Snapperメーカー155223の使用説明書/サービス説明書
ページ先へ移動 of 40
Safety Instructions & Operator's Manual for TWO STAGE INTERMEDIATE FRAME SNOW THROWER SERIES 3 MODELS 155223 17243 MODEL NUMBER EXPLANATION MODEL DESIGNATION ENGINE HP II Iss122131 I I SERIES DESIGNATION AUGER WIDTH I - Intermediate Frame Model 55 - 5.
IMPORTANT SAFETY INSTRUCTIONS WARNING: This powerful machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following instructions may result in serious injury to the operator or other persons.
IMPORTANT SAFETY INSTRUCTIONS OPERATIONAL PRECAUTIONS (Continued From Previous Page) 7. DO NOT put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times. 8. Start engine only where exhaust fumes will be safely dissipated.
TABLE OF CONTENTS SECTION 1 - IMPORTANT SAFETY INSTRUCTIONS .......................... 2-3 TABLE OF CONTENTS ............................................................................ 4 SECTION 2 - OPERATING INSTRUCTIONS ............................
Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check engine oil and add oil as needed to bring level up to the FULL mark. Refer to engine owner's manual for oil specifications 2.
Section 2 - OPERATING INSTRUCTIONS 2.2 STARTING, OPERATION & STOPPING (RECOIL START MODELS) (Go to Page 8 for Electric Start Models) 2.2.1. ENGINE 1. Turn fuel shut off valve to the "ON" position. See Figure 2.3. TURN VALVE TO "ON" POSITION FIGURE 2.
Section 2 - OPERATING INSTRUCTIONS Objects can be thrown by the snow thrower while it is in operation. Thrown objects could cause serious injury to the operator or bystanders. Always wear safety goggles or other suitable eye protection. Keep people and pets away from area.
Section 2 - OPERATING INSTRUCTIONS 2.2 STARTING, OPERATION & STOPPING (ELECTRIC START MODELS) (Go to Page 6 for Recoil Start Models) DO NOT use an electrical extension cord that is damaged. A damaged electrical extension cord could cause a shock or fire.
Section 2 - OPERATING INSTRUCTIONS WARNING Objects can be thrown by the snow thrower while it is in operation. Thrown objects could cause serious injury to the operator or bystanders. Always wear safety goggles or other suitable eye protection. Keep people and pets away from area.
Section 3 - MAINTENANCE DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. 3.1 INTRODUCTION To retain the quality of the snow thrower, use only genuine SNAPPER replacement parts.
Section 3 - MAINTENANCE 3.4 ANNUALLY (END OF EACH SEASON) Perform all maintenance as described in the maintenance schedule. 3.4.1. Engine Refer to engine owner's manual for service instructions. 3.4.2. Spark Plug Refer to engine owner's manual for service instructions.
Section 4 - REPAIR & ADJUSTMENTS DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. 4.1 AUGER and WHEEL DRIVE BELT ADJUSTMENT/REPLACEMENT When operating machine release the auger clutch control.
Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank.
Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank.
Section 4 - REPAIR & ADJUSTMENTS 4.1.5. GROUND SPEED ADJUSTMENT NOTE: It is recommended to remove the drive system cover and check rubber drive tire engagement with drive disc when adjusting ground speed. 1. Tilt machine forward to gain access to drive system area.
Section 4 - REPAIR & ADJUSTMENTS 4.1.8. SINGLE HANDLE CONTROL ADJUSTMENT (7 HP Models Only) IMPORTANT: Standing in the operator's position, the left handle bar lever is for wheel drive engagement and disengagement. The right handle bar lever is for auger/impeller engagement and disengagement.
Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank.
PROBLEM Engine Will Not Start Using Recoil Starter Engine Will Not Start Using Electric Starter Engine Stalls or Stops After Running Engine Loses Power Excessive Vibration Poor Snow Discharging TROUBLESHOOTING 1. 2. 3. 4. 1 2. 3. 1 2. 3. 4. 5. 1 2. 3.
3 YEAR LIMITED WARRANTY For three (3) years from purchase date for the original purchaser's residential, non-commercial use, SNAPPER, through any authorized SNAPPER dealer will replace, free of c.
Safety Instructions & Operator's Manual for TWO STAGE INTERMEDIATE FRAME SNOW THROWER SERIES 3 ® IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings.
Safety Instructions & Operator's Manual for TWO STAGE INTERMEDIATE FRAME SNOW THROWER SERIES 3 MODELS 155223 17243 MODEL NUMBER EXPLANATION MODEL DESIGNATION ENGINE HP II Iss122131 I I SERIES DESIGNATION AUGER WIDTH I - Intermediate Frame Model 55 - 5.
IMPORTANT SAFETY INSTRUCTIONS WARNING: This powerful machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following instructions may result in serious injury to the operator or other persons.
IMPORTANT SAFETY INSTRUCTIONS OPERATIONAL PRECAUTIONS (Continued From Previous Page) 7. DO NOT put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times. 8. Start engine only where exhaust fumes will be safely dissipated.
TABLE OF CONTENTS SECTION 1 - IMPORTANT SAFETY INSTRUCTIONS .......................... 2-3 TABLE OF CONTENTS ............................................................................ 4 SECTION 2 - OPERATING INSTRUCTIONS ............................
Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check engine oil and add oil as needed to bring level up to the FULL mark. Refer to engine owner's manual for oil specifications 2.
Section 2 - OPERATING INSTRUCTIONS 2.2 STARTING, OPERATION & STOPPING (RECOIL START MODELS) (Go to Page 8 for Electric Start Models) 2.2.1. ENGINE 1. Turn fuel shut off valve to the "ON" position. See Figure 2.3. TURN VALVE TO "ON" POSITION FIGURE 2.
Section 2 - OPERATING INSTRUCTIONS Objects can be thrown by the snow thrower while it is in operation. Thrown objects could cause serious injury to the operator or bystanders. Always wear safety goggles or other suitable eye protection. Keep people and pets away from area.
Section 2 - OPERATING INSTRUCTIONS 2.2 STARTING, OPERATION & STOPPING (ELECTRIC START MODELS) (Go to Page 6 for Recoil Start Models) DO NOT use an electrical extension cord that is damaged. A damaged electrical extension cord could cause a shock or fire.
Section 2 - OPERATING INSTRUCTIONS WARNING Objects can be thrown by the snow thrower while it is in operation. Thrown objects could cause serious injury to the operator or bystanders. Always wear safety goggles or other suitable eye protection. Keep people and pets away from area.
Section 3 - MAINTENANCE DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. 3.1 INTRODUCTION To retain the quality of the snow thrower, use only genuine SNAPPER replacement parts.
Section 3 - MAINTENANCE 3.4 ANNUALLY (END OF EACH SEASON) Perform all maintenance as described in the maintenance schedule. 3.4.1. Engine Refer to engine owner's manual for service instructions. 3.4.2. Spark Plug Refer to engine owner's manual for service instructions.
Section 4 - REPAIR & ADJUSTMENTS DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. 4.1 AUGER and WHEEL DRIVE BELT ADJUSTMENT/REPLACEMENT When operating machine release the auger clutch control.
Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank.
Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank.
Section 4 - REPAIR & ADJUSTMENTS 4.1.5. GROUND SPEED ADJUSTMENT NOTE: It is recommended to remove the drive system cover and check rubber drive tire engagement with drive disc when adjusting ground speed. 1. Tilt machine forward to gain access to drive system area.
Section 4 - REPAIR & ADJUSTMENTS 4.1.8. SINGLE HANDLE CONTROL ADJUSTMENT (7 HP Models Only) IMPORTANT: Standing in the operator's position, the left handle bar lever is for wheel drive engagement and disengagement. The right handle bar lever is for auger/impeller engagement and disengagement.
Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any adjustments, maintenance, service, or repairs, with engine running. Stop auger. Stop engine. Remove key. Disconnect spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank.
PROBLEM Engine Will Not Start Using Recoil Starter Engine Will Not Start Using Electric Starter Engine Stalls or Stops After Running Engine Loses Power Excessive Vibration Poor Snow Discharging TROUBLESHOOTING 1. 2. 3. 4. 1 2. 3. 1 2. 3. 4. 5. 1 2. 3.
3 YEAR LIMITED WARRANTY For three (3) years from purchase date for the original purchaser's residential, non-commercial use, SNAPPER, through any authorized SNAPPER dealer will replace, free of c.
Safety Instructions & Operator's Manual for TWO STAGE INTERMEDIATE FRAME SNOW THROWER SERIES 3 ® IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contain very important emissions information and critical safety warnings.
デバイスSnapper 155223の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Snapper 155223をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSnapper 155223の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Snapper 155223の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Snapper 155223で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Snapper 155223を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSnapper 155223の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Snapper 155223に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSnapper 155223デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
