X-MicroメーカーPCI Adapter fxmicroの使用説明書/サービス説明書
ページ先へ移動 of 23
X-Micr o WLAN 1 1g PCI Adapter U ser M anual.
2 Contents 1. Introduct ion 5 1.1 Product Feature .......................................................................................... 5 1.2 System Requirement .................................................................................. 5 2.
3 This product is in complia nc e with the essential requirement s and other re levant provisions of the R&TTE directive 1999/5/EC. P r o d u c t N a m e : X-Micro WLAN 11g PCI Card M o d e l N a m e : XWL-11GCAG MAX. OUT POWER COUNTR Y CHANNELS INDOOR OUTDOOR Spai n 2400-2483.
4 FCC INFORMA TION FCC Radiati on Exposure Statement This equipment compli es with FCC r a diation ex posure limits set forth for an uncontrolled env ironment. This equipment shoul d be installed and operated wi th minimum distance 20cm between the r adiator & your body .
5 1. Introduction 1.1 Product Featur e ● Compliance with IEEE 802.11g and 802.11b standards ● Highly efficient design mechanism to provide unbeatable performance ● Achieving data rate up to 54Mbps for 802.11g and 11Mps for 802.11b with wide range coverage; high performance to de liver up to 108Mbps raw data rate for 802.
6 2.2 Install the 108Mbps W ireless Network PCI Adapter 2.2.1 Utility Installation 1. Before insert PCI Adapter into the PCI slot of your com puter , please install the Utility Program first. Make sure that the 108Mbp s wireless Network PCI Adapter is NOT inserted into the PCI slot.
7 3. InstallShield Wizard will au tom atically start. Please click “Next” to continue..
8.
9 4. Please click “Finish” 5. Please make sure TURN OFF your comput er and remove the power cord from your PC. Open the computer case and th en please insert the Wireless PCI Adapter into the empty PCI slot of your computer system . Once the Wireless PCI Adapter is installed, place the computer case back.
10 2. Please click “Continue Anyway”.
11 3. Please click “Finish” 4. T o make sure if the installation is successful, you could check it through the device management..
12 5. Once the installation is successful, a utility program icon will show on your desktop. T o lunch the utility , just double click the icon. 3. Configuration 3.1 Link Information The default page is as below after you lau nch the Utility program. Status: Shows the BSSID associated, which can be used to identify the wireless network.
13 Encryption: Shows the current encryption m ode used for wireless network. TxRate: Shows the current data rate used for transmitting. Channel: Shows the current channel for communication. Link Quality : Shows the link quality of the 54Mbps wireless network PCI Adapter with the Access Point when opera ting under Infrastructure mode.
14 ● Ad-Hoc – to establish point-to-point wi reless communication di rectly with other wireless client devices such as wireless network PCI Adapter. AdHoc Band: There are two bands available for selection- 11B and 11G Channel: The value of channel that AP will ope rate in.
15 Encryption: 4 options are available: Disable , Enable , WPA and WPA-PSK . Select Enable or Disable for WEP data encryption featur e. If one of the two options is selected, it is required to select the Authentication mode from the next dropping list.
16 Aut. Mode: There are three modes available to choose. Open Authentication – the sender and receiver do not share secret Key for communication. Instead, each party generates its own key-pairs and asks the other party to accept it. The key is regenerated when the connection is established every time.
17 3.4 Site Survey This page allows you to enable the Site Survey function to sc an for the available wireless network (wireless clients a nd Access Points) and establish wireless communications with one. Available Network – displays the wireless networ ks (wireless clients and Access Points) that are in your signal range.
18.
19 3.5 About US This page displays some informat ion about the 54Mpbs PCI Adapt er utility, which includes the version numbers for Driver, Fi rmware and Utility. When there is new version of software availabl e for upgrade, you will be able to i dentify by version numbers.
20 Authentication Type: Indication of an authentica tion algorithm which can be supported by the Access Point: 1. Open System: Open System authentica tion is the sim plest of the available authentication algorithm s. Essentially it is a null authentication al gorithm.
21 both back off and wait a random amount of time before retrying. DHCP: Dynamic Host Configuratio n Protocol, which is a prot ocol that lets network administrators manage and allocate Intern et Protocol (IP) addresses in a network.
22 Gateway : a device that interconnects networ ks with different, incompatible communication protocols. HEX: Hexadecimal, HEX, consists of number s from 0 – 9 and letters from A – F.
23 connection to an Infrastructure network. RTS: R equest T o S end. An RS-232 signal sent f rom the transmitting station to the receiving station requesting permission to transmit. RTS Threshold: Transmitters contending for the m edium may not be aware of each other.
デバイスX-Micro PCI Adapter fxmicroの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
X-Micro PCI Adapter fxmicroをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはX-Micro PCI Adapter fxmicroの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。X-Micro PCI Adapter fxmicroの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。X-Micro PCI Adapter fxmicroで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
X-Micro PCI Adapter fxmicroを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はX-Micro PCI Adapter fxmicroの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、X-Micro PCI Adapter fxmicroに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちX-Micro PCI Adapter fxmicroデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
