CannonメーカーCANTFS-03-LPの使用説明書/サービス説明書
ページ先へ移動 of 24
C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS.
2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteri.
3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor .
4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone.
5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment.
6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position.
7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7.
8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs.
9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.
10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installatio.
11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set.
12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front.
12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front.
11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set.
10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installatio.
9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.
8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs.
7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7.
6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position.
5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment.
4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone.
3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor .
2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteri.
C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS.
デバイスCannon CANTFS-03-LPの購入後に（又は購入する前であっても）重要なポイントは、説明書をよく読むことです。その単純な理由はいくつかあります：
Cannon CANTFS-03-LPをまだ購入していないなら、この製品の基本情報を理解する良い機会です。まずは上にある説明書の最初のページをご覧ください。そこにはCannon CANTFS-03-LPの技術情報の概要が記載されているはずです。デバイスがあなたのニーズを満たすかどうかは、ここで確認しましょう。Cannon CANTFS-03-LPの取扱説明書の次のページをよく読むことにより、製品の全機能やその取り扱いに関する情報を知ることができます。Cannon CANTFS-03-LPで得られた情報は、きっとあなたの購入の決断を手助けしてくれることでしょう。
Cannon CANTFS-03-LPを既にお持ちだが、まだ読んでいない場合は、上記の理由によりそれを行うべきです。そうすることにより機能を適切に使用しているか、又はCannon CANTFS-03-LPの不適切な取り扱いによりその寿命を短くする危険を犯していないかどうかを知ることができます。
ですが、ユーザガイドが果たす重要な役割の一つは、Cannon CANTFS-03-LPに関する問題の解決を支援することです。そこにはほとんどの場合、トラブルシューティング、すなわちCannon CANTFS-03-LPデバイスで最もよく起こりうる故障・不良とそれらの対処法についてのアドバイスを見つけることができるはずです。たとえ問題を解決できなかった場合でも、説明書にはカスタマー・サービスセンター又は最寄りのサービスセンターへの問い合わせ先等、次の対処法についての指示があるはずです。
