AudiovoxメーカーDV1201の使用説明書/サービス説明書
ページ先へ移動 of 39
C D PLAYBACK R CD-R 1 STS9 2 I B Cove r Size : 14 8x 21 0 mm.
E - 1 Important Safety Instructions WARNING: T O PREVENT FIRE OR SHOCK HAZARD , DO NO T EXPOSE THIS APPLIANCE T O RAIN OR MOISTURE. CA UTION: T O PREVENT ELECTRIC SHOCK, MA TCH WIDE BLADE OF PLUG T O WIDE SLO T , FULL Y INSER T . WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).
E - 2 Important Safety Instructions 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference.
E - 3 Table of Contents Important Safety Instruction ..................... 1-2 Disc Formats ................................................ 4 Before You Start ........................................... 5 Using the remote control ....................
E - 4 The unit can playback discs bearing any of the following marks: Region Management Information Region Management Information: This unit is designed and manufactured to respond to the Region Management Information that is encoded on DVD discs.
E - 5 Before You Start To install Batteries 1. Open the battery door. Battery Replacement When batteries become weak, the operating distance of the Remote Control is greatly reduced and you will need to replace the batteries.
E - 6 Parts and Functions (Continued on next page) Remote Control 1) FUNCTION button Display the FUNCTION screen where you can check or change various setting. 2) PREV button Move reverse through titles, chapters or tracks on a disc. Tune to the presetted stations.
E - 7 Parts and Functions Remote Control (Continued on next page) 1 8) STANDBY / ON [ I / ] button Turns the Unit on and puts it in standby mode. 19) NEXT button Move forward through titles, chapters or tracks on a disc. Tune to the presetted stations.
E - 8 Rear Panel Front and Top Panel Parts and Functions Note: Screen saver - If no button is pressed within 2 minutes, the function will active. If you want to return the normal screen, press any button.
E - 9 Region (Local) Number Error Indicator If the region (local) number of the disc that you attempt to play differs from the region number of the Unit. "Invalid Region" appears on the TV screen. (The disc cannot be played). If no disc is loaded when the Main Unit is switched on.
E - 10 Setup (continued to next page) FM Connect FM antenna (supplied) to the FM ANTENNA jacks. AM(MW) Connect the loop antenna (supplied) to the AM(MW) LOOP ANTENNA terminals. For better reception A. Connecting your TV The unit can be connected to your TV in several different ways, depending on the design of your TV.
E - 11 Setup (continued to next page) or Component video outputs (DVD) Some TVs or monitors are equipped with component video inputs. Using the Audio cable (not supplied), connect the left/right AUDIO.
E - 12 Setup B. Connecting a VCR 1. Using the supplied Audio/Video cable, connect the yellow plug from VIDEO OUT jack on your Unit to VIDEO IN jack on your T V , connect the left and right AUDIO OUT jacks on your Unit to AUDIO IN jacks on your T V.
E - 13 Setup (continued to next page) D. Connecting the speakers & subwoofer The speaker cords have been color-coded to simplify connection. Just plug the POSITIVE (+) and NEGATIVE (-) ends of eac.
E - 14 Setup Turning on the Unit and TV 1) Press the STANDBY/ON button to turn the Unit ON, or 2) Press the I / STANDBY/ON button on the remote control or the FUNCTION button or the PL AY Y button to turn on the Unit while the Unit is in standby mode.
E - 15 Adjusting the Sound (continued to next page) To adjust the surround sound balance while Dolby Digital and Pro Logic II decoding is in effect Use the remote control to make the following changes.
E - 16 Adjusting the Sound The following table shows which speakers are working in the various modes. 5.1 - Represents FRONT LEFT/RIGHT, REAR LEFT/RIGHT, CENTER speakers and SUBWOOFER 2.
E - 17 (continued on next page) Playing a Disc DVD CD This owner’s manual explains the basic instructions of this DVD Unit. Some DVD discs are produced in a manner that allows specific or limited operation during playback. As such, the DVD Unit may not respond to all operating commands.
E - 18 (continued on next page) Fast Forward/Fast Reverse 1 . Press the TUNING or TUNING button when a disc is playing. • The disc begins fast scan at x2 speed. • Four speeds are available. Each time TUNING or TUNING button is pressed, the speed of fast scan changes in the following sequence: 2.
E - 19 DVD Angle selection Some DVDs contain scenes which have been shot from a number of different angles. For these discs, the same scene can be viewed from each of these different angles. 1. While you are playing a DVD with different angles recorded, press the ANGLE button to view the number of the current angle.
E - 20 DVD 00:09:29 01:25: 27 Title 1/10 Chapter 3/15 Angle 1/3 Audio Subtitle 2/3 Spa BitRate 7.1 Mbps Special Functions DVD DISPL AY function Using DISPL AY , you can check and change the current settings of the following items: ANGLE, AUDIO and SUBTITLE.
E - 21 Locating a specific title If a DVD disc contains title numbers, you can locate a specific title by directly selecting a title number. 1. In stop mode, press the GOTO button. 2. Press , or button to highlight a specific field and press the corresponding number button(s) for the title you want.
E - 22 DVD CD Locating a specific time Y ou can move to a specific location by entering its corresponding time (hours, minutes, seconds). 1. Press the GOTO button. 2. Press or button to highlight time. 3. Press the corresponding number buttons for the setting point you want.
E - 23 Programmable memory The two types of programmed playback provided by this Unit are title programmed playback and chapter programmed playback. Title / Chapter programmed playback 1. Press the MEMORY button while the disc is stopped. 2. Enter the title numbers in - - .
E - 24 Y ou can play a specific title or chapter repeatedl y. (Title repeat, chapter repeat, A-B repeat) Repeating a title Y ou can play the same title repeatedl y. 1. While the disc is playing, press the REPE AT DISC button until the “ Repeat Title ” indicator displays on the screen.
E - 25 This Unit will play MP3 and Picture files recorded on CD-R disc . Playing a MP3 file disc 1. Press the OPEN/CLOSE button, the disc tray opens. 2. Insert a MP3 file disc on the disc tray with the label side up. 3. Press the OPEN/CLOSE button, the disc tray closes.
E - 26 Playing MP3 and Picture File Disc Playing a Picture file disc 1. Press the OPEN/CLOSE button, the disc tray opens. 2. Insert a Picture CD on the disc tray with the label side up. 3. Press the OPEN/CLOSE button, the disc tray closes. 4. The unit will take a short while to load the disc.
E - 27 LANGUAGE setting 1. Press the FUNCTION button until DVD appears on the displa y. 2. Press the STOP button so that no disc is playing. 3. Press the SETUP button. 4. Use or button to select the Language, then press the ENTER button. 5. Use or button to English, then press the ENTER button.
E - 28 4:3 Pan Scan • When wide-screen video material is played, this mode clips the right and left sides of the image so that it can be viewed on a conventional TV screen. • Some wide-screen DVDs that do not permit Pan Scan mode playback are automatically played in letterbox mode (black bands top and bottom).
E - 29 Customizing the Function Settings Brightness 1. Press the SETUP button. 2. Use or button to select Video, then press the ENTER button. 3. Use or button to select Brightness, and then press the ENTER button. 4. Use or button to shift and select the Off/On, then press the ENTER button.
E - 30 AUDIO setting Digital Out 1. Press the SETUP button. 2. Use or button to select Audio, press the ENTER button. 3. Use or button to select Digital Out, and then press the ENTER button repeatedly to select Digital Out type. 4. T o exit the FUNCTION SETUP MENU and return to the normal screen, press the RETURN button.
E - 31 (continued on next page) Subwoofer 1. Press the SETUP button. 2. Use or button to select the Audio, press the ENTER button. 3. Use or button to Subwoofer, and then press the ENTER button. 4. Use or button to select the desired setting, and then press the ENTER button.
E - 32 Pink noise 1. Press the SETUP button. 2. Use or button to select the Audio, press the ENTER button. 3. Use or button to Pink noise, and then press the ENTER button. 4. Use or button to select the desired setting, and then press the ENTER button.
E - 33 Customizing the Function Settings RATING setting Password/Parental lock DVD discs equipped with the password function are rated according to their content. The contents allowed by a parental lock level and the way a DVD disc can be controlled may vary from disc to disc.
E - 34 Factory Set If you want to return the initial language setting to the factory default, do the following: 1. Press the SETUP button. 2. Use or button to select the Rating, then press the ENTER button. 3. Use or button to shift and select the Factory Set, then press the ENTER button.
E - 35 Tuning into a station manually 1. Press the FUNCTION button until the frequency band appears on the displa y. 2. Press the BAND button on the remote remote or STOP button on the front panel to select the desired band. 3. Press the TUNING button to tune in the desired station.
E - 36 Code AA AB AF AM AR AS AY AZ BA BE BG BH BI BN BO BR CA CO CS CY DA DE DZ EL EN EO ES ET EU FA FI FJ FO FR Code FY GA GB GL GN GU HA HI HR HU HY IA IE IK IN IS IT IW JA JI JW KA KK KL KM KN KO .
E - 37 Cleaning the Unit • Be sure to turn the Unit off and disconnect the AC power cord before maintaining the Unit. • Wipe the Unit with a dry soft cloth. If the surfaces are extremely dirt y , wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung out thoroughl y , then wipe with a dry cloth.
E - 38 SYMPTOM CAUSE (AND REME DY) • Check that the speakers and equipment are connected securel y. • Make sure that you've selected the corrected equipment on the system. • The system is in pause mode or in Slow-motion Play mode. Press the PL AY button to return to normal play mode.
デバイスAudiovox DV1201の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Audiovox DV1201をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAudiovox DV1201の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Audiovox DV1201の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Audiovox DV1201で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Audiovox DV1201を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAudiovox DV1201の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Audiovox DV1201に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAudiovox DV1201デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
