SonyメーカーNWZ-X1051の使用説明書/サービス説明書
ページ先へ移動 of 34
SER VICE MANUAL Sony Corporation Audio&Video Business Group Published by Sony T echno Create Corporation SPECIFICA TIONS DIGIT AL MEDIA PLA YER 9-889-490-01 2009E05-1 © 2009.05 US Model NWZ-X1051/X1061 Canadian Model T aiwan Model NWZ-X1060 AEP Model UK Model E Model Australian Model Chinese Model T ourist Model NWZ-X1050/X1060 V er .
NWZ-X1050/X1051/X1060/X1061 2 Maximum recordable number of photos that can be transferred (Approx.) Max. 20,000 Record able num ber of photos may be less depending on le sizes. Capacity (User available capacity) * 1 NWZ-X1050: 16 GB (Ap prox. 14.6 GB = 15,775,629,312 byt es) NWZ-X1060: 32 GB (Ap prox.
NWZ-X1050/X1051/X1060/X1061 3 1. SERVICING NOTES ............................................. 3 2. DISASSEMBL Y 2-1. Disassembly Flow ........................................................... 8 2-2. Panel (Rear) ....................................
NWZ-X1050/X1051/X1060/X1061 4 NOTE THE MAIN BOARD REPLACING When the MAIN board is replaced, process it according to the fol- lowing. 1. Format F ormat Y ou ca n forma t the built-in ash memory of the play er . Notes x If the memory is formatted, all da ta (songs, videos, photos, etc.
NWZ-X1050/X1051/X1060/X1061 5 Note: The MAC address of this set was changed along with this repair . Please set it again if you are using the MAC address fi ltering function of access point device of connection destination. Please refer to the operation guide of this set for the con fi rm method of MAC address con fi rming.
NWZ-X1050/X1051/X1060/X1061 6 MEMO.
NWZ-X1050/X1051/X1060/X1061 7 METHOD OF JUDGING RIGHT AND WRONG OF P ARTS RELA TED TO SWITCH In this set, only a part of parts that relate to the switch are supplied. Exchange the entire mounted board when parts that do not corre- spond to it are defective.
NWZ-X1050/X1051/X1060/X1061 8 SECTION 2 DISASSEMBL Y • This set can be disassembled in the order shown below . 2-1. DISASSEMBL Y FLOW 2-2. P ANEL (REAR) (Page 9) SET 2-3. HOLD ASSY (Page 9) 2-4. MAIN BOARD ASSY (INCLUDING BA TTERY ASSY) (Page 10) 2-5.
NWZ-X1050/X1051/X1060/X1061 9 Note: Follow the disassembly procedure in the numerical order given. 2-2. P ANEL (REAR) Note 1 : This illustration sees the set from rear side. 2-3. HOLD ASSY Note: This illustration sees the set from rear side. 1 two screws (M1.
NWZ-X1050/X1051/X1060/X1061 10 2-4. MAIN BOARD ASSY (INCLUDING BA TTERY ASSY) Note: This illustration sees the set from rear side. 2-5. BA TTERY ASSY (BA TT1), MAIN BOARD Note: This illustration sees the MAIN board from battery assy side. 6 two screws (M1.
NWZ-X1050/X1051/X1060/X1061 11 2-6. 5PIN HP JACK ASSY (J001), CHASSIS SECTION Note 1 : This illustration sees the set from rear side. 1 two screws (M1.4) 5 two screws (M1.4) 7 chassis section 2 holder (jack) 3 5pin HP jack assy (J001) 4 insulation sheet (O-FPC) 6 Open the EL indicator element in the direction of the arrow .
NWZ-X1050/X1051/X1060/X1061 12 2-7. KEY FLEXIBLE PRINT BOARD (FPC1), CHASSIS 2-8. EL INDICA TOR ELEMENT (EL01) Note: This illustration sees the set from rear side.
NWZ-X1050/X1051/X1060/X1061 13 2-9. HOME KEY BOARD, GUARD (MUL TI) Note: This illustration sees the set from rear side. 2-10. BUTTON (VOL), KNOB (NC) Note: This illustration sees the set from rear side. 4 HOME KEY board is lightiy pushed from button side.
NWZ-X1050/X1051/X1060/X1061 14 2-1 1. TOUCH P ANEL MODULE (TPM1), FRAME 6 touch panel module (TPM1) 1 spacer (window) 2 Peel off touch panel module flexible board.
NWZ-X1050/X1051/X1060/X1061 15 SECTION 3 TEST MODE 1. SETTING THE TEST MODE Note: Perform the test mode in the state of 3.6 V or more in the battery voltage. Setting method: 1. T urn the power on. 2. Press the [HOME] key , the home menu is displayed. 3.
NWZ-X1050/X1051/X1060/X1061 16 4-1-3. Standby current check (DSVCHK) This mode is used in case standby current is checked. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “POWER”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 17 4-2-1. Output check (OUTPUT) “1 kHz 0 dBs L-ch/R-ch VOLUME: 25” audio signal is outputted. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “AUDIO”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 18 4-2-5. CH separation (L-ch) check (SEPLR) “1 kHz 0 dBs L-ch VOLUME: 25” audio signal is outputted. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “AUDIO”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 19 4-2-9. Sound pressure regulation level check (SPCHK) “1 kHz 0 dBs L-ch/R-ch VOLUME: 30” audio signal is outputted. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “AUDIO”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 20 4-2-13. User speci fi cation contents playback 3 (USER3) “/User3.oma” is reproduced. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “AUDIO”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 21 4-3-3. User speci fi cation contents playback 2 (USER2) “/User2.mp4” is reproduced. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “VIDEO”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 22 4-4-2. Key check (KEY) The operation of the key is con fi rmed. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “OTHER”, and press the [ u ] key to enter the minor item. 3. Press the [ > ]/[ .
NWZ-X1050/X1051/X1060/X1061 23 4-4-9. NAND capacity check (NCAPCHK) Capacity of NAND fl ash memory , present bad block, maximum bad block, and vender ID are displayed. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “OTHER”, and press the [ u ] key to enter the minor item.
NWZ-X1050/X1051/X1060/X1061 24 4-7-1. Consecutive no-modulation Wi-Fi transmission (TX (CW)) Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “WIFI”, and press the [ u ] key to enter the minor item. 3. Press the [ > ]/[ .
NWZ-X1050/X1051/X1060/X1061 25 4-7-5. Wi-Fi power setting (POWER) Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ . ] key to select the “WIFI”, and press the [ u ] key to enter the minor item. 3. Press the [ > ]/[ . ] key to select the “POWER”.
NWZ-X1050/X1051/X1060/X1061 26 4-8. FM Screen display MPT APP (X.XX.XX) POWER AUDIO VIDEO OTHER CLESTE DAC WIFI FM — RCVCHK NC SHUTDOWN EXITTEST 4-8-1. Reception output check (RCVCHK) FM tuning checked. Checking method: 1. Enter the test mode. 2. Press the [ > ]/[ .
NWZ-X1050/X1051/X1060/X1061 NWZ-X1050/X1051/X1060/X1061 27 27 SECTION 4 DIAGRAMS 4-1. SCHEMA TIC DIAGRAM For Schematic Diagrams. Note: • All capacitors are in μ F unless otherwise noted. (p: pF) 50 WV or less are not indicated except for electrolytics and tantalums.
NWZ-X1050/X1051/X1060/X1061 NWZ-X1050/X1051/X1060/X1061 28 28 4-2. PRINTED WIRING BOARD Note 2: When the MAIN board is replaced, there are some notes. Refer to “NOTE THE MAIN BOARD REPLACING” (page 4) in servicing notes for notes. Note 1: In this set, only a part of parts that relate to the switch are supplied.
29 NWZ-X1050/X1051/X1060/X1061 SECTION 5 EXPLODED VIEWS 1 4-1 17-206-01 SCREW M1.4 2 A-1717-758-A HOLD ASSY 3 3-254-135-01 SCREW (B1.4) 4 3-234-449-47 SCREW (M1.
30 NWZ-X1050/X1051/X1060/X1061 5-2. MAIN BOARD SECTION 51 4-124-173-01 SHEET (JACK), INSULA TION 52 4-1 12-892-01 HOLDER (JACK) 53 3-234-449-31 SCREW (M1.
31 NWZ-X1050/X1051/X1060/X1061 5-3. TOUCH P ANEL SECTION 101 4-1 12-855-01 CUSHION (OLED) 102 4-1 12-862-01 SHEET (WINDOW), ADHESIVE 103 4-139-129-01 SP ACER (WINDOW) 104 A-1717-757-A BUTTON (HOME) (B.
32 NWZ-X1050/X1051/X1060/X1061 SECTION 6 ELECTRICAL P ARTS LIST A-1602-782-A HOME KEY BOARD, COMPLETE ************************* When HOME KEY board is defective, exchange the entire mounted board.
Ref. No. Part No. Description Remark NWZ-X1050/X1051/X1060/X1061 33 33 ACCESSORIES ************ 1-477-125-23 ADAPTOR, PLUG (DUAL) (Plug adaptor for in- fl ight use (single/dual)) 1-835-737-12 CONNECT.
NWZ-X1050/X1051/X1060/X1061 REVISION HISTOR Y Checking the version allows you to jump to the revised page. Also, clicking the version at the top of the revised page allows you to jump to the next revised page. V er . Date Description of Revision 1.0 2009.
デバイスSony NWZ-X1051の購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Sony NWZ-X1051をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはSony NWZ-X1051の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Sony NWZ-X1051の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Sony NWZ-X1051で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Sony NWZ-X1051を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はSony NWZ-X1051の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Sony NWZ-X1051に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちSony NWZ-X1051デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。