AudiovoxメーカーAPS-996の使用説明書/サービス説明書
ページ先へ移動 of 20
Model APS-996 Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure.
Page 2 w Protected Push Button V alet/Override Switch w 7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / V alet / Arming w Intrusion Alert With Memory w Instant Siren Activation w Starter Disa.
Page 3 known as a code grabber , which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Y our Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the alarm system will not respond.
Page 4 þ Siren will not sound. If the siren sounds 3 chirps, then you have left a door , trunk, or hood lid ajar . Simply close the opened entry point to provide full protection o Doors Lock - Option.
Page 5 þ Any mild impact to the vehicle’ s glass will cause the alarm to sound a short series of warning tones. þ Any strong impact to the vehicle’ s glass will cause the alarm to trigger for the full 30 second alarm cycle.
Page 6 The LED will start flashing rapidly , indicating that the system is re-arming automatically . Open any door to suspend the automatic arming. þ Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence.
Page 7 When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational.
If the new code was accepted, the unit will report back the newly entered code, by flashing the LED, first indicating the 10ths digit, pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming.
1. Enter the vehicle and turn the ignition switch to the on position. NOTE: The siren will sound. 2. Within 5 seconds, press and release the pushbutton switch 1 time. 3. Within 5 seconds, turn the ignition switch off then on. 4. Within 5 seconds, press and release the pushbutton switch 1 time.
R F SHOCK SENSOR MODE SELECTION The way in which your alarm system reacts to threatening vibrations, created by attempts to enter the vehicle by breaking a window , is adjustable by the transmitter immediately after arming. There are 4 modes of operation that can be selected by the operator: 1.
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select a 2 hour start timer . After 10 seconds expire, the parking lights will flash and the siren will chirp 2 times confirming that the two hour start cycle is set.
the only means to keep the engine and engine fluids warm is to periodically start the engine. W ARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous car- bon monoxide fumes which can be harmful or fatal if prolonged expo- sure occurs.
o Remote Electric Trunk Release o Remote Car Starter o Remote Window Closure o Remote Garage Door Interface NOTE: In addition there may be a second optional feature connected to your system that when the same transmitter button is pressed and released 2 times within 3 seconds (double pressed), the second optional feature will acti- vate.
Page 14 ADDITIONAL REMOTE FUNCTION ( CHANNEL 6 ) Channel 6 is an alternate output that can be controlled by the unlock button of the transmitter , or by and independent button or combination of buttons.
Page 15 TRANSCEIVER ICONS AND THEIR INDICA TIONS When Disarmed, Press the Arm/Lock button to Lock and Arm the System. The Lock Icon is displayed on the LCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button to Unlock and Disarm the System.
The following trigger patterns will be displayed. Triggered and the entry attempt was made to one of the vehicle doors. Triggered and entry attempt was made to the vehicles hood or trunk. Triggered and entry attempt was made to the vehicles glass, or the vehicle has been hit or bumped hard enough to cause a response from the vibration detec- tor .
ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start.
If you require more frequent starting please refer to auto start up timer mode shown earlier in this guide. NOTE: T o insure accurate 24 Hour Start up, it is advisable to reset the start time periodically as time may drift slightly each day .
.
© 2002 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-6387 APS 996 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON S OL ID = V ALET MODE 3 FLASH.
デバイスAudiovox APS-996の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Audiovox APS-996をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAudiovox APS-996の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Audiovox APS-996の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Audiovox APS-996で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Audiovox APS-996を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAudiovox APS-996の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Audiovox APS-996に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAudiovox APS-996デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
