ProFormメーカー831.210051の使用説明書/サービス説明書
ページ先へ移動 of 24
Patent Pending USERÕS MANUAL A pH testing kit (not included) is required for proper use and maintenance of this product. A pH testing kit can be pur- chased at any spa or pool supply store. CAUTION Read all precautions and instruc- tions in this manual before using this equipment.
T ABLE OF CONTENTS IMPORT ANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 IMPORT ANT SAFETY INSTRUCTIONS W ARNING: TO REDUCE THE RISK OF DROWNING, ELECTRIC SHOCK, OR SERIOUS INJUR Y , READ THE FOLLOWING IMPORT ANT PRECAUTIONS BEFORE USING THE RESTORA TION 5.
4 20. DANGERÑIf you will be using the hydrother- apy spa outside, do not bury the power cord; you should also keep the power cord away from lawn mowers, hedge trimmers, and other similar equipment. 21. W ARNINGÑThe hydrotherapy spa must be wired directly into a 240 volt power source equipped with a Ground Fault Circuit Interrupter (GFCI).
5 34. W ARNINGÑT o reduce the risk of injury or drowning: Consult your physician about pos- sible side-effects of any medications you may be taking before using the hydrotherapy spa. Heat from the water , in conjunction with some medications may cause drowsiness and increase the risk of drowning.
6 BEFORE YOU BEGIN Thank you for selecting the innovative PROFORM ¨ RESTORA TION 5.1 hydrotherapy spa. The RESTORA TION 5.1 hydrotherapy spa of fers the fea- tures and quality of a traditional hot tub at an afford- able price. Best of all, the RESTORA TION 5.
7 CHOOSING A LOCA TION FOR THE HYDROTHERAPY SP A There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the hydrotherapy spa.
8 SET -UP AND ASSEMBL Y Before beginning assembly , carefully read the following information and instructions: ¥ Place all parts in a cleared area and remove the packing materials from the spa shell; do not dis- pose of the packing materials until assembly is completed and the spa is in operation.
4. The RESTORA TION 5.1 is designed to operate with a 240 volt power source and must be wired directly to a 240 volt ground fault circuit interrupter (GFCI) installed in your home.
1. Remove the two indicated Control Unit Screws (19) and the two Small Star W ashers (8) from the cover on the Control Unit (14). Fold the cover down. Route the 240 volt AC power cord through the indi- cated opening on the right side of the Control Unit (14).
11 5. For a 40 amp 240 volt AC power supply , set the jumper J1 to pins 1 and 2 on the power board and leave the other jumpers at the factory settings, as shown at the right. This will allow the heater and the pump to operate at high speed simultaneously .
12 USING THE HYDROTHERAPY SP A The hydrotherapy spa is designed to seat five adults. The fifteen thera-jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control.
13 A A B B D C A E A D A B SP A SHELL DIAGRAM SP A OPERA TION Refer to the diagram above. The function of each component is explained below: The eight uni-directional thera-jets (A) are located on both sides of the spa. Five jets focus the water massage on your upper or lower back.
14 USING THE CONSOLE Refer to the console diagram above. The function of each console control is explained below: T emperature Display: During normal use this display shows the actual water temperature. When the Set T emp indicator is lit, the display shows the set temperature.
15 POSTING THE W ARNING SIGN The warning sign, shown below , must be posted on a wall or fence, where all users of the RESTORA TION 5.1 will be able to see it. Whenever the spa is moved, the sign must also be moved and reposted near the spa. ADJUSTING THE FIL TER CYCLE The spa filter cycle runs automatically to clean the water in the spa.
16 The hydrotherapy spa is designed to provide you with years of enjoyment. Please follow the guidelines below to properly maintain your hydrotherapy spa. MAINTENANCE SCHEDULE DAIL Y ¥ Check the water level and refill the spa to the level shown on page 9, step 5.
17 W A TER CHEMISTRY The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. (See TEST- ING AND TREA TING THE W A TER on page 12.) Additional chemicals can be purchased at a pool and spa supply store. CAUTION: The chemicals used to maintain the pH balance of the water and to sanitize the water can be dangerous.
18 T o drain the hydrotherapy spa, follow these steps: 1. Set the temperature control on the console to the lowest setting. 2. Shut off the circuit breaker or GFCI. 3. Remove the access cover from the back of the spa unit. 4. Remove the drainage hose from the clip and attach a garden hose to the valve on the drainage hose.
19 CHECKING AND CLEANING THE FIL TER The filter should be checked periodically for build-up of dirt and oil. T o check or clean the filter , it is neces- sary to remove the basket and the two filter car- tridges from the filter housing. Removing and Cleaning the Basket: 1.
20 1. SYMPTOM: THE SP A WILL NOT OPERA TE a. Check to see if the GFCI breaker is tripped, or was not turned on. Reset the GFCI breaker . b. Make sure the Heater Switch (7), located on the Control Unit (14) inside the pump compart- ment, is in the ÒONÓ position.
21 9. SYMPTOM: THE W A TER LEVEL DROPS a. Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wet- ness on the floor around the hydrotherapy spa, then the spa shell may have a leak. Contact your local spa and pool service provider for repairs.
22 P ART LISTÑModel No. 831.210051 R0698A Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notice. Key No. Qty .
1 2 2 3 4 5 6 9 12 13 14 15 16 17 18 32 31 29 30 25 26 11 8 19 19 8 8 7 28 21 27 33 3 23 23 22 20 25 34 37 36 35 24 19 EXPLODED DRA WINGÑModel No. 831.
Part No. 147145 J00594-C R0698A Printed in USA © 1998 Sears, Roebuck and Co. Model No. 831.210051 QUESTIONS? As a manufacturer , we are commit- ted to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee complete satisfaction through direct assistance from our factory .
デバイスProForm 831.210051の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
ProForm 831.210051をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはProForm 831.210051の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。ProForm 831.210051の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。ProForm 831.210051で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
ProForm 831.210051を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はProForm 831.210051の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、ProForm 831.210051に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちProForm 831.210051デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
