AudiovoxメーカーXR9000の使用説明書/サービス説明書
ページ先へ移動 of 20
128-7863 1 of 20 Page 1 Model XR9000 Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure.
128-7863 2 of 20 Page 2 Additional Engine Immobilizer Output, (Optional Relay Required) T rue Last Door Arming (Hardwire Only) Defective Zone By-Pass Defective Zone Chirp Confirmation .
128-7863 3 of 20 Page 3 simply press button 1, (lock), two times within a one second time period. The system will now respond to that transmitter each time a button is pressed. NOTE: This system is custom configurable and can be set up to operate with a number of options controlled from any transmitter button or button com- bination.
128-7863 4 of 20 Page 4 Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the sys- tem will turn on the headlights when the system is armed.
128-7863 5 of 20 Page 5 transmitter button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock.
128-7863 6 of 20 Page 6 WARNING SIGNALS section of this manual to identify which zone was triggered. Doors Unlock - Optional 2 S tep Doors Unlock - Optional NOTE: If the optional Headlamp illu.
128-7863 7 of 20 Page 7 1. Open the vehicle door . The alarm will sound. 2. Turn the ignition key to the on position. 3. Within 5 seconds, press and release the PBLED override switch. The alarm system will stop sounding and enter the (bypassed) mode. Y ou can now start and operate the vehicle normally .
128-7863 8 of 20 Page 8 (As per the example, press and release 2 times to set the units digit to 2). 8. Turn the ignition switch to the off position. Immediately observe the LED flash pattern. Y ou will note the LED flashing five times, pause, and then flash two times, pause.
128-7863 9 of 20 Page 9 again for 3 seconds. If the button is not pressed, the alarm will automatically stop after 30 seconds. Also if any transmitter button other than the Lock or Unlock button is pressed and released, the Panic mode will be turned off immediately.
128-7863 10 of 20 Page 10 programmed, simply press the lock button of your keychain transmitter anytime during the remote start cycle. The shock sensor will be shunted for the entire run cycle and will resume normal operation after the remote start unit shuts off.
128-7863 11 of 20 Page 11 2. Depress the brake pedal. 3. Open the hood. 4. Place the system in the Remote S tart Override mode. 5. Race the engine to above 4000 RPM. OPERA TING ON AUT OMA TIC ST ART UP TIMER MODE Y our system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period.
128-7863 12 of 20 Page 12 NOTE: The feature that has been added to channel 3 will always be activated using the same transmitter button that remotely starts the vehicle. There is no way to move the channel 3 function to a different transmitter button.
128-7863 13 of 20 Page 13 1) Place the gear selector in park. 2) Set the parking, (hand), brake. 3) Be certain your foot is off the brake pedal. 4) Press the program/Push-Button switch 2 times within 5 seconds. The parking lights will flash two times indicating the mode was successfully en- tered.
128-7863 14 of 20 Page 14 When the Panic Mode has been activated and the system is armed the vehicle's lights will flash, the siren and lock icon will be displayed on the LCD screen and the siren will beep.
128-7863 15 of 20 Page 15 the door is closed or the zone clears, the transmitter will chirp 1 time, and the display will clear . When the vehicle is armed, and the hood or trunk, is opened or ajar , the transmitter will chirp 3 times, the lights will flash, and the display will indicate a hood or trunk trigger as shown on the previous page.
128-7863 16 of 20 Page 16 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start.
128-7863 17 of 20 Page 17 activated at the vehicle, you can toggle the feature on simultaneously pressing the Lock + Option buttons of the transmitter . The 24 hour icon will appear and the transmitter will emit a tone confirming the feature is active.
128-7863 18 of 20 Page 18 Battery Indicator: Y our transmitter has a battery indicator that is shown in the upper right corner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deteriorates, the bars will disap- pear .
128-7863 19 of 20 Page 19.
128-7863 20 of 20 Page 20 XR9000 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INT RUSI ON ZON E 3 2 FLASH...P AUSE = INT RUSI ON ZON E 2 1 FLASH.
デバイスAudiovox XR9000の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Audiovox XR9000をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはAudiovox XR9000の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Audiovox XR9000の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Audiovox XR9000で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Audiovox XR9000を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はAudiovox XR9000の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Audiovox XR9000に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちAudiovox XR9000デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。