................................... 4 Operating The Device .................................... 4 Care And Maintenance .
3 Thank you for purchasing the OMRON ® HJ-322U Pedometer. Fill-in f or future referenc e DA TE PURCHASED: ___________________________ • Staple your purchase rec eipt here • Register your product online at www .register-omron.com This Pedometer features advanced 3D Smart Sensor technology - so it knows exactly when you’re taking a step.
4 To assure the correct use of the product basic safety measures should always be followed including the warnings and cautions listed in this instruction manual. SAFETY SYMBOLS USED IN THIS INSTRUCTION MANUAL W ARNING Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury .
5 IMPORT ANT SAFET Y INFORMA TION Do not touch the USB Connector with wet hands. Do not use a cell phone near the pedometer while transferring data. When transferring data to the online solution do not leave the unit plugged into the PC for an extended period of time.
6 Front of unit: Low battery indicator Transfer indicator Display set / ● button mode / ▼ button mem /▲ button NOTE: Remove the protective lm from the face of the unit.
7 KNOW Y OUR UNIT Components: Holder Attach/remove the holder as illustrated below. NOTE: When attaching the holder, do not grip it strongly at the top and bottom.
8 Measure your stride length before setting the pedometer. How to measure your stride length 1. Walk 10 steps with your normal stride as illustrated below. 2. Measure the distance from START to END in inches. 3. Calculate your stride length by dividing the total distance by 10.
9 The unit comes with the battery installed. When you use the unit for the rst time, follow the steps below. For setting range details refer to “SPECIFICATIONS”. NOTE: If the initial settings are not correct, the measurement results may not be accurate.
10 SET TINGS 8. To set the stride length, repeat steps A) and B) in step 6 above. 9. To set the year, repeat steps A) and B) in step 6 above. 10. To set the month, repeat steps A) and B) in step 6 above. 11. To set the day, repeat steps A) and B) in step 6 above.
11 The unit accurately counts in a pocket, bag or anywhere you want to put it. The unit may be placed in the upper front pocket of your clothing, in the front pocket of your pants, in a bag, or attached to your belt or pants, or hang it from your neck.
12 Press to change the display. Step count display Distance display Calories display Aerobic steps display Time display READING THE CURRENT DISPLAY.
13 READING THE CURRENT DISPLA Y Calories By measuring the intensity of your activity, the unit can calculate the amount of calories burned. Aerobic steps Aerobic steps are the physical exercise that helps us stay healthy. Aerobic steps are counted separately when walking more than 60 steps per minute and more than 10 minutes successively.
14 The unit stores up to 22 days of data, including the current day and displays the previous 7 days of data on the unit. The current day’s data is automatically stored in memory when the time reaches 12:00AM (0:00). The display will return to 0. NOTE: The time must be correctly set in the unit.
15 MEMOR Y FUNCTION NOTE: If no button is pressed for more than 1 minute, the display will return to the current day’s data. Transfer Indicator The Transfer Indicator will blink when 18 days of data, including the current day, are stored in the memory and have not been transferred.
16 To begin using the software for the rst time, please visit www.omrontness.com for the initial set-up instructions. TRANSFERRING DATA TO THE ONLINE SOLUTION.
17 Low battery indicator When the low battery indicator appears on the display, immediately replace the battery with a new CR2032 battery. Blinking Battery power is low . Appears continuously Battery power exhausted. The unit stops measurement. Data cannot be transferred.
18 1. Loosen the screw of the battery cover on the back of the unit. Remove the battery cover by pulling it off in the direction of the arrow. Use the supplied screwdriver or use a small screwdriver to loosen the screw on the battery cover. 2. Remove the battery with a toothpick.
19 BA TTERY REPLA CEMENT CAUTION Do not throw the battery into re. The battery may explode. 3. Insert the battery (CR2032) with the positive (+) side face up. 4. Replacethebatterycoverbyslidingthecatchinrst,then tighten the screw.
20 Follow the procedure below to delete all the previous measurement results and settings, including the date, time, weight, height, and stride length. 1. Press and hold . “lb” or “kg” ashes on the display. 2. Press and hold and at the same time.
21 T o keep the unit in the best condition and protect the unit from damage follow the directions listed below: CAUTION Do not disassemble or modify the unit. Changes or modications not approved by Omron Healthcare will void the user warranty. Clean the unit with a soft dry cloth.
22 Problem Probable Cause How to Correct The low battery indicator blinks or appears continuously . The battery is low or worn. Replace the battery with a new one (CR2032), refer to “BA TTERY REPLACEMENT”. Nothing is displayed. Battery saving mode active.
23 TROUBLESHOO TING TIPS Problem Probable Cause How to Correct Communication error . Check the display on your PC and follow the instruction provided. Or plug in the USB Connector once more and try again. NOTE: If the error still occurs after trying the above, contact Omron’ s Customer Support.
24 Model : HJ -32 2U ( HJ -322U -Z) Power S uppl y: 3 V DC (1 lith iu m bat ter y CR 2032 ) Mea su reme nt R an ge: St ep s: 0 to 99,999 st eps Di st a nc e: 0.
25 NOTE: POTENTIAL FOR RADIO/TELEVISION INTERFERENCE (for U.S.A. only) This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
26 FC C ST A TEMENT POTENTIAL FOR RADIO/TELEVISION INTERFERENCE (for Canada only) This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Canadian Department of Communications.
27 Your OMRON HJ-322U Pedometer, excluding the battery, is warranted to be free from defects in materials and workmanship appearing within 1 year from the date of purchase, when used in accordance with the instructions provided with the unit. The above warranties extend only to the original retail purchaser.
OM R ON H EALTHCA RE , I NC. 1925 W est Field C our t La ke Fores t, IL 6 00 45 U . S.A. ww w .om ronhealt hcare.com © 201 2 OM RO N H EA L T HCAR E, I NC.
デバイスOmron HJ-322Uの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Omron HJ-322Uをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはOmron HJ-322Uの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Omron HJ-322Uの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Omron HJ-322Uで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Omron HJ-322Uを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はOmron HJ-322Uの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Omron HJ-322Uに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちOmron HJ-322Uデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
