Oregon ScientificメーカーPS-M03Uの使用説明書/サービス説明書
ページ先へ移動 of 28
Full Weather Station with Radio Controlled Clock and AM / FM Radio (Model #: PS-M03 / PS-M03U) User Manual PS M03 English Cover 6/30/03, 11:11 PM 1.
EN 1 TABLE OF CONTENTS About this guide ......................................................... 2 Product overview ........................................................ 3 Getting started ...........................................................
EN 2 ABOUT THIS GUIDE Congratulations on your selection of the Philippe Starck with Oregon Scientific Full Weather Station with Radio Controlled Clock and AM / FM Radio (PS-M03 / PS-M03U).
EN 3 PRODUCT OVERVIEW TOP AND BATTERY COMPARTMENT VIEW DESCRIPTIONS 1. Snooze / Light button ( 12, 19) 2. Light sensor ( 19) 2 1 PS M03 English R18 7/16/03, 1:04 PM 3.
EN 4 BOTTOM AND SIDE VIEW DESCRIPTIONS 1. Battery compartment ( 8) 2. Backlight switch ( 19) 3. Reset button ( 8, 20) 4. Light sensitivity knob ( 19) 5. Headphone jack ( 18) 6. DC input jack ( 8) 7. Antenna ( 17) AC power adapter not shown. NOTE RESET SENSOR ON LIGHT OFF AUTO LIGHT DC 7.
EN 5 LCD DISPLAY DESCRIPTIONS 1. Low battery icon ( 8) 2. Clock ( 10) 3. Barometer ( 13) 4. Weather forecast ( 14) 5. Moon phase ( 13) 6. Calendar ( 12) 7.
EN 6 BACK VIEW BUTTON DESCRIPTIONS 1. Select - switch modes / change settings ( 8, 9) 2. Up - increase setting / activate auto-synch ( 10) 3. Down - decrease setting / deactivate auto-synch ( 10) 4. Alarm -activate / deactivate alarm ( 12) 5. Channel - switch remote unit ( 15) 6.
EN 7 REMOTE UNIT DESCRIPTIONS 1. Temperature / Trend display ( 15, 17) 2. Low battery icon ( 8) 3. Humidity / Trend / Comfort Level display ( 15, 16, 17) 4. ° C/ ° F switch ( 9) 5. Channel switch ( 9) 6. Reset button ( 8, 20) 7. Battery compartment ( 8) 8.
EN 8 GETTING STARTED BATTERIES Batteries for the remote and main units are supplied with this product. Replace them whenever the low battery signal ( ) displays. Remove the battery compartment lid on the bottom of the main unit, and insert the batteries.
EN 9 CHANGE SETTINGS Press and hold SELECT for 2 seconds. Then, press UP or DOWN to change each setting. Press SELECT to switch options. REMOTE UNIT SET UP Up to 3 remote units can be used with this product to monitor outdoor temperature and humidity.
EN 10 CLOCK This product can automatically synchronize the date and time with official time-keeping organizations in Frankfurt, Germany (PS-M03) or Rugby, England (PS-M03U). When the unit is within 1500 km (932 miles) of a RF signal, the reception icon will blink during reception.
EN 11 SET OR CHANGE THE CLOCK 1. Press SELECT to switch to the Clock Mode. The time will flash. 2. Press and hold SELECT for 2 seconds to enter the setting mode. 3. Select the 12/24-hour format, hour, and minute. Press UP or DOWN to change the setting.
EN 12 If you choose , use the radio control buttons to select the AM/FM band, radio station and volume level ( 18) . 4. Press SELECT again when you are finished. SNOOZE Press the SNOOZE/LIGHT button the top of the unit to temporarily disable the alarm for 8 minutes.
EN 13 MOON PHASE Press SELECT until the Calendar Area flashes. Then, press UP or DOWN to change the date and view the corresponding moon phase. BAROMETER This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast ( 14) and a trend line showing the direction of barometric change.
EN 14 WEATHER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30 to 50 km (19 - 31 mile) radius with 70 to 75 percent accuracy. The weather forecast is always displayed. VIEW THE LAST 24 HOURS Press SELECT 2 times until the Barometer Area flashes.
EN 15 CLEAR MIN / MAX RECORDS While viewing Min/Max records, press and hold UP or DOWN for 2 seconds until a beep sounds. This clears the previous measurements from the memory.
EN 16 SENSOR SEARCHING If there is no remote unit signal, the temperature and humidity measurements will be blank. Check the remote unit batteries, or press and hold UP and DOWN for 2 seconds to search for the remote unit(s).
EN 17 SET UNIT While in Temperature / Humidity Mode, press SELECT for 2 seconds. Press UP or DOWN to switch between ° C and ° F. Press SELECT to confirm. RADIO You can listen to Phase Lock Loop (PLL) digital radio broadcasts with this product. ANTENNA The antenna wire is located on the side of the unit.
EN 18 VOLUME Press UP or DOWN . There are 8 volume levels. SWITCH AM/FM BAND Press TUNING to enable auto tuning. Press again to switch AM/FM band. SELECT STATION Press STATION . There are 16 preset channels: 8 for FM and 8 for AM. TUNING Press TUNING .
EN 19 3. The Light sensitivity knob is located in the battery compartment. Rotate to adjust. 4. When activated, the continuous backlight will be half as bright as usual. To achieve full brightness, press SNOOZE/LIGHT. BACKLIGHT Press SNOOZE/LIGHT to illuminate the backlight for 5 seconds.
EN 20 WARNINGS This product is designed to give you years of service if handled properly. Observe the following guidelines: • Never immerse the unit in water. This can cause electrical shock and damage the unit. • Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity.
EN 21 • Do not make any changes or modifications to this product. Unauthorized changes may void your right to use the product. • The contents of this user guide are subject to change without notice. • Images not drawn to scale. TROUBLESHOOTING Check here before contacting our customer service department.
EN 22 Radio Problem Symptom Remedy Select radio format ( 10) Reception is poor / static Place clock near a window ( 10) Remote unit Cannot locate remote unit Check batteries ( 8) Check location ( 9) Disable auto- synchronization ( 10) Cannot change clock Adjust the antenna ( 17) Problem Symptom Remedy Clock Cannot auto-synchronize 1.
EN 23 Problem Symptom Remedy Temp Shows “LLL” or “HHH” Temperature is out-of- range. Cannot change channel Check sensors. Only one sensor is working ( 15) SPECIFICATIONS Dimensions: L x W x H 129 x 43 x 133.3 mm (5.1 x 1.7 x 5.3 inches) Weight 525 grams with batteries Remote unit dimensions L x W x H 75 x 35 x 78.
EN 24 Barometer Unit mb/hPa or inHg Range 500 to 1050 mb (14.77 to 31.01 inHg) Resolution 1 mb (0.03 inHg) Altitude -100 to 2500 meters (-328 to 8202 feet) Display Rainy, cloudy, partly cloudy, sunny .
EN 25 Channel No. 1, 2, or 3 Unit ° C or ° F Radio-controlled clock Synchronization Auto or disabled Clock display HH:MM:SS Hour format 12hr AM/PM (MSF format) 24hr (DCF format) Calendar DD/MMM; wee.
EN 26 ADDITIONAL RESOURCES Visit our website (www.oregonscientific.com) to learn more about your new product and other Oregon Scientific products such as digital cameras, hand-held organizers, health and fitness gear, and weather stations.
EN 27 EC-DECLARATION OF CONFORMITY This product contains the approved transmitter module TX 07 and complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directives, if used for its intended use and that the following standard(s) has/have been applied: Radio frequency spectrum (Article 3.
デバイスOregon Scientific PS-M03Uの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Oregon Scientific PS-M03Uをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはOregon Scientific PS-M03Uの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Oregon Scientific PS-M03Uの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Oregon Scientific PS-M03Uで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Oregon Scientific PS-M03Uを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はOregon Scientific PS-M03Uの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Oregon Scientific PS-M03Uに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちOregon Scientific PS-M03Uデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。