Remingtonメーカー104316-01の使用説明書/サービス説明書
ページ先へ移動 of 20
® ® IMPORTANT: Read and understand this manual before assembling or operating this chain saw. Improper use of saw can cause severe injury. Keep this manual for future reference.
2 097017 ELECTRIC CHAIN SA W ® SAFETY W ARNINGS BEFORE OPERATING SAW 1 . Read and understand this owner ’ s manual before operating chain saw . 2. W atch what you are doing. Use com- mon sense. Do not operate saw when you are tired. 3. Use chain saw for cutting wood only .
3 097017 OWNER’S MANUAL Kickback Safety Devices On This Saw This saw has a low-kickback chain and reduced kickback guide bar. Both items reduce the chance of kickback. Kickback can still occur with this saw. Properly install front hand guard. This item can reduce injuries from kickback.
4 097017 ELECTRIC CHAIN SA W ® CHAIN SA W NAMES AND TERMS Bucking Process of cutting a felled tree or log into lengths. Felling Process of cutting down a tree. Felling Cut Final cut when felling a tree. Make this cut on opposite side of tree from notching cut.
5 097017 OWNER’S MANUAL Power Cord Rear Hand Guard Rear Handle Front Hand Guard Guide Bar Spike Saw Chain Guide Bar Nose Scabbard Oil Cap Trigger Switch Lockout Motor Housing Figure 2 - Electric Chain Saw Oil Level Sight Hole (located on saw body, hidden by front handle) Front Handle PRODUCT IDENTIFICA TION UNP ACKING 1.
6 097017 ELECTRIC CHAIN SA W ® Mounting Stand-Outs Guide Bar Bolts Guide Bar Nuts Adjusting Hole Guide Bar Tapping Screw Saw Chain Cutting Edge Cutting Edge Towards Guide Bar Nose Front Hand Guard Dr.
7 097017 OWNER’S MANUAL PUSH TO SHARPEN INSTALLING AUTOMATIC CHAIN SHARPENER (Fast Sharp Models Only) 1. Screw automatic chain sharpener into threaded hole.
8 097017 ELECTRIC CHAIN SA W ® CUTTING WITH THE CHAIN SAW 1. Connect saw to extension cord. Con- nect extension cord to power supply . 2. Make sure section of log to be cut is not laying on ground. This will keep chain from touching ground as it cuts through log.
9 097017 OWNER’S MANUAL Figure 12 - Felling A Tree Direction of Fall 2" 1st Cut - Lower Notch Cut 2nd Cut - Upper Notch Cut Hinge 2 Inches 3rd Cut - Felling Cut WARNING: Do not cut all the way through tree. Leave about two inches of tree diameter un- cut directly behind felling notch (see Figure 12).
10 097017 ELECTRIC CHAIN SA W ® BUCKING A LOG Figure 14 - Bucking Log With Entire Length On Ground WARNING: Avoid kickback. Kickback can result in severe in- jury or death. See Kickback, page 3 to avoid risk of kickback. WARNING: • If on slope, make sure log will not roll down hill.
11 097017 OWNER’S MANUAL 1st Cut Figure 16 - Bucking Log When Log Is Supported On Both Ends 2nd Cut TRIMMING A TREE (Pruning) Figure 17 - Cutting A Limb WARNING: Avoid kickback. Kickback can result in severe in- jury or death. See Kickback, page 3 to avoid risk of kickback.
12 097017 ELECTRIC CHAIN SA W ® CLEANING SAW BODY CLEANING AND MAINTENANCE Guide Bar With Uneven Wear Figure 18 - Guide Bar Cross Section Show- ing Uneven Bar Wear Guide Bar Groove Guide Bar NOTICE: Below are instructions for servicing your chain saw.
13 097017 OWNER’S MANUAL WARNING: Unplug chain saw from power source before servic- ing. Severe injury or death could occur from electrical shock or body contact with moving chain. WARNING: Cutting edges on chain are sharp. Use protective gloves when handling chain.
14 097017 ELECTRIC CHAIN SA W ® PUSH TO SHARPEN Filing Cutter Depth Gauges The cutter depth gauge clearance is reduced as cutters are sharpened. After every second or third sharpening, reset cutter depth gauges. 1. Place depth gauge tool (.025") firmly across top of two cutters.
15 097017 OWNER’S MANUAL TROUBLESHOOTING WARNING: Unplug chain saw from power source before servicing. Severe injury or death could occur from electrical shock or body contact with moving chain. OBSERVED FAULT Saw runs, but does not cut. Saw does not cut unless heavily forced.
16 097017 ELECTRIC CHAIN SA W ® AUTHORIZED SER VICE CENTERS P AR TS CENTRALS Portable Heater Parts 342 North County Road 400 East Valparaiso, IN 46383 219-462-7441 1-800-362-6951 FBD 1349 Adams Street Bowling Green, KY 42103-3414 502-846-1199 1-800-654-8534 Lyons & Lyons Sales Co.
17 097017 OWNER’S MANUAL INDIANA (IN) Hutchens Sales and Service R.R. #5, Box 550 Bloomfield, IN 47424 812-876-1891 Nichols Ice & Oil 2018 Park Road Connersville, IN 47331 317-825-3741 B & W Repair Service 213 N. Main Street Dale, IN 47523 812-937-2576 Reggie's Small Engine Spec.
18 097017 ELECTRIC CHAIN SA W ® NEW JERSEY (NJ) Complete Saw Service 336 River Road Garfield, NJ 07026 201-478-7838 Nemeth's Mower Service 55 - 4th Ave. Haskell, NJ 07420 201-835-0080 Air & Electric Tool Service, Inc. 215 North 8th Street Kenilworth, NJ 07033 908-272-5567 Associated Industries Rd 38, Box 2486 Mt.
19 097017 OWNER’S MANUAL REPLACEMENT P AR TS AND ACCESSORIES WARNING: Use only replace- ment parts and accessories de- scribed in this manual. Use of other parts or accessories could damage saw or injure operator. Purchase these accessories and parts from your nearest dealer or service center.
097017-01 REV. X 5/98 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004 INTERNA TIONAL ELECTRIC CHAIN SAW LIMITED WARRANTY Always specify model and serial numbers when writing the factory. We reserve the right to amend these specifications at any time without notice.
デバイスRemington 104316-01の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Remington 104316-01をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRemington 104316-01の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Remington 104316-01の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Remington 104316-01で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Remington 104316-01を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRemington 104316-01の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Remington 104316-01に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRemington 104316-01デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
