StoeltingメーカーSO328の使用説明書/サービス説明書
ページ先へ移動 of 29
Optima SO328 Floor Model OWNER'S MANUAL Manual No. 513591 Apr . 2003 Rev .2.
.
Need Part s or Service? We stock the parts you need. Our Technicians are factory trained and are certified in the Stoelting Technicare program. Model No.: _______________________ Serial No.: _______________________ Purchase Date: ____________________ Start-Up Date:____________________ CALL Distributor: _________________________ Phone No.
.
OWNER'S MANUAL FOR MODEL SO328 STOELTING FLOOR MODEL FREEZER This manual provides basic information about the freezer. Instructions and suggestions are given covering its operation and care. The illustrations and specifications are not binding in detail.
.
SECTION DESCRIPTION PAGE 1. INTRODUCTION 1.1 Remote Possibilities .......................................................................................... 1 1.2 Features ...............................................................................
FIGURE TITLE PAGE 1 Model SO328 ................................................................................... 1 2 Freezer Specifications ...................................................................... 2 3 Leveling Unit ...................
1 1.1 REMOTE POSSIBILITIES The S toelting Optima delivers frozen drink profits by the pitcher . The Model SO328 is a high-volume producer of ready-to-serve frozen cocktails or frozen neutral base for those special drink recipes. From an extra-small space, the Optima’s compact design and high capacity output will give you extra-large profits.
2 Electrical Refrigeration Crated Dimensions Dimensions 208/230/60/1 HFC-404A environmentally- Width: 22" (55.9cm) Width: 17.6"(44.7cm) 20 amp circuit & plug friendly refrigerant Depth: 30" (76.2cm) Depth: 26.
3 SECTION 2 INST ALLA TION INSTRUCTIONS 2.1 SAFETY PRECAUTIONS Do not attempt to operate the freezer until the safety precautions and operating instructions in this manual are read completely and are thoroughly understood. Take notice of all warning labels on the freezer.
4 2.4 INSTALLING PERMANENT WIRING If permanent wiring is required by local codes, the following procedure must be performed. W ARNING DISCONNECT FREEZER FROM THE SOURCE OF ELECTRICAL SUPPL Y BEFORE SER VICING . A . Remove the right side and left panels and electrical box covers to gain access to the power cord.
5 SECTION 3 INITIAL SETUP AND OPERATION 3.1 OPERATOR'S SAFETY PRECAUTIONS SAFE OPERA TION IS NO ACCIDENT ; Observe these rules: A. Know the freezer . Read and understand the Operating Instructions. B. Notice all warning labels on the freezer . C.
6 Figure 6. Disassembling Freezer C. Remove the spigot body from the front door by pul ling the retaining pin out of the spigot handle. Push the spigot body thru the bottom of the front door . D. Remove the agitator assembly from the freezer . Pull the agitator assembly out of the freezer barrel.
7 W ARNING THE UNITED ST A TES DEP ARTMENT OF AGRI- CUL TURE AND FOOD AND DRUG ADMINISTRA- TION REQUIRE THA T ALL CLEANING AND SANI- TIZING SOLUTIONS USED WITH FOOD PRO- CESSING EQUIPMENT BE CERTIFIED FOR THIS USE. USE “STERA-SHEEN” OR EQUIV ALENT .
8 Ê Ê Ê Ê Ê 3.8 CLEANING & SANITIZING OF S0328 WITH FILL-O-MA TIC II AND FILL-O-MA TIC III A . Empty freezer & mix container of product. B . Mix 4 gallons of warm (120°F) detergent (Joy or equivalent) water and pour into mix container , brush mix container , pick up hose and draw tube.
9 4. Fill Timer Operation The timer has ten dip switches, all switches placed in the “on” position are added together to make up the tot al time delay . This freezer leaves the factory with 64, 128 and 256 in the “on” position, this is a total of 448 seconds.
10.
11 4.1 ROUTINE CLEANING T o remove spilled or dried mix from the freezer exterior , simply wash in the direction of the finish with warm soapy water and wipe dry .
12.
13 SECTION 5 REPLACEMENT PARTS INFORMATION 5.1 ORDERING P ARTS T o assure receipt of the proper replacement part s, supply your dealer or distributor with the following information: A. MODEL NUMBER of equipment. B. SERIAL NUMBER of model (stamped on nameplate).
14 Item Stoelting P/N Qty . Description 1 1 170882 1 Auger Bushing 2 4177009 1 Auger Weldment 3 667892 1 Seal, Shaft 4 3172965 1 Rear Seal Adapter 5 624857 1 Ring, O, 2-1/4 ID x 2-5/8 OD x 3/16 CS 6 162157 2 Blade, Scraper 7 508048 As Reqd Lubricant 8 21771 18 1 W asher , Acetron 1.
15 6.1 Fill-O-Matic II The Fill-O-Matic II is a self contained auto-fill system designed to be used with the Model SO328 Freezer. The pump is built onto the cover of a 10 gallon mix vat.
16 Strainer On/Off Switch 1 15 V olt 15 Amp Plug Ç Å È Figure 10. Fill-o-matic II.
17 6.2 Fill-O-Matic II The Fill-O-Matic III is a gas powered auto-fill system designed to be used with Slush and Cocktail Freezers. The pump is built to hang on the side of a 10 gallon mix vat. The pump can be driven by either regulated CO 2 , nitrogen or filtered compressed air.
18 Mix Outlet Gas Outlet Gas Inlet Mix Inlet É Ë Ë Ë Figure 11. Fill-o-matic III.
19 Gas Powered T o Freezer Electric From Auto Fill Note: T ubing Sold Separately 7 = 6 6.3 Fill-O-Matic Connections.
.
W ARRANTY MIX TRANSFER PUMPS / COCKT AIL / SLUSH 1. Scope: Stoelting LLC warrants to the first user (the “Buyer”) that the evaporator assembly and compressor (if applicable) of Stoelting mix trans.
デバイスStoelting SO328の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Stoelting SO328をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはStoelting SO328の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Stoelting SO328の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Stoelting SO328で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Stoelting SO328を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はStoelting SO328の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Stoelting SO328に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちStoelting SO328デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
