ToshibaメーカーHD-EP35KBの使用説明書/サービス説明書
ページ先へ移動 of 40
HD DVD player HD-EP35KB HD-EP35KE Owner’s manual * The DTS-HD Advanced Digital Out logo indicates that this product when properly upgraded can enable full DTS-HD Advanced Digital Out capabilities. Please contact Toshiba Customer Solutions for update information.
2 SAFETY PRECAUTIONS WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
3 CAUTION: These servicing instructions are for use by qualifi ed service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualifi ed to do so. In the spaces provided below , record the Model and Serial No.
4 IMPORT ANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Head all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings.
5 Precautions Notes on handling • Never disconnect the power cord from a wall outlet while the player is turned on, unless it is in an emergency. Doing so may cause malfunction. • When shipping the player, the original shipping carton and packing materials come in handy.
6 Precautions (Continued) Notes on moisture condensation Moisture condensation damages the unit. Please read the following carefully. Moisture condensation occurs, for example, when you pour a cold drink into a glass on a warm day. Drops of water form on the outside of the glass.
7 T able of contents SAFETY PRECAUTIONS ....................................... 2 IMPORTANT SAFETY INSTRUCTIONS ............... 4 Precautions ........................................................... 5 Table of contents .............................
8 Features Disc compatibility Discs which can be played on this player are as follows. The icons ( ) are used in this manual to indicate features and/or functions that are applicable to various types of discs. Disc Specifi cation Prerecorded discs HD DVD video disc ( HD DVD ) 12cm (4 3 / 4 in.
9 Important notes about HD DVD HD DVD with high-defi nition content required for HD viewing. Viewing high-defi nition content and up-converting DVD content may require an HDCP capable DVI or HDMI input on your 50/60 Hz display device. Up-conversion of DVD content will result in near HD picture quality.
10 Index to parts and controls Front panel Rear panel No. Control Function Page 1 ON/ST ANDBY button T urns the power on or restores the unit to the standby mode. 18 2 ON/ST ANDBY indicator Blue: power on / Red: standby mode 18 3 Front panel display See the next page.
11 Display No. Function 1 Displays the video output format currently selected. (i: interlaced, p: progressive) 2 : Playing 3 : Pausing 4 : Fast forward playback 5 : Fast reverse playback 6 Shows a title number . 7 HD DVD: An HD DVD is loaded. DVD: A DVD is loaded.
12 Loading batteries 1 Open the cover and load batteries (R03 size). Make sure to match the + and – on the batteries to the marks inside the battery compartment. 2 Close the cover. Supplied accessories Check that the following accessories are supplied.
13 TV control The remote control of this player is compatible with TV controls. Once you program the remote control (see the next paragraph), the following controls are available.
14 Preparation Proceed the following steps to set the player ready. Resolution and connections Page 15 Page 16 Page 17 Page 18 Page 18 Page 19 Step 1: Connecting to a TV Step 2: Connecting to audio sy.
15 Via HDMI input To view 1080p output, make this connection. HDMI transfers digital audio and uncompressed digital video on a single cable. As a result, audio cables and video cables don’t need to be connected separately to a device. Note • This player supports simultaneous output of video on its HDMI and component video ports.
16 Preparation (Continued) *To use the optical digital output, use an optical cable to connect this jack to an optical audio input on a device capable of processing Dolby Digital, DTS bitstream, or PCM audio. Sound can output from connected audio system.
17 You may use the internet connection feature to update the player’s fi rmware. See page 35. Some HD DVD discs may enable you to access special HD DVD sites, if you connect the player to the Internet via an always-on broadband connection.
18 Preparation (Continued) When the power turns on, ON/STANDBY indicator on the front panel changes colour from red (standby mode) to blue (operation). Start up (and disc loading ( page 26)) may take time. When you power on this player for the fi rst time, the setting menu will appear.
19 Make the settings which are necessary to operate the player. 1 Make sure that the following menu is displayed. (If not, press SETUP to display it.) SETUP MENU Picture Audio Language Ethernet General A: Language 2 Press / to select “Language”, then press OK.
20 B: Time 6 Press / to select “General”, then press OK. ETUP MENU Picture Audio Language Ethernet General OSD On/Off Off Parental Lock Off Off Remote Controller Sound Off Maintenance Twin Format Disc HD DVD Clock Set HDMI Control 7 Press / to select “Clock Set”, then press OK.
21 C: Resolution 11 Press / to select “Picture”, then press OK. SETUP MENU Picture Audio Language Ethernet General TV Shape 16:9 Picture Mode Auto RGB Output Range Standard Resolution Setting up to 1080i 12 Press / to select “Resolution Setting”, then press OK.
22 D: Audio output 15 Press / to select “Audio”, then press OK. SETUP MENU Picture Audio Language Ethernet General Digital Out SPDIF Bitstream Digital Out HDMI Auto Digital Direct Audio Mode Off Dynamic Range Control Auto Dialog Enhancement Of f Speaker Setting 5.
23 Select one of the followings according to your connection, and press OK. 5.1ch When a 5.1 channel surround system is connected to this player. 1 Set the speaker sizes, distance to each speaker and the crossover frequency. Front Left / Front Right Small: Select if the speaker cannot output low frequency.
24 E: Ethernet Perform this setting if you connect the player to your LAN ( page 17). After performing this setting, you need to turn off this player and turn it on again to activate this setting. If you do not connect, skip to Step 20. 18 Press / to select “Ethernet”, then press OK.
25 20 Press RETURN or to return to the menu of step 1. 21 Press SETUP to close the menu. 22 If you made the LAN setting (“E: Ethernet”, page 24), press ON/STANDBY to turn the player off, then press the button again to turn it on. Network Speed 28.
26 Playing 1 Press OPEN/CLOSE to open the disc tray. 2 Place a disc in the hollow of the disc tray with the playback side down. Notes • Use the button on the front panel or the remote control to open and close the disc tray. Do not push or hold the disc tray wh ile it is moving.
27 Note • If the player freezes for about 15 minutes or more and will not respond to any buttons, holding down ON/STANDBY button on the front panel for about 10 seconds can force the player to turn off. However, this is an emergency measure, which may cause damage to the player.
28 T o select the sound HD DVD DVD-Video DVD-RW DVD-R CD If a disc contains several languages, you can select a preferred language from them to hear. 1 During playback, press AUDIO. The current audio setting appears. (except for some HD DVD discs) e.g.
29 T o locate a position HD DVD DVD-Video DVD-RW DVD-R CD 1 Press T.SEARCH repeatedly to select the category. Category To search by specifying: Title Title number Chapter Chapter number Time Elapsed time of the current title (track) Track Track number 2 Press the number buttons to enter a number.
30 Playing (Continued) A/B/C/D buttons HD DVD DVD-Video DVD-RW DVD-R CD Use these buttons as indicated by the video display during HD DVD disc playback. Depending on the disc contents, the functions of each button may differ. Cursor controls HD DVD DVD-Video DVD-RW DVD-R CD Future HD DVD discs may include game software and drawing software.
31 Output sound conversion table Disc ADV indicator Audio format “Digital Out SPDIF” “Digital Out HDMI” Bitstream PCM Auto PCM 2 Downmixed PCM HD DVD Video Advanced content ADV DD Plus/Dolby T rueHD Dolby Bitstream 2ch PCM Depend on HDMI receiver up to 5.
32 Customizing the function settings Group Setting Disc Details Page Picture TV Shape HD DVD DVD-Video DVD-RW DVD-R CD To select a picture size according to the aspect ratio of your TV. 33 RGB Output Range HD DVD DVD-Video DVD-RW DVD-R To select the RGB range according to the capacity of the connected DVI monitor.
33 Group Setting Disc Details Page General Parental Lock HD DVD DVD-Video DVD-RW DVD-R To turn the parental lock function on or off. 37 Clock Set HD DVD DVD-Video DVD-RW DVD-R CD To set the clock of the player. 20 OSD On/Off HD DVD DVD-Video DVD-RW DVD-R CD To activate or deactivate the operational status display on the TV screen.
34 Customizing the function settings (Continued) Picture Mode There are two types of source content in pictures recorded in DVD video discs: fi lm content (pictures recorded from fi lms at 24 frames per second) and video content (video signals recorded at 25 frames in PAL (30 frames in NTSC) per second).
35 Dialog Enhancement To turn on or off a function that increases dialog volume of a disc playback. On This function is activated. Off This function is disabled. Notes • This function is effective only in playback of Dolby Digital recorded HD DVD or DVD video discs.
36 Customizing the function settings (Continued) How to select a language: 1) Obtain the code from the list below. 2) Enter the code as below. 3) Select “OK” and press OK button.
37 Ethernet See page 24. General Parental Lock HD DVD and DVD video discs equipped with the Parental Lock function have a predetermined limitation level.
38 Clock Set See page 20. OSD On/Off To activate or deactivate the operational status display on the TV screen. On Activates the operational status display (e.g., ) on the TV screen. Off Deactivates the operational status display (e.g., ) on the TV screen.
39 Before calling service personnel Before accessing, try updating this player’s fi rmware. For details on how to update, see “Update (Firmware update)” ( page 38). If you experience any of the following diffi culties while using this unit, check the list below before consulting your nearest Toshiba dealer.
Specifi cation Power requirement 36.0W Power supply 220 - 240V AC 50/60Hz Mass 3.3kg External dimension Width 430 x Height 59.5 x Depth 327mm Signal system Standard PAL/NTSC colour system Laser Semiconductor laser Wavelength: 405nm/650nm/780nm VIDEO output 1.
デバイスToshiba HD-EP35KBの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Toshiba HD-EP35KBをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはToshiba HD-EP35KBの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Toshiba HD-EP35KBの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Toshiba HD-EP35KBで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Toshiba HD-EP35KBを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はToshiba HD-EP35KBの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Toshiba HD-EP35KBに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちToshiba HD-EP35KBデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
