ZenoahメーカーPE2500Hの使用説明書/サービス説明書
ページ先へ移動 of 20
PE2500H W A TER PUMP T1056-93510 (904) OPERA T OR’S MANUAL • Before using our water pumps, please read this manual carefully to understand the proper use of your unit.
.
SAFETY FIRST Instructions contained in warnings within this manual marked with a symbol concern critical points which must be taken into consideration to prevent possible serious bodily injury, and for this reason you are requested to read all such instructions carefully and follow them without fail.
❲ 4 ❳ For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to take a mistake.
2. For safe operation • Before operating the machine, be sure to read through this manual carefully and follow proper operating instructions. • Never allow children or anyone unable to fully understand the instructions given in the manual to use the machine.
❲ 6 ❳ • Do not touch the spark plug or the plug wire while the engine is in operation. They may cause an electric shock. • Do not touch metallic parts such as the muffler, spark plug, etc. with bare hands during the operation of engine or immediately after a stop.
3. Parts Location 1. Air cleaner 2. Throttle lever 3. Spark plug 4. Handle 5. Self-suction plug 6. Discharge port 7. Suction port 8. Hose coupling 9. Clump 10. Suction hose 11. Strainer 12. Clump 13. Drain plug 14. Base 15. Fuel tank 16. Engine stop button 17.
❲ 8 ❳ 4. Specifications MODEL PE2500H Pump Type ··········································································.
• Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m(10ft) away from the fueling point before starting the engine.
❲ 10 ❳ other containers. 6. Indicate the contents on outside of container for easy identification. ■ FUELING THE UNIT 1. Untwist and remove the fuel cap. Rest the cap on a dustless place. 2 . Put fuel into the fuel tank to 80% of the full capacity.
• As a suction hose, be sure to use attached suction hose(nominal diameter 25mm x 3m) or an equivalent ‘water suction hose’ only. • Securely connect hoses with attached hose couplings and clumps.
❲ 12 ❳ • Fuel(Gasoline) is highly flammable and incorrect handling will cause fire accident. Strictly avoid smoking or fire during mixing or supplying the fuel. • Be sure to stop the engine and allow it to be cooled before refueling. • Spilled fuel shall be completely wiped away with wiping cloth, etc.
7. Operation ■ STARTING ENGINE 1 . Push a priming pump at lower side of the carburetor several times until you can see the fuel flows into a clear tube. (F3) 2. Put the choke lever to CLOSE position, and set the throttle lever 1/3 to 1/2 open from fully returned position.
■ STOPPING ENGINE In case of emergency, immediately stop the engine. 1. Return the throttle lever and run engine 1 to 2 minutes for cooling down. 2. Press the engine stop button(yellow) until the engine completely stops. (F5) ■ AFTER USE 1. Release a drain plug at lower part of the pump and drain the water out of the pump.
❲ 15 ❳ 8. Maintenance • Be sure to stop the engine and keep off fire for inspection and maintenance. • Always use our genuine parts/oils or our specified goods for replacement. ■ AIR CLEANER After every 25 hours of operation, release the air cleaner cover and remove dusts.
❲ 16 ❳ • Operation with no fuel filter cause clogging of the carburetor. Fuel Filter Part No. 3302-85400 ■ SPARK PLUG Do not touch the spark plug with bare hands immediately after stopping the engine. There is a possibility of burns by high temperature.
■ ADJUSTING IDLE SPEED Engine idle speed is already adjusted at shipping. However, if the engine stalls due to too low engine speed when fully returning the throttle lever or if you feel it to be too high, adjust the speed. Idle adjusting screw is on the upper part of the carburetor.
❲ 18 ❳ 9. Storage ■ STORING FOR LONG PERIOD • To stop using your machine for a long period, drain fuel from the fuel tank and the carburetor before storing it. Fuel left behind inside there for long period may clog the carburetor and cause engine troubles as no starting of engine or reduced engine output.
10. T roubleshooting guide COUNTERMEASURE Change with proper fuel(see Page 9) Open choke and repeat pulling rope (see Page 13) cleaning Cleaning of electrode or replace plug (see Page 16) Top up with .
Warranty certificate Komatsu Zenoah Co. The Komatsu Zenoah product model No.PE2500H is covered by a Warranty of 6 months from the following date of purchase. In the case of professional machine used for professional work, such machines are covered by a Warranty of 3 months.
デバイスZenoah PE2500Hの購入後に(又は購入する前であっても)重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります:
Zenoah PE2500Hをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはZenoah PE2500Hの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Zenoah PE2500Hの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Zenoah PE2500Hで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Zenoah PE2500Hを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はZenoah PE2500Hの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Zenoah PE2500Hに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちZenoah PE2500Hデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。