Vulcan-Hartメーカー2GR45DF ML-136424の使用説明書/サービス説明書
ページ先へ移動 of 27
INSTALLATION & OPERATIONAL MANUAL GRD & GRC SERIES GAS FRYERS With KleenScreen PLUS ® Filtration Systems M O D E L S : 1 G R 4 5 D M L - 1 3 6 4 1 1 1 G R 4 5 C M L - 1 3 6 4 1 4 1 G R 6 5 D .
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -2- IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -3- TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY……………………………… ……….
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -4- INTRODUCTION GENERAL Vulcan Fryers are produced wit h quality workmanship and mate rial. Proper installation, usage and maintenance will result in year s of satisfactory performance.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -5- INSTALLATION Do not use the door or its handle to lift the fryer. Before installing the fryer, veri fy that the type of gas (natural or propane) agrees with the specifications on the fryer data plate, which is located on the inside of the door panel.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -6- CODES AND STANDARDS The fryer must be insta lled in accordance with: In the United States: State and local codes, or in the absence of local codes, with: National Fuel Gas Code, ANSI-Z223.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -7- FLUE CONNECTION Make the flue connection as follows: Comply with Vapor Removal from Cooking Equipment , ANSI-NFPA Standard #96 (latest edition), available from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -8- After piping has been checked for leaks, fully purge gas pipes to remove air. GAS PRESSURES (ALL MODELS): The gas pressure should be set at 4” W.C. (W ater Column) (0.8 kPa) for natural gas and 10” W.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -9- In Australia, use only the caster suppl ied by the manufacturer for the fryer device. The fryer must be installed using a hose assembly restraining device to limit the movement of the appliance in accordance with AS1869.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -10- BEFORE FIRST USE Cleaning New units are wiped down at the fa ctory to remove an y visible signs of dirt, oil, grease, etc.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -11- BASIC FRYING INSTRUCTION Set the desired temperature and allow shorte ning to heat up to t hat temperature. Fry items that are the same size to ensure equal doneness. Drain or wipe dry raw or wet foods to minimize splatter when lowering into hot shortening.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -12- TURNING ON THE FRYER Open the door to the fryer. Turn t he power switch to the on position. Set temperature by turning the knob to the desired temperat ures. The burners will light automatically.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -13- Programming the Solid State Control.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -14- Programming the Computer Control.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -15- DRAINING THE TANK 1. Turn off fryer. 2. Insert the drain extension into the drain valve. Tighten only hand tight. 3. Direct the drain spout into the container that you want to drain the shortening into.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -16- 7. Press the TEMP button again and the gas burners will heat the so lution. Bring the solution to a simmer only. A llow to stand for a few minutes. 8. Turn OFF the power to the fryer.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -17- KleenScreen Plus ® Filtration System Installation and Operational Manual for “DF” and “CF” Models GRD/CF and 2XGD/CF .
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -18- Filtering Instructions for KleenScreen PLUS ® Fryers General The KleenScreen PLUS ® filtration system filters t he oil as it is pumped back into its’ respective tank(s). Only one tank can be dr ained and filtered at a time.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -19- Fully assembled filter screen assembly: F i g . 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -20- INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREEN PLUS ® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RA TE WE RECOMME ND YOU CHANGE YOUR FILTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE).
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -21- Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -22- Filtering Instructions for KleenScreen PLUS ® Fryers with Solid State Controls.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -23- Filtering Instructions for KleenScreen PLUS ® Fryers with Computer Controls.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -24- FILTERING TIP: Open the filtering drawer approximately 1” to allow any oil in the re turn line to run back into the filter pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter components.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -25- BOIL OUT PROCEDURE: Use the Boil Out By-Pass™ drai n extension allowing the boil out solution to exit the fry tank without using the filtering system. Do not allow water to run through the motor / pump.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -26- MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, clean ing, and servicing the fryer. Spilling hot fryer com pound can cause severe burns. Do not move fryer without draining all frying compound from the ta nk.
GRDF / GRCF SERIES GAS FRYERS VULCAN-HART F-329 33 Rev. G (May 2009) -27- OPEN PROBE – If an open probe is detected, the heat demand is disabled and any running cooking cycles are cancelled.
デバイスVulcan-Hart 2GR45DF ML-136424の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Vulcan-Hart 2GR45DF ML-136424をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはVulcan-Hart 2GR45DF ML-136424の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Vulcan-Hart 2GR45DF ML-136424の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Vulcan-Hart 2GR45DF ML-136424で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Vulcan-Hart 2GR45DF ML-136424を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はVulcan-Hart 2GR45DF ML-136424の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Vulcan-Hart 2GR45DF ML-136424に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちVulcan-Hart 2GR45DF ML-136424デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
