Vulcan-Hartメーカー1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MFの使用説明書/サービス説明書
ページ先へ移動 of 20
VULCAN-HART DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC WWW.VULCANHART.COM INST ALLA TION & OPERA TION MANUAL For additional information on Vulcan-Hart or to locate an authorized parts and service provider in your area, visit our website at www .vulcanhart.
— 2 — GR SERIES GAS FRYERS IMPORT ANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREP ARED FOR PERSONNEL QUALIFIED T O INST ALL GAS EQUIPMENT , WHO SHOULD PERFORM THE INITIAL FIELD ST ART -UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
— 3 — GR SERIES GAS FRYERS T ABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY ................................................................................................. 2 INTRODUCTION ..............................................................
— 4 — GR SERIES GAS FRYERS EXTENDING SHORTENING LIFE ........................................................................................... 14 DRAINING THE TANK .................................................................................
— 5 — GR SERIES GAS FRYERS INTRODUCTION GENERAL Vulcan Fryers are produced with quality workmanship and material. Proper installation, usage and maintenance will result in many years of satisfactory performance. Before installing the fryer, thoroughly read this manual and carefully follow all instructions in the order given.
— 6 — GR SERIES GAS FRYERS RECEIVING AND UNPACKING This fryer was carefully inspected before leaving the factory. Upon acceptance of the shipment, the transportation company assumes full responsibility for safe delivery. Immediately after unpacking the fryer, check for possible shipping damage.
— 7 — GR SERIES GAS FRYERS INST ALLA TION WARNING: THIS EQUIPMENT SHALL BE INSTALLED ONLY BY A LICENSED GAS FITTER. Caution: Do not use the door or its handle to lift the fryer.
— 8 — GR SERIES GAS FRYERS Air Supply and Ventilation WARNING: DO NOT OBSTRUCT THE FLOW OF COMBUSTION/ VENTILATION OR AIR OPENINGS AROUND THE FRYER. ADEQUATE CLEARANCE AROUND THE FRYER IS NECESSARY FOR SERVICING AND PROPER BURNER OPERATION. • Install fryer in an area with sufficient air supply for gas combustion at fryer burners.
— 9 — GR SERIES GAS FRYERS FLUE CONNECTION Caution: Ensure that your ventilation system does not cause a down draft at the fryer's flue opening. Down drafts will not allow the fryer to exhaust properly and will cause overheating which may cause permanent damage.
— 10 — GR SERIES GAS FRYERS Quick-Disconnect for Units on Casters For an appliance equipped with casters: • The installation shall be made with a connector that complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances, CAN/CGA-6.
— 11 — GR SERIES GAS FRYERS OPERA TION WARNING: HOT OIL AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER. WARNING: SPILLING HOT FRYING COMPOUND CAN CAUSE SEVERE BURNS. DO NOT MOVE FRYER WITH- OUT DRAINING ALL FRYING COMPOUND FROM THE TANK.
— 12 — GR SERIES GAS FRYERS CAUTION: Solid shortening should NOT be used with GRM Fryers with millivolt controls. Melting solid shortening will damage the fryer tank and void your warranty. • Close the drain valve. • Fill the fryer tank with liquid shortening.
— 13 — GR SERIES GAS FRYERS TURNING OFF THE FRYER (FREE-STANDING MODELS) 1 . Turn the thermostat OFF. 2 . To keep the pilot lit, turn the gas valve knob to “I” in PILOT. 3 . To shut off all gas to the system, including the pilot, turn the gas valve knob to OFF.
— 14 — GR SERIES GAS FRYERS BASIC FRYING INSTRUCTIONS • Set the desired temperature and allow shortening to heat up to that temperature. • Fry items that are about the same size together to ensure equal doneness. • Drain or wipe dry raw or wet foods to minimize splatter when lowering into the hot shortening.
— 15 — GR SERIES GAS FRYERS DAILY FILTERING – ALL MODELS WARNING: HOT OIL AND HOT PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER. WARNING: WHEN HANDLING HOT OIL, WEAR INSULATED AND OIL- PROOF GLOVES. • Filter shortening at least once a day.
— 16 — GR SERIES GAS FRYERS BOIL OUT PROCEDURE Weekly or as required 1 . Drain the tank as described under DRAINING THE TANK. 2 . Once the shortening has been drained, flush out scraps and sediment with a small amount of warm shortening, using tank brush.
— 17 — GR SERIES GAS FRYERS MAINTENANCE WARNING: HOT OIL AND HOT PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING, AND SERVICING THE FRYER. WARNING: SPILLING HOT FRYING COMPOUND CAN CAUSE SEVERE BURNS. DO NOT MOVE FRYER WITHOUT DRAINING ALL FRYING COMPOUND FROM THE TANK.
— 18 — GR SERIES GAS FRYERS TROUBLESHOOTING WARNING: FRYERS WITH KLEENSCREEN™ FILTERS: CERTAIN PROCEDURES IN THIS SECTION REQUIRE ELECTRICAL TESTS OR MEASUREMENTS WHILE POWER IS APPLIED TO THE MACHINE.
— 19 — GR SERIES GAS FRYERS.
F-31233 Rev. B (May 2006) PRINTED IN U.S.A ..
デバイスVulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはVulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はVulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Vulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちVulcan-Hart 1GR35M ML-136407, 1GR45M ML-136408, 1GR65M ML-136409, 1GR85M ML-136410, 2GR45MF ML-136417, 2GR65MF ML-136418, 2GR85MF ML-136419,デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
