RheemメーカーGas Domestic Outdoor Water Heaterの使用説明書/サービス説明書
ページ先へ移動 of 32
This water heater must be installe d and serviced by an authorised person. Please leave this guide with the householder. Owners Guide and Installation Instructions Gas Domestic Outdoor Water Heater.
PA TE NTS This water heater may be protected b y one or more patents or regi stered designs. ® Registered trademark of Rhee m Australia Pty Ltd. ™ Trademark of Rheem Australia Pt y Ltd. Notice to Victorian Customers from the Victorian Plumbing Indust ry Commission.
3 CONTENTS HOUSEHOLDER – We recommend you read pages 4 to 13. The other pages are intended for the installer but may be of interest. About Your Water Heater ............................................................ 4 How Your Water Heater Works .
4 ABOUT YOUR WATER HEATER MODEL TYPE Congratulations for choosing a Rheem ® water heater. The model you have chosen is suitable for outdoor installation only. The model is either a 3 11 series Rheemglas ® , 314 series RheemPlus™ or 811 series Optima™ water heater.
ABOUT YOUR WATER HEATER 5 TEMPERATURE ADJUSTMENT The temperature adjusting dial is on the gas valve, located behind the access cover on the lower front of the water heater. A setting of ‘6’ will normally maintain the water temperature at about 60 ° C.
ABOUT YOUR WATER HEATER 6 • Do not store flammable or combustible mater ials near the water heater. Flammable liquids (such as petrol), newspapers and similar articles must be kept well away from the water heater and the flue terminal. • Do not use aerosols, stain remov ers and household chemicals near the water heater whilst it is working.
ABOUT YOUR WATER HEATER 7 HOW DO I KNOW IF THE WATER HEATER IS INST ALLED CORRECTLY? Installation requirements are shown on page 20. The w ater heater must be installed by an authorised person and the installation mu st comply with National Standards AS/NZS 3500.
8 HOW YOUR WATER HEATER WORKS Water is stored in a vitreous enamel lined steel cylind er and heated by a gas burner located under the cylinder. The heat produced by the burner is transferred to the water through the base of the cylinder and through the wall of a flue pipe which passes through the cent re of the cylinder.
9 REGULAR CARE TEMPERATU RE PRE SSU RE REL IEF VAL VE This valve is near the top of the water heater and is essential for its safe operation. It is possible for the valve to release a little water through the drain line during each heating period. This occurs as the water is heated and expands by approximately 1/50 of its volume.
REGULAR CARE 10 TEMPERATURE LIMITING VALVE A RheemPlus water heater is fitted with a temperature limiting valve at the hot water outlet. The valve is set to deliver water not exceeding 50 ° C. The valve should be checked for performance every twelve months.
11 SAVE A SERVICE CALL Check the items belo w before making a service call. You will be charged for attending to any condition or fault that is not related to manufacture or failure of a part.
SAVE A SERVICE CALL 12 WATER NOT HOT ENOUGH You may find that due to heavy hot water usage the water temperature may be lower than normally expected. WATER TEMPERATURE T OO HIGH A RheemPlus water heater is fitted with a temperature limiting valv e set to deliver water not exceeding 50 ° C.
SAVE A SERVICE CALL 13 EXPANSION CONTROL VALVE RUNNING If an expansion control valve is fitted in the cold water line to the wat er heater (refer to page 22 ) it may discharge a sm all quantity of water instead of the temperature pressure relief valve on the water heater.
14 INSTALLATION THIS WATER HEAT ER IS FOR OUTDOOR INSTALLATION ONLY. THIS WATER HEAT ER IS NOT SUITABLE FOR POO L HEATING. Check the water heater is suitable for the gas type available (refer to the rating label on the water heater).
INSTALLATION 15 The water heater is to be installed at gro und level on a concrete or brick plinth (fire proof base) and must stand vertically upright with the back of t he water heater against an external wall or alternatively against a fireproof screen extending at least 500 mm above, below and either side the flue terminal.
INSTALLATION 16 TANK WATER SU PPLY If the water heater is supplied with water from a tank sup ply, then the bottom of the supply tank must be at least 1 m above the highest hot water outlet. Take care to avoid air locks. The cold water line to the water heater should be adequately sized and fitted with a full flow gate valve or ball valve.
INSTALLATION 17 A RheemPlus water heater will not deliver temperatures exceeding 50 ° C, in accordance with AS 3498. There is no statutory requirement to fit a temperature limiting device if this water heater is installed in other than an early childhood centre, school, nursing home or a facility for young, aged, sick or disabled people.
INSTALLATION 18 These conditions may result in either water at a temperature exceeding the requirements of AS/NZS 3500.4 being delivered to the hot water outlets in the ablution areas, or the device closing completely and not delivering water at all, or the device failing.
INSTALLATION 19 SADDLING - PIPE WO RK To prevent damage to the cylinder when attaching pipe clips or saddles to the water heater jacket, we recommend the use of self-drilling scre ws with a maximum length of 12 mm. Should pre drilling be required, extreme caution must be observed when penetrating the jacket of the water heater.
INSTALLATION 20 TYPICAL INSTALLATION – OUTDOOR LOCATION Gas Details Hourly Gas Consumption (MJ) Min. Gas Pressure (kPa) Test Point Gas Pressure (kPa) Max. Gas Pressure (kPa) 090 135 170 090 to 170 090 135 170 090 to 170 Natural 30 35 40 1.13 1.00 1.
INSTALLATION 21 DIMENSIONS AND TECHNICAL DATA Rheemglas and Optima RheemPlus Rheemglas Optima RheemPlus 311 090 -- -- 311 135 811 135 314 135 311 170 811 170 314 170 Storage capacity litres 85 130 160.
22 CONNECTIONS – PLUMBING CONNECTIO N SIZ ES Rheemglas, Optima RheemPlus • Hot water connection: RP ¾/20 G ¾ B • Cold water connection: RP ¾/20 G ¾ B • Relief valve connection: RP ½/15 RP.
CONNECTIONS – PLUMBING 23 GAS INLET The gas connection is made through the grommet in the left hand side panel to the gas control. The pipe work must b e cleared of foreign matter before connection and purged before attempting to light the water heater.
CONNECTIONS – PLUMBING 24 RELIEF VALVE DRAIN A copper drain line must be fitted to the relief valve to c arry the discharge clear of the water heater.
25 COMMISSIONING TO FILL AND TURN ON THE WATER HE ATER The gas pilot or burner must not be lit until the water heater is filled w ith wat er . • Open all of the hot water taps in the house (don’t forget the shower). • Open the cold water isolation valve fully to the water heater.
26 LIGHTING THE WATER HEATER FOR YOUR SAFETY RE AD BEFORE LIGHTING Warning: This gas water heater is designed to operat e reliably and safely as long as the operating instructions are followed exactly . You must comply with these lighting instructions at every stage.
LIGHTING THE WATER HEATER 27 LIGHTING INSTRUCTIONS Using the gas control light the water heater as follows: 1. Stop , read the safety information on page 26. 2. Turn the gas control knob fully clockwise to the “ z ” (off) position. 3. Wait five (5) minutes so any build up of unburnt gas can escape.
LIGHTING THE WATER HEATER 28 TEST THE WATER HEATER AFTER INSTALLATION • The operation of the water heater must be thoroughly checked by the installer. • The burner flame must light smoothly and quickly from the pilot flame, and must go out quietly and completely.
LIGHTING THE WATER HEATER 29 CLOSE DOWN PROCEDU R E 1. Turn the gas control knob to the “ · ” position (pilot). This setting will leave the pilot flame alight however the main burner will not be able to light. 2. Turn the gas control knob to the " z " (off) position.
30 WATER SUPPLIES Your water heater is manufactured to suit the water conditions of most Australian metropolitan supp lies. However, there are some known water su pplies which can have detriment al effects on the wate r heater a nd its operation a nd/or life expectancy.
31 RHEEM MAINS PRESSURE WATER HE ATER WARRANTY – AUSTRALIA ONLY – WARRANTY CONDITIONS 1. This warranty is applicable only to water heaters manufactured from 1 st September 2005.
RHEEM MAINS PRESSURE WATER HE ATER WARRANTY – AUSTRALIA ONLY – 32 WARRANTY Rheem will: a) Repair or, if necessary replace any Rheem water heater; or b) Replace any component (or, if necessary, arr.
デバイスRheem Rheem Gas Domestic Outdoor Water Heaterの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Rheem Rheem Gas Domestic Outdoor Water Heaterをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはRheem Rheem Gas Domestic Outdoor Water Heaterの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Rheem Rheem Gas Domestic Outdoor Water Heaterの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Rheem Rheem Gas Domestic Outdoor Water Heaterで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Rheem Rheem Gas Domestic Outdoor Water Heaterを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はRheem Rheem Gas Domestic Outdoor Water Heaterの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Rheem Rheem Gas Domestic Outdoor Water Heaterに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちRheem Rheem Gas Domestic Outdoor Water Heaterデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
