Oregon ScientificメーカーPS-L06Uの使用説明書/サービス説明書
ページ先へ移動 of 30
EN Full Weather St ation wit h Radio Cont rolled Clock , Projection and AM /FM Radio (Model #: PS- L06 / PS-L06U ) User Manual PS-L06_GB-final.p65 8/8/03, 12:02 PM 1.
EN PS-L06_GB-final.p65 8/8/03, 12:02 PM 2.
EN T ABLE OF CONTENTS About this guide ........................................................ 2 Product overview ....................................................... 3 Getting started .......................................................... 8 Batteries .
EN ABOUT THIS GUIDE Congratulations on your selection of the Philippe Starck with Oregon Scientific Full W eather Station with Radio-Controlled Projection Clock and AM/FM Radio (PS-L06 / PS-L06U).
EN PRODUCT OVERVIEW TOP VIEW DESCRIPTIONS 1. Snooze / Light button ( → 12, 19) 2. Light sensor ( → 19) 3. Projection lens ( → 20) 1 2 3 3 PS-L06_GB-final.
EN LCD DISPLA Y DESCRIPTIONS 1. Low batteries icon ( → 8) 2. Clock ( → 10) 3. Barometer ( → 13) 4. Weather forecast ( → 15) 5. Moon phase ( → 13) 6. Calendar ( → 12) 7. T emperature and humidity ( → 15) 8. Alarm ( → 11) 9. Radio ( → 18) 1 2 3 4 69 8 7 5 4 PS-L06_GB-final.
EN BACK VIEW BUTTON DESCRIPTIONS 1. Focus – focus projector ( → 20) 2. Select – switch modes / change settings 3. Rotation – rotate projector ( → 20) 4. Up – increase setting / activate auto-synch ( → 11) 5 . Down – decrease setting / deactivate auto-synch ( → 11) 6.
EN BOTTOM VIEW DESCRIPTIONS 1. Battery compartment ( → 8) 2. Light sensitivity knob ( → 20) 3. Reset button ( → 8, 21) 4. Antenna ( → 18) 5. Headphone jack ( → 19) 6. DC power input jack ( → 8) 7. Backlight switch ( → 19) NO TE AC power adapter not shown.
EN REMOTE UNIT DESCRIPTIONS 1. T emperature / T rend display 2. Low battery icon 3. Humidity / T rend / Comfort Level display 4. ° C / ° F switches 5. Channel switches 6. Reset button 7. Battery compartment 8. W all-mount hole 9. Battery compartment lid 7 7 9 2 3 6 4 1 5 8 PS-L06_GB-final.
EN GETTING ST ARTED BA TTERIES Batteries for the remote and main units are supplied with this product. Replace them whenever the low battery signal ( ) displays. Remove the battery compartment lid on the bottom of the main unit, and insert the batteries.
EN SWITCH BETWEEN MODES Press SELECT . The select mode will flash. The display will stop flashing if no key is pressed within 5 seconds. CHANGE SETTINGS Press and hold SELECT for 2 seconds. Then, press UP or DOWN to change each setting. Press SELECT to switch options.
EN • Position the unit so that it faces the main (indoor) unit. Minimize obstructions such as doors, walls, and furniture. Y ou may need to experiment with various locations to get the best reception.
EN TO DISABLE OR ENABLE AUTO- SYNCHRONIZA TION In Clock mode, Press DOWN for 2 seconds to disable the auto-synchronization. The unit will not respond to radio signals until you reactivate the synchronization. T o enable auto-r eception, pr ess UP for 2 seconds.
EN SELECT to confirm. If you choose , also select the melody (1 – 7) and volume level (Lo or Hi). If you choose , use the radio control buttons to select the AM/FM band, radio station and volume level ( → 18). 4. Press SELECT again when you are finished.
EN 3. Select the year , month, date, and language. Press UP or DOWN to change the setting. Press SELECT to confirm. NO TE The language options are (E) English, (F) French, (D) German, (I) Italian, and (S) Spanish. MOON PHASE Press SELECT until the Calendar Area flashes.
EN BAROMETRIC TREND The barometric trend arrow for the last 30 minutes is always displayed. VIEW THE LAST 24 HOURS Press SELECT 2 times until the Barometer Area flashes. Then, press UP or DOWN to view the last 24 hours history . SET UNIT AND AL TITUDE Y ou can set the unit of measurement (mb/hPa or inHg) and altitude.
EN WEA THER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30 to 50 km (19 - 31 mile) radius with 70 to 75 percent accuracy .
EN clears the previous measurements from the memory . SELECT REMOTE UNIT CHANNEL While in the T emperatur e / Humidity Mode, press CHANNEL to switch between CH 1, 2, or 3, or press and hold CHANNEL for 2 seconds to enter Auto scan mode. If only 1 remote unit is in use, you will not be able to change channels or Auto scan.
EN COMFORT ZONE The indoor and outdoor comfort zones are shown for the following conditions. TRENDS The trend arrow for the last 30 minutes always displays.
EN SET UNIT While in T emperature / Humidity Mode, press SELECT for 2 seconds. Press UP or DOWN to switch between ° C and ° F . Press SELECT to confir m. RADIO Y ou can listen to PLL digital radio broadcasts with this product. ANTENNA The antenna wire is located in the battery compartment.
EN STORE ST A TION TO MEMORY Press ST A TION for 2 seconds. The assigned number (1 – 8) will show in the Radio Area. SLEEP TIMER Press SLEEP . T o change the timer length (0 – 120 minutes in increments of 10) press UP or DOWN . The radio automatically turns off when the timer r eaches 0.
EN 3. The Light Sensitivity knob is located in the battery compartment. Rotate to adjust. 4. When activated, the continuous backlight will be half as bright as usual. T o achieve full brightness, press SNOOZE/LIGHT . PROJECTOR This product has a built-in projector for viewing time and alarm status at night.
EN CONTINUOUS PROJECTION The AC power adapter must be plugged in to use this feature ( → 8). Press and hold SNOOZE/LIGHT for 2 seconds. when the projection is on. When activated, the time and alarm status will project continuously . Press and hold SNOOZE/LIGHT for 2 seconds again to deactivate.
EN W ARNINGS This product is designed to give you years of service if handled properly . Observe the following guidelines: • Never immerse the unit in water . This can cause electrical shock and damage the unit. • Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity .
EN 23 Problem Symptom Remedy Radio Remote unit Reception is poor / static Cannot locate remote unit Select radio format ( → 18) Check batteries ( → 8) Place clock near a window ( → 10) Check location ( → 9) Cannot change channel Check sensors.
EN SPECIFICA TIONS Main unit dimensions L x W x H 181 x 45 x 185.3 mm (7.1 x 1.77 x 7.3 inches) W eight 994 grams with battery Remote unit dimensions L x W x H 75 x 35 x 78.
EN Remote Unit: -20 ˚C to 60 ˚C (-4 ˚F to 140 ˚F) Resolution 0.1 ° C (0.2 ° F) Comfort 20 ° C to 25 ° C (68 ° F to 77 ° F) (see also, Relative humidity) Memory Minimum / maximum T rend +/- 0.
EN Channel No. 1, 2, or 3 Unit ° C or ° F Radio-controlled clock Synchronization Auto or disabled Clock display HH:MM:SS Hour format 12hr AM/PM (MSF format) 24hr (DCF format) Calendar DD/MMM; weekda.
EN Power Main unit 4 x UM-3 (AA) 1.5V alkaline batteries (back-up) AC/DC 7.5V power adapter (for normal operation and continuous backlight and projector) Remote unit 2 x UM-4 (AAA) 1.5V alkaline batteries ADDITIONAL RESOURCES V isit our website (www .
EN EC-DECLARA TION OF CONFORMITY This product contains the approved transmitter module TX 07 and complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directives, if used for its intended use and that the following standard(s) has/have been applied: Radio frequency spectrum (Article 3.
デバイスOregon Scientific PS-L06Uの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Oregon Scientific PS-L06Uをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはOregon Scientific PS-L06Uの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Oregon Scientific PS-L06Uの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Oregon Scientific PS-L06Uで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Oregon Scientific PS-L06Uを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はOregon Scientific PS-L06Uの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Oregon Scientific PS-L06Uに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちOregon Scientific PS-L06Uデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。