BlaupunktメーカーLas Vegas CDM147の使用説明書/サービス説明書
ページ先へ移動 of 24
.
2 FCC W arning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
3 Español Advertencias FCC ........................................ 47 Registro del Propietario ................................ 47 Características .............................................. 48 Precauciones ......................................
4 Features Congratulations on your purchase of this Blaupunkt CD Receiver. Its Codem III-US FM/AM Tuner, 3-Beam Laser/Anti-Vibration & Shock mechanism and CD Changer Controls provide the ultimate in sound reproduction. Its high-power amplifier and 4-Channel RCA preamp output provide you with tremendous system configuration flexibility.
5 Detachable Face Detaching & Attaching the Face: The face of this unit can be detached and taken with you to prevent it from being stolen. Detaching the Face: Before detaching the face, be sure to press the PWR Button first. Then press the REL (Release) Button and detach the face by gently pulling it off as illustrated.
6 Electrical Connections and Installation @/<?#&*>@! To avoid the aggravation of costly mistakes and serious damage that could make you feel this way, please carefully read all of the instructions before you begin. Carefully follow all instructions.
7 tremendous flexibility in configuring your speaker arrangement: • You can connect a speaker (regular, co-axial or tri-axial speakers or component speaker system, all hereafter referred to simply as “speaker”) to each of the units’ four pairs of speaker leads.
8 Installation Recommendations • Carefully choose the mounting location so that the unit won’t interfere with normal driving. • Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would subject to dust, dirt or excessive vibration.
9 to dashboard/center console 2 NISSAN Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features (side-bracket mounting systems). In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring and separate it from the unit.
10 Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case.
11 Specifications Audio Power Specifications Power Output and Total Harmonic Distortion: 13.5 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15,000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM Tuning Range: 87.
12 Location of Controls 1. REL (Release) Button 2. Disc Insertion Slot 3. Eject 4. SRC (Source)/LIST Button Source Change Disc Name List Access 5. PWR (Power) Button 6. Volume + 7. Volume – 8. Mute/Audio Button Mute, Bass, Treble, Balance/Fade Access Name Storing/Deletion/Exit Minute: 00 9.
13 Instructions — General Operation See Traffic Safety & Precautions on page 4. “Press” means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. (Beep for all button presses available through Direct Software Control Menu.
14 Audio Operation Volume Control Buttons (+/–) Press + and - to increase/decrease volume from 0 to 63, in increments of 1.25 dB/step. Volume control is accessible from all modes except Name Access and Edit modes. Mute & Cellular Mute Press Mute to temporarily reduce volume to level set under Menu.
15 Seek Tuning Press / or V to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity requirements predetermined by sensitivity set through SENS/LD button. Press of / or V buttons for more than 1/2 second seeks next receivable frequency after button is released.
16 CD Playback When a CD is already in unit, press SRC as needed to activate “CD PLAY”. CD Eject Press eject. Disc ejects. If disc is not removed within about 5 seconds (unless ignition off) or if eject is pressed again within this time, disc is automatically reloaded, although unit stays with current audio source.
17 Auxiliary Input Jack Connect other audio equipment, such as a portable cassette or DAT player, through the 500mV/3.5 mm pigtail connector. Access auxiliary equipment output by pressing SRC until “AUX IN” appears. Adjust volume, bass, and treble settings through the receiver.
18 previously active. A track will not be played a second time until all tracks have been played. Once all tracks have been played, next disc is selected. Disc Mix Press MIX as needed until MIX II appears. MIXII behaves per software in CD changer. Press of / / V during MIXII mode returns unit to regular play.
19 Running Track Program Press TPM to activate program. TPM appears. (If TPM pressed when no programming has been entered for disc currently in magazine, “NO PROG” appears.) TPM Track Up/Down To advance and go back within program, use << and >> buttons.
20 4. After eighth character (the farthest right character) is completed, first (left-most) character of next group of eight characters begins to flash. After fifth group of eight characters, pressing >> will access first group again. 5. Press Mute to store turn-on message and return to Menu.
21 Radio Station Naming (“STN NAME”) Available only while radio is active source. One name per frequency, 8 characters per name. (Names can be assigned to any frequency, preset or not.) If you try to enter more than 30 names, “**FULL**” appears.
22 Erasing One Disc Name Access Disc Access mode under Menu (See Disc Naming). Choose disc that has name to be deleted. When name appears, press Mute for 2 seconds. Beep sounds. Release now to delete the name. “NAME” and “DELETED” alternately blink.
23 CD operation Trouble Cause/Solution CD play does not start. • Dusty or defective disc. • The ambient temperature is more than 50 ° C (120 ° F). The disc cannot be loaded or is • The disc is inserted with the printed side downwards. automatically ejected.
24 German Headquarters: Blaupunkt-Werke GmbH Postfach 77 77 77 D-31132 Hildesheim Germany Robert Bosch Corporation Sales Group — Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60153 1-800-950-BLAU Robert Bosch, SA., DE, C. V. Dr. Lucio 270 Cols.
デバイスBlaupunkt Las Vegas CDM147の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Blaupunkt Las Vegas CDM147をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはBlaupunkt Las Vegas CDM147の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Blaupunkt Las Vegas CDM147の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Blaupunkt Las Vegas CDM147で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Blaupunkt Las Vegas CDM147を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はBlaupunkt Las Vegas CDM147の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Blaupunkt Las Vegas CDM147に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちBlaupunkt Las Vegas CDM147デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
