Williams SoundメーカーTGS PRO 720の使用説明書/サービス説明書
ページ先へ移動 of 24
® HEARING HELPER ™ T our Guide System W ireless, Por table FM Listening System M ANUAL AND U SER G UIDE MAN 122C T ransmitter Model PFM T32 or T31 Receiver Model PP A R35 Model TGS PRO 720.
® 2 HEARING HELPER ™ FM T OUR G UIDE S YSTEM , M ODEL TGS PRO 720 I NST ALLA TION G UIDE & U SER M ANUAL Contents Page S YSTEM O VERVIEW 3 S YSTEM C OMPONENTS 4 M ICROPHONES 4 H EADPHONES &.
® 3 S YSTEM O VER VIEW The HEARING HELPER ™ T our Guide System is a portable, high-performance, wireless system composed of the PFM T32 or T31 T ransmitter and PP A R35 Recei vers and designed for use in guided tour applications. The system allo ws one-way transmission of a tour guide’ s v oice to group members using an FM radio signal.
® 4 S YSTEM C OMPONENTS Body Pack T ransmitter (PFM T32 or T31) with (2) AA batteries (B A T 001) Noise-cancelling headband microphone (MIC 086) (10) Recei vers (PP A R35) w/batteries (BA.
® 5 R O PTIONAL H EADPHONES AND E ARPHONES The optional HED 021 Lightweight Headphone is the standard headset for the T our Guide System. It of fers excellent sound quality and wearing comfort. The foam earpads may be remov ed and washed in a mild detergent, rinsed thoroughly , and air dried.
® 6 C A UTION! C A UTION! C A UTION! S AFETY I NFORMA TION H EARING S AFETY This product is designed to amplify sounds to a high volume le vel which could potentially cause hearing damage if used improperly . T o protect y our hearing and the hearing of others: Make sure the v olume is turned down before putting on the earphone or headphone.
® 7 1. Install two (2) AA batteries. If you’ re using rechar geable batteries, they must be char ged before using. 2. Plug the microphone cord into the “Mic” jack on top of the transmitter . 3. Place the transmitter in the belt clip case provided.
® 8 C HANGING THE PFM T32 F REQUENCY F IG . 4: PFM T32 F REQUENCY C HANGE By default, the T32’ s frequency is to set 75.7 MHz (Channel G). If you experience FM interference, or if you need to match a recei ver’ s frequenc y , it may be necessary to adjust the frequenc y on the T32.
® 9 Gain Control Adjustment If necessary , the microphone gain control on the T32 can be increased or decreased to meet the demands of specific listening applications. Instructions: 1. Open the battery compartment using a coin in the slot in the bottom of the transmitter .
® 10 U SING T HE PFM T31 T RANSMITTER Note: Before you begin, make sure you ha ve AA Alkaline batteries installed in the transmitter . See Battery Information on page 15. 1. Plug the microphone into the “mic” jack on top of the transmitter . 2. T urn the po wer on: Place the FM switch to the “On” position.
® 11 Switch Settings MHz 1 2 3 4 5 6 7 8 72.1 DN UP DN UP DN DN DN DN 72.3 DN UP DN UP UP DN DN DN 72.5 DN UP DN UP DN DN UP DN 72.6 DN DN UP DN DN DN DN UP 72.7 DN UP DN UP UP DN UP DN 72.8 DN UP DN DN DN DN DN UP 72.9 DN UP DN UP DN DN DN UP 74.7 UP DN DN UP UP DN DN UP 75.
® 12 U SING THE PP A R35 R ECEIVER Note: Rechargeable batteries are shipped in a dischar ged state and must be charged o vernight before using. 1. Make sure there are two char ged AA batteries in the Recei ver . If batteries are not installed, see Battery Information on page 15.
® 13 – or – B EL T C LIP I NST ALLA TION FOR PP A R35 T O I NST ALL : Position the belt clip on the rear of the R-35 recei ver as sho wn in Figure 9a. T urn the belt clip 180º left or right as sho wn in Figure 9b . The belt clip is now installed and ready for use.
® 14 PP A R35 R ECEIVER F REQUENCY C HANGE I NSTRUCTIONS Selecting a frequency for the R35 recei ver requires an adjustment to the internal tuning coil. See figure belo w to locate the coil to be adjusted. A plastic tuning wrench (PL T 005) will be needed to adjust this recei ver’ s tuning coil.
® 15 B A TTERY I NFORMA TION I NST ALLA TION Open the battery compartment using a coin in the slot in the bottom of the recei ver or transmitter . Press the batteries into place, observing proper battery polarity .
® 16 Charging Indicators Charging Pins Cord Hook P ow er Input Charging Contact Holes F IGURE 12: U SING T HE O PTIONAL CHG 200A B A TTERY C HARGER T O C HARGE THE PFM T32 OR T31 T RANSMITTER Step 1: Plug the CHG 200’ s power supply into the Po wer Input on the charger’ s side and a standard A C wall outlet.
® 17 U SING T HE O PTIONAL CHG 3512 B A TTERY C HARGER TO CHARGE THE PP A R35 R ECEIVER Before inserting the PP A R35 receivers into the char ger, be sure that each recei ver has NiMH batteries installed. Also, check to make sure the switch setting in the PP A R35 battery compartment indicates the “NiMH” setting.
® 18 H INTS FOR U SING THE S YSTEM Normal operating distance between the transmitter and recei ver is about 30 meters. The operating range will v ary in different b uildings and surroundings. In some locations, the signal may momentarily disappear . This is called a “drop-out” and is due to reflection and cancellation of the radio signal.
® 19 I N C ASE O F D IFFICUL TY If your T our Guide System is not working, check the follo wing: 1. Read thr ough the manual and user guide car efull y to v er ify proper setup and installation of y our system . 2. Make sure the batteries are fresh or completely char ged and that the “plus” and “minus” terminals are installed correctly .
® 20 Williams Sound products are engineered, designed, and manufactured under carefully controlled conditions to provide you with many years of reliable service. Williams Sound warrants the HEARING HELPER ™ Tour Guide System against defects in materials and workmanship for FIVE (5) years.
® 21 S YSTEM S PECIFICA TIONS FM T RANSMITTER , M ODEL PFM T32 Dimensions: 3-5/8" L x 2-3/8" W x 7/8" H (92.1 mm x 60.3 mm x 22.2 mm) Weight: 4.4 oz (125 g) with battery Color: Royal blue, shatter-resistant polypropylene Battery Type: Two (2) AA 1.
® 22 R ECEIVER , M ODEL PP A R35 Dimensions: 4.1" L x 2.85" W x 1.2" H (104.1 mm x 72.4 mm x 30.4 mm) Weight: 4.5 oz (127 g) Color: Gray Battery Type: Two (2) AA non-rechargeable alkaline batteries (BAT 001), approx.
.
© 2006, Williams Sound Corp. MAN 122C ® 10321 West 70th St., Eden Prairie, MN 55344 U.S.A. 800.843.3544 | 952.943.2252 | FAX: 952.943.2174 www.williamssound.
デバイスWilliams Sound TGS PRO 720の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Williams Sound TGS PRO 720をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはWilliams Sound TGS PRO 720の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Williams Sound TGS PRO 720の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Williams Sound TGS PRO 720で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Williams Sound TGS PRO 720を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はWilliams Sound TGS PRO 720の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Williams Sound TGS PRO 720に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちWilliams Sound TGS PRO 720デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
