Briggs & Strattonメーカー5900692の使用説明書/サービス説明書
ページ先へ移動 of 19
7/2007 1 5101092 Rev No. 02 TP 300-7333-02-M2-SP Dealer Setup & Adjustment Instructions S200X - 25HP , 27HP & 32HP 61” & 72” Mower Deck T ABLE OF CONTENTS: SETUP PROCEDURES Quick Setup List .............................................
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 2 Quick Setup List - P age Setup Procedure Steps to P erform 3 Uncrating ❏ Remov e Crate & Banding. ❏ Loosen Hydraulic Release V alv es. ❏ Release P arking Brake and Roll T r actor forw ard off skid.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 3 TP 300-7333-02-M2-SP Uncrating 1. Using a reciprocating utility saw or equivalent, cut crate away from bottom skid. Remove crate. Remove shrink-wrap plastic. 2. Cut nylon banding from front of the frame and rear rear bumper.
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 4 T ractor Assembl y Motion Contr ol Handle Assembly 1. Remove the handles and mounting hardware from the handle bar box.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 5 TP 300-7333-02-M2-SP Roll Bar Installation Install the Roll Bar 1. Unpack the roll bar and hardware from the box. 2. Place the roll bar in to the roll bar pockets (A, Figure 6) on the frame. Refer to Figure 7 for the correct roll bar orientation.
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 6 Chec k Fluid Le vels Chec k the Engine Oil Level 1. Use the dipstick (A, Figure 8) to check the engine oil level. If necessary add engine oil. Check the engine manufacturer’s owner’s manual for the oil recommendations.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 7 TP 300-7333-02-M2-SP Chec k the Mower Assembl y Chec k T or que - Mower Blades 1. Park the machine on a flat, level surface and engage the parking brake. 2. Lock the deck lift pedal in the 5” (12,7 cm) position.
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 8 Install the Mo wer Deck (72” Models) 1. Park machine on a flat, level surface and engage the parking brake.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 9 TP 300-7333-02-M2-SP Chec k Deck Rod Timing 1. Park machine on a flat, level surface. Disengage the PTO, stop the engine and engage the parking brake. Rear tires must be inflated to 15 psi (1,03 bar); front tires to 25 psi (1,72 bar).
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 10 Figure 18. 2 x 4 Locations Figure 19. Hanger Chain Adjustment Dec k Leveling Adjustment NOTE: Before adjusting the deck level, the deck lift rod timing must be checked and/or adjusted.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 11 TP 300-7333-02-M2-SP Chec k Deck Drive Belt 1. Lower the mower deck to its lowest cutting position. 2. Remove the mower deck guards. 3. Make sure the V-side of the belt runs in the pulley grooves (Figures 21 & 22).
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 12 Lubrication Lubricate the unit at the locations shown in Figure 25 through 28 as well as the following lubrication points.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 13 TP 300-7333-02-M2-SP Figure 29. Adding Fuel A. Fuel Cap A Adding Fuel To add fuel: 1. Remove the fuel cap (see A, Figure 29). 2. Fill the tank to about 1-1/2” (3,81 cm) of the bottom of the filler neck.
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 14 P erf orm the Safety Chec ks Functional T ests 1. Check the tractor for loose bolts, screws, nuts, etc. 2. Start the engine and check all the controls for proper operation: ground speed control levers, parking brake, throttle cable, electric PTO clutch, etc.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 15 TP 300-7333-02-M2-SP Adjustment Pr ocedures Seat Adjustment See Figure 30. The seat can be adjusted forward and backward. Move the lever forward, position the seat as desired, and release the lever to lock the seat into position.
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 16 Motion Contr ol Handle Adjustment The control levers can be adjusted in three ways. The alignment of the control levers, the placement of the levers (how close the ends are to one another) and the height of the levers can be adjusted.
S200X 25HP & 27HP - 61” Mower Dec k 7/2007 17 TP 300-7333-02-M2-SP Return-T o-Neutral & Neutral Adjustment RETURN-TO-NEUTRAL ADJUSTMENT To determine if it is necessary to adjust the neutral return, perform the following steps. 1. Disengage the PTO, engage the parking brake and turn off the engine.
S200X 25HP & 27HP - 61” Mower Dec k TP 300-7333-02-M2-SP 7/2007 18 Figure 35. Parking Brake Adjustment A. Brake Spring B. Adjustment Nut P arking Brake Adjustment 1. Disengage the PTO, engage the parking brake, stop the engine and remove the ignition key.
Briggs & Stratton Yard Power Products Group Copyright © 2007 Briggs & Stratton Corporation Milwaukee, WI, USA. All rights reserved. The Snapper Pro logo is a trademark of Briggs & Stratton Corporation Milwaukee, WI, USA. Contact Information: Briggs & Stratton Yard Power Products Group 5375 N.
デバイスBriggs & Stratton 5900692の購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Briggs & Stratton 5900692をまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはBriggs & Stratton 5900692の技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Briggs & Stratton 5900692の取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Briggs & Stratton 5900692で得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Briggs & Stratton 5900692を既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はBriggs & Stratton 5900692の不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Briggs & Stratton 5900692に関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちBriggs & Stratton 5900692デバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
