ZanussiメーカーZWI 1125の使用説明書/サービス説明書
ページ先へ移動 of 28
EN User manual Washing Machine ZWI 1125.
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing Programmes _ _.
• If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from ho- ses and their connections after the installation.
Product description 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adju stable f eet 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available).
1 2 3 4 5 6 B C A 7 1 Programme selector dial 2 SPIN reduction button 3 OPTIONS button 4 EXTRA RINSE button 5 START/PAUSE button 6 DELAY START button 7 Indicator pilot lights Table of symbols Push but.
Start Pause This button allows you to start or to interrupt the selected programme. Delay Start The start of the programme can be delayed by 3, 6 or 9 hours by means of this button. Indicator pilot light (7) B C A When selecting a washing programme both lights A and B illuminate.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment COTTONS 60° - 40° - 30° - Cold Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 6 kg - Reduced load 3 kg 1) Whit e and colo ured cot ton (normally soiled items).
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Comp artment WOOL/HANDWASH 30° - C old Main wash - Rinses Maximum spin speed at 900 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics.
Before loading the laundry Never wash whites and coloureds together. Whites may lose their whiteness in the wash. New coloured items may run in the first wash; they should therefore be washed separately the first time. Button up pillowcases, close zip fasteners, hooks and poppers.
When the degree of hardness is soft, readjust the quantity of the detergent. First use • Ensure that the electrical and water connections comply with the installation instructions.
When selecting a programme, the light corresponding to the maximum speed allowed for that programme will illu- minate. Select the available opti ons b y pressing buttons 3 and 4 Depending on the programme, different functions can be combined. These must be selected after choosing the de- sired programme and before starting the programme.
continues to run at regular intervals until the water drain- ing. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to . 2. Set the draining or spinning programme. 3. If needed, reduce the spin speed, . 4. Press button 5 .
Place a container close to the pump ( A ) to collect any spillage. Pull out the emergency emptying hose ( B ), place it in the container and re- move its cap. When no more water comes out, unscrew the pump cover by turning it anti-clockwise and remove the filter.
Frost precaution If the machine is exposed to temperatures below 0°C, cer- tain precautions should be taken. • Turn off the water tap. • Unscrew the inlet hose. • Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out.
Problem Possible cause/Solution The washing machine does not start: The door has not been closed (the button 5 red light blinks). • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rota- tion of the drum.
Consumption values Programme Energy consumption (KWh) 1) Water consumption (litre) 1) Programme duration (Minutes) 1) White Cottons 90 °C 2.0 61 140 Cottons 60 °C 1.35 58 125 Cottons 40 °C 0.75 58 120 Synthetics 40 °C 0.9 50 90 Delicates 40 °C 0.
Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing ma- chine by raising or lower- ing the feet.
1. Into a drainage standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” supplied. “U” piece supplied Place the drain hose into your standpipe, which should have an internal diameter of approximately 38 mm thus ensuring there is an air break between the drain hose and standpipe.
SHOWER WASHING MACHINE DISHWASHER BA TH SINK TOILET BIDET RAINWA TER ‘RUN-OFF’ SURF ACE WA TER DRAINS & SEWERS UNTREA TED DISCHARGE RIVER RIVER TREA TED DISCHARGE FOUL DRAIN FOUL SEWERS SEWAGE.
A 600 596 555 170 75 176,5 416 100 60 818 min. 820 min. 560 When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped.
D 4 6 8 Caution! Do not remove the screw 8 ! d) Counter-magnet (6) The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, it is neces- sary to screw the counter-magnet (6) (steel disk + rub- ber ring) into the inner side of the door.
Drill four fixing holes see Fig. G Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to al- low a small strip of beading to be fitted in front of the appliance feet.
25.
26.
27.
www.zanussi.com/shop 132966891-A-462011.
デバイスZanussi ZWI 1125の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Zanussi ZWI 1125をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはZanussi ZWI 1125の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Zanussi ZWI 1125の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Zanussi ZWI 1125で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Zanussi ZWI 1125を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はZanussi ZWI 1125の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Zanussi ZWI 1125に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちZanussi ZWI 1125デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
