US AmpsメーカーAXの使用説明書/サービス説明書
ページ先へ移動 of 20
Copyright 2007 U.S.Amps. All rights reserved. Owners Manual Owners Manual and and Installation Installation Guide Guide AX AX series series www.usamps.
1 Thanks, Caution, and Contacts T able of Contents Did Y ou Buy the Right U.S.Amp? Installation WARNING Amplifier Mounting V entilation Amplifier and Crossover Input Signal Level Input Gain Control Ad.
2 Gain Control Adjustment: Always start with the gain control fully counter-clockwise (all the way down), or just slightly open. Adjust the source unit volume as high as possible without distortion. Increase the amplifier gain until the amplifier distorts, then turn the gain down slightly until the signal becomes clear .
3 AWG 14 AWG 13 AWG 10 AWG 8 AWG 6 AWG 4 AWG 2 AWG 1 AWG 0 AWG 00 AWG 000 AWG 0000 30 Amps 35 Amps 45 Amps 60 Amps 80 Amps 105 Amps 135 Amps 160 Amps 190 Amps 215 Amps 245 Amps 275 Amps GETTING WIRED: Once you have established the current needs of your system, it will be of the UTMOST IMPORTANCE to properly fuse the amplifier .
4 WARNING: All U.S.Amps require a grounded input connection. DO NOT use ground-loop isolation devices or high/low conv ersion devices on the input of your U.S.Amp! Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation.
5 WARNING: NEVER use ground-loop isolation on the input of your U.S.Amp! It doesn’t need it! AX-1000/2000 2-Channel Amplifiers Controls and Features Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation. 1 Amplifier Output The low level output can be connected to other amplifiers.
6 Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation. 1 2 Input Gain is variable from 1 to 9 volts for full output. Best results are achiev ed by adjusting the control to the lowest setting in relation to the output of the source unit.
+ + + + + + + 7 Remote Bass Gain The AX -5600 comes with an optional “Remote Bass Gain” or “RBG” that can be mounted in the passenger compartment to independently attenuate the low pass output.
8 WARNING: All U.S.Amps require a grounded input connection. DO NOT use ground-loop isolation devices or high/low conv ersion devices on the input of your U.S.Amp! Amplifier Input The amplifier MUST receive input on BOTH RCA jacks for proper operation.
+ + + + + + + + + + + + + + + + + + + 9 Wiring Instructions for AX-TU600C/1000/2000 Negative 12V to V ehicle Ground (Use minimum 8-gauge Wire) F U S E Vehicle Battery 11 to 15 volts DC + − V ehicle .
10 Front Left Speaker Front Right Speaker Rear Right Speaker Rear Left Speaker Power Output 75W X 4 @ 4 Ω 90W X 4 @ 2 Ω Wiring Instructions for AX-TU4360C WARNING: NEVER use ground-loop isolation on the input of your U.
A X - 6 0 0 D E 11 Rear Left Speaker Rear Right Speaker Front Left Speaker Front Right Speaker + – Sub Power Output 75W X 4 @ 4 Ω 90W X 4 @ 2 Ω Sub Woofer Output 500W X 1 @ 1 Ω Wiring Instructions for AX-5600 (Note: The front and rear channels of the AX -5600) WARNING: NEVER use ground-loop isolation on the input of your U.
12 Wiring Instructions for AX-600DE Negative 12V to V ehicle Ground (Use minimum 8-gauge Wire) F U S E Vehicle Battery 11 to 15 volts DC + − V ehicle Ground Source Unit Positive 12V R emote T urn-on.
AX - T U 4 3 6 0 C 13 Wiring Instructions for AX-3200DE Negative 12V to V ehicle Ground (Use minimum 8-gauge Wire) F U S E Vehicle Battery 11 to 15 volts DC + − V ehicle Ground Source Unit Positive 12V R emote T urn-on Power Output 1200W X 1 @ 4 Ω 2500W X 1 @ 2 Ω 3000W X 1 @ 1 Ω WARNING: NEVER use ground-loop isolation on the input of your U.
14 Copyright 2007 U.S.Amps. All rights reserved. *Specifications are subject to change without notice N/A 300W X 2 200A 150W X 2 AX-2000HC N/A 75W X 4 90W X 4 60A AX-TU4360C N/A 165W X 2 300W X 2 60A .
AX - T U 6 0 0 C 15 Copyright 2007 U.S.Amps. All rights reserved. *Specifications are subject to change without notice. **Measured at 4 Ω /14.4V at the circuit board. 600W X 1 @ 4 Ω 2000W X 1 @ 1 Ω <0.025% >95 dB >1000 150 V us AX-2000HC 180W X 2 @ 4 Ω <0.
16 Why Tubes? Y ou may know that a transistor is a modern, efficient, less expensive version of a vacuum tube, which is the device that made sound recording and reproduction possible in the first place. Now , the electronics industry has been trying for many years to equal the sound quality av ailable from tubes.
17 VTCSD “follows” the high voltage tube signal STRAIGHT INT O THE SPEAKERS, adding only current in a form of “amplifier power steering” — free from voltage gain or negative amplifier feedback! V accum tubes are renowned for their high dynamic range and smooth emphasis of even-order harmonics.
18 NO TE.
Owners Manual and Installation Guide AX series www.usamps.com Limited Warranty: U.S.Amps warr ants all manufactured electronic products to be free from defects in material and workmanship for a period not to exceed TWO YEARS from the date of purchase.
デバイスUS Amps AXの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
US Amps AXをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはUS Amps AXの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。US Amps AXの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。US Amps AXで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
US Amps AXを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はUS Amps AXの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、US Amps AXに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちUS Amps AXデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
